stop start Acura RL 2004 3.5 Owner's Manual

See page f or important saf etyinf ormation about how to properlyposition the steering wheel. 17
Your Acura’s steering wheel is
electrically-adjustable f or angle and
distance. The adjustment switch is
on the lef t side of the steering
column. Always adjust the steering
wheel bef ore you begin driving.
Make sure the rear window is clear
and you have good visibility bef ore
starting to drive.
The def ogger and antenna wires on
the inside of the rear window can be
accidentally damaged. When
cleaning the glass, always wipe side
to side.
The rear window def ogger will clear
fog,frost,andthinicefromthe
window. Push the def ogger button to
turn it on and of f . The light in the
button lights to show the def ogger is
on. If you do not turn it of f , the
def ogger will shut itself of f af ter
about25minutes.Italsoshutsoff
when you turn of f the ignition. You
have to turn it on again when you
restart the vehicle. Steering Wheel A djustments
Rear Window Def ogger
Controls Near the Steering Wheel
Inst rument s and Cont rols76
Cars without Navigation System
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.

To load a single CD:Press and release the LOAD
button.
The CD Loaded indicator f or an
empty position will start to blink
the green disc indicator will come
on, and LOAD will appear in the
display. Insert the disc into the CD
slot about halfway, the drive will
pull it in the rest of the way.
The system will load the CD, and
begin playing it.
Repeat this until all six positions
are loaded. The system will then
begin playing the last CD loaded. When LOAD appears again in the
display, insert the next disc into
the CD slot. Do no try to insert a
disc until LOAD appears. You
could damage the audio unit.
If you are not loading CDs into all six
positions, press the LOAD button
again after the last CD has loaded.
The system will begin playing the
last CD loaded.
If you stop loading CDs bef ore all six
positions are f illed, and you do not
press the LOAD button, the system
will wait f or ten seconds, then stop
the load operation and begin playing
the last CD loaded.
For best results use only high quality
CD-R discs labeled f or audio use.
TheCDplayercanonlyplayclosed
CD-R recordings. CD-RW discs will
not work in this unit.
Insert the disc into the CD slot
about half way, the drive will pull it
in the rest of the way. The disc
indicator turns red and blinks as
the CD is loaded. On the right side of the display,
the CD Loaded indicator f or an
empty position will begin blinking
and the green disc indicator will
come on. Press and hold the LOAD button
until you hear a beep and see
‘‘LOAD’’ in the display, then
release the button.
To load multiple CDs in one
operation:
1.
2.
3. 4.
5.
1.
2.
3.
Audio System
Comf ort and Convenience Feat ures
L oading CDs in t he Changer
144

CONT INUED
You can also load a CD into an empty
position while a CD is playing by
pressing the appropriate preset
button. Select an empty position (the
CD Loaded indicator is of f ), and
press the preset button f or that
position (1 to 6). The system will
stop playing the current CD and start
the loading sequence. It will then
play the CD just loaded. If you press the LOAD button while
a CD is playing, the system will stop
playing that CD and start the loading
sequence. It will then play the CD
just loaded.
Audio System
Comf ort and Convenience Feat ures145
LOAD BUTTONFM
BUTTONCD SLOT
AM BUTTON TAPE BUTTON
CD LOADED INDICATOR
PRESET BUTTONS

To load a single CD:Press and release the LOAD
button.
The CD Loaded indicator f or an
empty position will start to blink
the green disc indicator will come
on, and LOAD will appear in the
display. Insert the disc into the CD
slot about halfway, the drive will
pull it in the rest of the way.
The system will load the CD, and
begin playing it.
When LOAD appears again in the
display, insert the next disc into
the CD slot. Do no try to insert a
disc until LOAD appears. You
could damage the audio unit.
Repeat this until all six positions
are loaded. The system will then
begin playing the last CD loaded.
If you are not loading CDs into all six
positions, press the LOAD button
again after the last CD has loaded.
The system will begin playing the
last CD loaded.
If you stop loading CDs bef ore all six
positions are f illed, and you do not
press the LOAD button, the system
will wait f or ten seconds, then stop
the load operation and begin playing
the last CD loaded.
Insert the disc into the CD slot
about half way, the drive will pull it
in the rest of the way. The disc
indicator turns red and blinks as
the CD is loaded. On the right side of the display,
the CD Loaded indicator f or an
empty position will begin blinking
and the green disc indicator will
come on. Press and hold the LOAD button
until you hear a beep and see
‘‘LOAD’’ in the display, then
release the button.
To load multiple CDs in one
operation: For best results use only high quality
CD-R discs labeled f or audio use.
TheCDplayercanonlyplayclosed
CD-R recordings. CD-RW discs will
not work in this unit.
1.
2.
3. 4.
5.
1.
2.
3.
CONT INUED
Audio System
Comf ort and Convenience Feat ures
L oading CDs in t he Changer
165

You can also load a CD into an empty
position while a CD is playing by
pressing the appropriate preset
button. Select an empty position (the
CD Loaded indicator is of f ), and
press the preset button f or that
position (1 to 6). The system will
stop playing the current CD and start
the loading sequence. It will then
play the CD just loaded. If you press the LOAD button while
a CD is playing, the system will stop
playing that CD and start the loading
sequence. It will then play the CD
just loaded.
Audio System
Comf ort and Convenience Feat ures166
LOAD BUTTONCD LOADED
INDICATOR
CD SLOT
PRESET BUTTONS AM/FM
BUTTON
CD/TAPE BUTTON

