change key battery Acura RL 2005 Owner's Manual

If you turn the ignition switch to
ACCESSORY (I) or LOCK (0), or
move the shift lever out of Park, the
display will change to the normal
screen.
To have the driver’s ID detected,
make sure your remote is linked to
the system (seeon page ). Then use your
remote to unlock the doors (see on page ).
When the ignition switch is in the
ON (II) position, the multi-
inf ormation display shows the driver’s
ID.
You cannot customize the setting; When the keyless memory
settings are of f (see page ).
When you disconnect the vehicle
battery, and then do not unlock
the door.
When the multi-information
display does not show the driver’s
ID. 86
88
167CUST OMIZE MENU 15 SEC
0SEC
MAX
HIGH
MID
LOW
MIN
SHIFT FROM P
WITH VEH SPD
OFF
SHIFT TO P
IGN OFF
OFF
DRIVER DOOR
ALL DOORS
ON
OFF
90 SEC
60 SEC
30 SEC
INTERMITTENT
WITH VEH SPDDEFAULT
15 SEC
MID
WITH VEH
SPD
SHIFT TO
P
DRIVER
DOOR
ON
30 SEC
WITH VEH
SPD
See page
92
See page
93
See page
95
See page
96
See page
97
See page
97
See page
98
See page
100
LIGHTING SETUP
DOOR/WINDOW
SETUP
WIPER SETUP
HEADLIGHT AUT O
OFF TIMER
AUTO LIGHT
SENSITIVITY
EXIT
AUTO DOOR LOCK
AUTO DOOR UNLOCK
DOOR LOCK MODE
SECURITY RELOCK
TIMER
EXIT
WIPER ACTION
EXIT
EXITCUST OMIZE SET UP
CUST OMIZE GROUP
KEYLESS LOCK
ACKNOWLEDGMENT
Multi-Inf ormation Display
Memory Position
Link
K eyless A ccess Setup
Inst rument s and Cont rols
79

When you turn the ignition switch to
LOCK (0) and release it, or remove
the built-in key from the ignition
switch, the steering wheel
automatically moves f ully in and up.
The steering wheel returns to its
original position when you push the
ignition switch or insert the built-in
key back in the ignition switch.
Steering wheel movement is also
controlled by the driving position
memory system (see page ).
To change the ‘‘AUTO TILT &
TELESCOPIC’’ setting, see page .If your vehicle’s battery is
disconnected or goes dead, or the
f use f or the power tilt and telescopic
steering wheel is removed, the
power tilt and telescopic steering
wheel system needs to be reset
when you reconnect the battery or
installing the f use.
Push the ignition switch for more
than 1 second and release it, or
insert the built-in key into the
ignition switch, and remove it. The
steering wheel automatically moves
f ully in and up to let you know the
system is reset.
Move the steering wheel to the
highest position and keep that
position by pushing and holding the
adjustment button for more than 1
second. Then, move the steering
wheel to the most inward position,
and keep that position by pushing
and holding the adjustment button
for more than 1 second.
86
124
To reset the system when the auto tilt
and telescopic f eature is turned on, dothis: To reset the system when the auto tilt
and telescopic f eature is turned of f , dothis:
Steering Wheel A djustments
112

The handle of each f ront door has a
sensor. That sensor works with the
remote so you can automatically
unlock/lock the door(s).If you do not open any of the doors
within 30 seconds, they will
automatically relock.
The unlock sensors do not operate
when:
Theremoteisnotwithinthe
operating range.
To change the ‘‘DOOR UNLOCK
MODE’’ setting, see page . If a remote is within operating range
while you wash your vehicle or when
it is raining heavily, the door sensors
may respond by unlocking the doors.
When you unlock the door(s), some
exterior lights blink twice and the
system beeps twice.
To change the ‘‘KEYLESS ACCESS
LIGHT FLASH’’ setting, see page
.
To change the ‘‘KEYLESS ACCESS
BEEP’’ setting, see page . The remote is too close to the
vehicle.
By def ault, only the driver’s door
unlocks when you grab its handle. All the doors unlock when you grab
the handle of the f ront passenger’s
door.
When the doors are unlocked.
The vehicle battery is dead. Theremotebatteryisdead.
If you grab the handle of the f ront
door by the hand with glove, the
door sensor may delay to respond or
not respond by unlocking the doors. 90
89
89
Unlocking the Door(s)
K eyless A ccess System
Inst rument s and Cont rols
129

