reset Acura RDX 2008 Owner's Manual

When the turbo charger is activated,
this meter shows the boost pressure.
This shows how much f uel you have.
It may show slightly more or less
than the actual amount. The needle
returns to the bottom after you turn
of f the ignition.
CONT INUED
T urbo Boost Meter
Fuel Gauge
Gauges
Inst rument s and Cont rols
71
TURBO BOOST METERMULTI-INFORMATION
DISPLAY
TACHOMETER
SELECT/RESET
KNOB
SPEEDOMETER
FUEL GAUGE
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
\f—\f—\f
y
\f\fy
() 
\fy\f\fy
2008 RDX

Û
Ý
To change the display, press the
SEL/RESET button or INFO ( / )buttononthesteeringwheel
repeatedly until the desired
information appears (see page ).
You can also change the display by
pressing the Select/Reset knob in
the instrument panel. When you turn the ignition switch to
the ON (II) position, what you last
selected is displayed.
In the multi-information display, the
system message is also displayed
(see page ) and you can
customize your vehicle control
settings (see page ).
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from the ON
(II) position to the ACCESSORY (I)
position, a ‘‘Goodbye’’ message is
shownonthedisplay.
7377
80
Multi-Inf ormation Display
72
SEL/RESET
BUTTON
INFO BUTTONS
\f—\f—\f
y
\fy
() 
\fy\f\fy
2008 RDX

ÛÝ
Multi-Inf ormation Display
Inst rument s and Cont rols
73
U.S. model is shown.: Press the INFO( / ) Button
: Press the SEL/
RESET Button IGNITION OFF
IGNITION ON
\f—\f—\f
y
\fy
() 
\fy\f\fy
2008 RDX

The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.
This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.When you reset Trip A, AVG.
FUEL A is reset at the same time.
When you reset Trip B, AVG.
FUEL B is reset.
The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
To reset a trip meter, display it, then
press and hold the SEL/RESET
button until the number resets to
‘‘0.0’’. You can customize the Trip A and
AVG. FUEL A reset condition in the
multi-inf ormation display (see page
).
This shows the outside temperature
in Fahrenheit (U.S. models), or in
Centigrade (Canadian models).
You can adjust the outside
temperature display (see page ).
91
89
Odometer
Trip Meter
Outside Temperature Display
Multi-Inf ormation Display
74
\f—\f—\f
y
\fy
() 
\fy\f\fy
2008 RDX

This shows the estimated distance
you can travel on the fuel remaining
in the f uel tank. This distance is
estimated f rom the f uel economy
you received over the last several
miles(U.S.) or kilometers (Canada),
so it will vary with changes in speed,
traf f ic, etc.
This shows the time passed traveled
since you last reset it. When you turn
the ignition switch to the ON (II)
position, ELAPSED TIME is reset.
You can customize the ELAPSED
TIME reset condition on the multi-
inf ormation display (see page ).This shows your vehicle’s average
f uel economy in mpg (U.S. models)
or liter/100 km (Canadian models)
since you last reset the Trip A or
Trip B.
When you reset Trip A, AVG.
SPEED is also reset.
This shows the average speed you
are traveling in miles per hour (mph)
forU.S.modelsorkilometersper
hour (km/h) f or Canadian models.
When the battery is disconnected, or
you ref uel, RANGE is also reset.
The multi-inf ormation display in the
instrument panel shows you the
engine oil lif e and maintenance
service items when the ignition
switch is in the ON (II) position. This
inf ormation helps to keep you aware
of the periodic maintenance your
vehicle needs f or continued trouble-
f ree driving. Ref er to page f or
more inf ormation.
This shows your current f uel
mileage.
When you turn of f the engine, INST.
MPG or INST. L/100 km is also
reset.
The average f uel mileage will be
reset when you reset the trip meter,
or if the vehicle’s battery goes dead
or is disconnected.
You can customize the Trip A and
AVG. FUEL A reset condition on the
multi-inf ormation display (see page).
327
91
93
RANGE
EL A PSED T IME
AVG. FUEL A/B
A VG. SPEED
Maintenance Minder
INST.MPG(U.S.models)/INST.
L /100km (Canadian models)
Multi-Inf ormation Display
Inst rument s and Cont rols
75
\f—\f—\f
y
\fy
() 
\fy\f\f\fy
2008 RDX