Your Acura’s transmission has f our
f orward speeds, and is electronically
controlled f or smoother shif ting. It
also has a ‘‘lock-up’’ torque converter
forbetterfueleconomy.Youmay
f eel what seems like another shif t
when the converter locks.
This indicator between the f uel
gauge and temperature gauge shows
which position the shif t lever is in.The shift lever has seven positions.
It must be in Park or Neutral to start
the engine. When you are stopped in
D,D,2,1,NorR,pressfirmlyon
the brake pedal, and keep your f oot
of f the accelerator pedal.
The ‘‘D ’’ indicator comes on f or a
f ew seconds when you turn the
ignition switch ON (II). If it f lashes
while driving (in any shif t position),
it indicates a possible problem in the
transmission. Avoid rapid acceler-
ation and have the transmission
checkedbyanauthorizedAcura
dealer as soon as possible.
43
4
Automatic Transmission
Driving
Shif t L ever Position Indicator Shif t L ever Positions
218
SHIFT LEVER

µµ
µ
CONT INUED
Whenever you move the shif t lever,
slide it along the guide on the
console. This position mechani-
cally locks the transmission. Use
Park whenever you are turning of f or
starting the engine. To shif t out of
Park, you must press on the brake
pedal and have your f oot of f the
accelerator pedal. Move the shif t
lever to the right to shif t out of the Park position.
If you have done all of the above and
still cannot move the lever out of
Park, see Shif t Lock Release on page
.
To avoid transmission damage, come
to a complete stop bef ore shif ting
into Park. The shif t lever must be in
Park bef ore you can remove the key
from the ignition switch. To shif t to Reverse
f rom Park, see the explanation under
Park. To shif t to Reverse f rom
Neutral, come to a complete stop and
then shift. Push down on the shift
lever bef ore shif ting into Reverse
from Neutral.
Use Neutral if you
need to restart a stalled engine, or if
it is necessary to stop brief ly with
the engine idling. Shif t to Park posi-
tion if you need to leave the vehicle
f or any reason. Press on the brake pe-
dal when you are moving the shif t
lever from Neutral to another gear.
221
To shift from:
PtoR
NtoR 2to1
1to2
2toD
DtoD DtoN
DtoD Dto2
NtoD RtoNRtoP Do this:
Press the brake pedal.
Push down on the shif t lever.
Move the lever.
3
34 4
43 3 4
Driving
Automatic Transmission
Park (P) Reverse (R)
Neutral (N)
219

µ
µµ
µ
Use this position f or
your normal driving. The transmis-
sion automatically selects a suitable
gear f or your speed and acceleration.
You may notice the transmission
shif ting up at higher speeds when
the engine is cold. This helps the
engine warm up f aster.
This position is similar
to D , except only the first three
gears are selected. Use D when
towing a trailer in hilly terrain, or to
provide engine braking when going
down a steep hill. D can also keep
the transmission f rom cycling
between third and f ourth gears in
stop-and-go driving.
ForfasteraccelerationwheninD or
D , you can get the transmission to
automatically downshif t by pushing
the accelerator pedal to the floor.
The transmission will shif t down one
or two gears, depending on your
speed. This position locks
thetransmissioninsecondgear.It
does not downshif t to f irst gear
when you come to a stop. Second
gives you more power when climbing,
and increased engine braking when
going down steep hills. Use second
gear when starting out on a slippery
surf ace or in deep snow. It will help
reduce wheelspin.
To shif t f rom Second to
First, push down on the shif t lever.
With the lever in this position, the
transmission locks in First gear. By
upshif ting and downshif ting through
1, 2, D and D , you can operate this
transmission much like a manual
transmission without a clutch pedal. If you exceed the maximum speed
f or the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may f eel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
RPM below the red zone.
4
3
3
3
4 34
Driving
Automatic Transmission
Drive (D )
Drive (D )Second (2)
First (1)Engine Speed L imiter4
3
220

such as trying to take a
corner too f ast or making a sudden
lane change. Always drive at a safe,
prudent speed f or the road and
weather conditions.
Always steer moderately
when you are braking hard. Severe
or sharp steering wheel movement
can still cause your car to veer into
oncoming traffic or off the road. The ABS is self -checking. If anything
goes wrong, the ABS indicator on
the instrument panel comes on (see
page ). This means the anti-lockf unction of the braking system has
shut down. The brakes still work like
a conventional system without anti-
lock, providing normal stopping
ability. You should have the dealer
inspect your car as soon as possible
if this light stays on af ter you start
the engine, or comes on while
driving.
it only helps with steering
control during braking. You should
always maintain a saf e f ollowing
distance f rom other vehicles. on loose or
uneven surf aces, such as gravel or
snow, than a vehicle without anti-
lock. Slow down and allow a greater
distance between vehicles under
those conditions.
60
CONT INUED
The Braking System
Driving
Import ant Saf et y Reminders A BS Indicat or
A BS will not prevent a skid that
results f rom changing direction
abruptly,
A BS cannot prevent a loss of
stability. A BS does not reduce the time or
distance it takes to stop the
vehicle;A vehicle with A BS may require a
longer distance to stop
225
ABS INDICATOR

Install the engine cover. First
tighten the two bolts on the front
of the engine cover, then tighten
the three nuts on the engine cover.
Tightening torque:
Install the radiator cap, and
tighten it to the first stop.
Start the engine and let it run until
the radiator cooling f an comes on
at least twice. Then stop the
engine.
Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
Check the level in the radiator,
add coolant if needed. Remove the radiator cap. Pour
coolant into the radiator up to the
base of the f iller neck and into the
reserve tank up to the MAX mark.
Start the engine and hold it at
1,500 rpm until the cooling f an
comes on. Turn of f the engine.
Check the coolant level in the
radiator and add coolant if needed.
12. 11. 13.
14.
15. 16.
17.
CONT INUED
Cooling Syst em
Maint enance261
Fill up to here FILLER NECK
7 lbf·ft (9.8 N·m , 1.0 kgf·m)