Each f ront door has a LOCK/
UNLOCK f eature.
When you touch the door lock
sensor of the f ront door by the hand,
all the doors and the trunk will lock.If you touch the door lock sensor of
the f ront door by the hand with glove,
the door sensor may delay to
respond or not respond by locking
the doors.
Theremoteisnotwithinthe
operating range.
The lock sensors do not operate if :
The built-in key is in the ignition
switch. The doors are open.
The ignition switch is not in the
LOCK (0) position.
The remote is too close to the
vehicle.
The vehicle battery is dead. Theremotebatteryisdead.
When you lock the doors, some
exterior lights blink once and the system beeps once. When you
cannot set the security system
because the trunk or hood is open,
no exterior light blinks and/or no
beeper sounds.
Bef ore locking the doors, make sure
theremoteisnotinsidethevehicle. If a remote is within operating range
while you wash your vehicle or when
it is raining heavily, the door sensors
may respond by locking the doors. Within 2 seconds of touching the
handle to lock the doors or locking
the doors with remote, pull the
handletomakesurethedoorsare
actually locked. The door unlock
sensors do not operate f or about 2
seconds af ter the doors are locked. To change the ‘‘KEYLESS ACCESS
BEEP’’ setting, see page . To change the ‘‘KEYLESS ACCESS
LIGHT FLASH’’ setting, see page
.
90
89
L ocking the Doors
K eyless A ccess System
130
DOOR LOCK SENSOR

´
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Replace the batteries if necessary.
Battery type: CR2025
Remove the built-in key.
Remove the upper half by carefully
prying on the edge with a coin. Replace the old batteries with new
batteries. Place the batteries so the
side is f acing up. Snap the two
halvesof theremotecaseback
together.
K eyless A ccess System
Replacing the Remote Battery
Inst rument s and Cont rols
135

............................
Capacities Chart .366
.............
Carbon Monoxide Hazard . 54
....................
Cargo, How to Carry .257
..............
CAUTION, Explanation of . ii
.........................................
CD Care .196
.......................
CD Error Message .197
...................................
CD Changer .187
................................
Ceiling Lights .160
........................
Certif ication Label .364
.................................
Chains, Tires .329
....................
Changing a Flat Tire .337
Changing Oil ........................................
How to .306
......................................
When to .291
...
Charging System Indicator . 60,348
............
Checklist, Bef ore Driving . 262
.....................................
Child Saf ety .36
..............................
Booster Seats .51
...................................
Child Seats .43
Important Saf ety ...............................
Reminders .36
..........................................
Inf ants .41
..........................
Larger Children .50
.........................................
LATCH .45 ......................
Risks with Airbags .37
.............................
Small Children .42
.........................................
Tethers .49
.........
Where Should a Child Sit? . 37
.......................................
Child Seats .42
.........................................
LATCH .45
..........
Tether Anchorage Points . 49
................
Childproof Door Locks . 118
Cleaning ...................................
Seat Belts .321
...............
Climate Control System . 162
........................
CO in the Exhaust .371
............
Cold Weather, Starting in . 263
......................
Compact Spare Tire .336
.................
Console Compartment . 155
.................
Consumer Inf ormation . 378
.............
Controls, Instruments and . 57
Coolant ........................................
Adding .308
....................................
Checking .253
.........................
Proper Solution .308
...................
Temperature Gauge . 68
Crankcase Emissions Control ........................................
System .371
................
Cruise Control Indicator . 64
............
Cruise Control Operation . 201...................................
Cup Holders .154
.............
Customer Service Of f ice . 378
.........................
Customize Settings .78
..................
Door/Window Setup . 94
.........
KEYLESS ACCESS Setup . 88
.............................
Lighting Setup .91
.................................
Meter Setup .82
..............................
Position Setup .85
........................
Setting to Def ault .80
.................................
Wiper Setup .99
................
DANGER, Explanation of . ii
...................................
Dashboard .4, 58
..............
Daytime Running Lights . 106
Daytime Running Lights .......................................
Indicator .64
.................................
Dead Battery .343
............
Def ects, Reporting Saf ety . 380
..............
Def ogger, Rear Window . 110
..............
Def rosting the Windows . 168
..........................
Dif f erential Fluid .366
....................................
Dimensions .366
.............
Dimming the Headlights . 104
Index
D
C
II