ÛÝÛÝ
With the multi-information display
and the INFO ( / ) and SEL/
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings.
To enter the customizing mode,
press and hold the INFO ( / )
button for more than 3 seconds.
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park. You cannot customize the settings
under these conditions:
If you turn the ignition switch to
the ACCESSORY (I) or the LOCK
(0) position.
If you move the shif t lever out of
Park. If you want the settings as they were
when the vehicle lef t the f actory,
select DEFAULT ALL, as described
on page .
Ref er to the table on the f ollowing
pages about the settings you want to
customize.
The f irst customizing menu is: If you want to change any vehicle
control settings, select CHG
SETTING, then press the SEL/
RESET button (see page ).
DEFAULT ALL
CHG SETTING 83
84
Customized Settings
Multi-Inf ormation Display
80
\f—\f—\f
y

y
() 
\fy\f\fy
2008 RDX

ÎÎÎ
Î Î
Î
Î Î
µ™¶ ™
µ™¶ ™
Î
CONT INUED
Customize Setup
Description
Customize Menu
Customize Entry Customize Group Page
ENGLISH
FRENCH
SPANISH
5°F 0°F 5°F
3°C 0°C 3°C
ON
OFF
IGN RESET
TRIP A RESET
TRIP B RESET
15 sec
30 sec
60 sec
0sec
15 sec
30 sec
60 sec
SHIFT FROM P
WITH VEH SPEED
OFF
Changes the language used in the display.
Changes the outside temperature reading
above or below its current reading.
Causes trip meter A and the average fuel
economy to reset when you refuel.
Resets the elapsed time of your current trip.
Changes how long (in seconds) the interior
lights stay on after you close the doors.
Changes how long (in seconds) the exterior
lights stay on after you close the driver’s
door.
Changes when the system automatically
locks the doors.
LANGUAGE SELECT ION
ADJUST OUTSIDE
TEMP. DISPLAY
TRIP A & AVG. FUEL
RESET with REFUEL
ELAP. TIME RESET
CONDITION
INTERIOR LIGHT
DIMMING T IME
HEADLIGHT AUT O OFF
TIMER
AUTO DOOR LOCK
CHG SETTING
(P.84)
MET ER SET UP
(P.86)
LIGHTING SETUP
(P.95)
DOOR SETUP
(P.100) 87
89
91
93
96
98
101
: Default setting
Multi-Inf ormation Display
Inst rument s and Cont rols
81
 — — 
y

y
() 
 y  y
2008 RDX

ÛÝÛÝ ÛÝ
If you want to set the def ault settings,
press the INFO ( / ) button to
select DEFAULT ALL, then press
the SEL/RESET button.
To enter the customizing mode,
press and hold the INFO ( / )
button for more than 3 seconds. When DEFAULT ALL is set, you will
see the above display for several
seconds, then the screen returns to
CUSTOMIZE ENTRY.
To set the def ault settings, press the
INFO ( / ) button to select SET
then press the SEL/RESET button.
CONT INUED
DEFAUL T AL L
Multi-Inf ormation Display
Inst rument s and Cont rols
83
\f—\f—\f
y
\fy
() 
\fy\f\fy
2008 RDX

Û
Ý
ÛÝ
You can customize some of the
vehicle control settings to your
pref erence. Here are the settings
you can customize:
METER SETUP
LIGHTING SETUP
DOOR SETUP
While CHG SETTING in the
CUSTOMIZE ENTRY is shown in
the multi-information display, press
the SEL/RESET button. The screen
changes to METER SETUP in the
CUSTOMIZE GROUP.
Each time you press the INFO ( / ) button, the screen changes as
shownonthenextpage.Pressthe
INFO ( / ) button, until you see
the setup you want to customize,
then press the SEL/RESET button
to enter your selection.
If DEFAULT ALL is not set, you will
see the above display for several
seconds, then the screen goes back
to CUSTOMIZE ENTRY. Repeat the
procedure to select DEFAULT ALL.
If you want to cancel DEFAULT
ALL, select EXIT, then press the
SEL/RESET button. The screen
goes back to CUSTOMIZE ENTRY.Change Settings
Multi-Inf ormation Display
84
\f—\f—\f
y

y
() 
\fy\f\fy
2008 RDX

ÛÝÛÝ
Multi-Inf ormation Display
Inst rument s and Cont rols
85
: Press and hold theINFO ( / ) button
(3 seconds)
: Press the SEL/RESET button or the Select/
Reset knob
: Press the INFO ( / ) button or rotate the
Select/Reset knob Seepage86
Seepage95
Seepage100
\f—\f—\f
y

y
() 
\fy\f\f\fy
2008 RDX