buttons Acura RL 2006 Owner's Manual

Î
Î
Your Vehicle at a Glance
4
CLIMATE CONTROL
SYSTEM
AUDIO SYSTEM
POWER DOOR
LOCK MASTER
SWITCH INSTRUMENT PANEL
INDICATORS
ACCESSORY
POWER SOCKETS
HOOD RELEASE LEVER
POWER WINDOW
SWITCHES
DRIVING POSITION
MEMORY SYSTEM
AIRBAGS
MIRROR CONTROL
AUTO BUTTON
AUTOMATIC
TRANSMISSION
TRUNK RELEASE
BUTTON
FUEL FILL DOOR RELEASE
BUTTON
POWER REAR MOONROOF SWITCH
SUNSHADE BUTTON
TILT BUTTON HomeLink BUTTONS
OnStar BUTTONS
REAR HEAD RESTRAINT 1: CEILING CONSOLE
INTERFACE DIAL
(P.61)
(P.156)
(P.148) (P.177)
(P.265)(P.252)
(P.179)
(P.190)
(P.152) (P.149)
(P.297) (P.299)(P.154)
(P.11,26)
(P.194)
(P.203)
(P.195,203,256)
(P.313)
(P.188)
1

Î
Î
ÎÎ
2:
3:
Canadian models only
Ref er to the navigation system manual.
Your Vehicle at a Glance
Your Vehicle at a Glance
5
MIRROR CONTROLS INSTRUMENT
PANEL BRIGHTNESS
STEERING WHEEL
AUDIO CONTROLS HANDSFREELINK
BUTTONS
HORN
ADAPTIVE FRONT LIGHTING
SYSTEM (AFS) OFF SWITCH
VOICE CONTROL
BUTTONSHAZARD WARNING
BUTTON
WINDSHIELD
WIPER/WASHER
VEHICLE STABILITY ASSIST (VSA)
SYSTEM OFF SWITCH COLLISION MITIGATION
BRAKE SYSTEM (CMBS)
OFF SWITCH PASSENGER AIRBAG
OFF INDICATOR
REAR WINDOW
DEFOGGER BUTTON
HEATED MIRROR
BUTTON CRUISE CONTROL
BUTTONS
HEADLIGHTS/
TURN SIGNAL/
FOG LIGHTS PADDLE SHIFTERS
(P.315)
(P.139)
(P.155) STEERING WHEEL
ADJUSTMENTS (P.143) (P.279)
(P.230) DISTANCE BUTTON
(P.246)(P.141)
(P.35)
(P.142) / (P.155 )
(P.234)/
(P.237) ADAPTIVE CRUISE
CONTROL (ACC)
BUTTONS
(P.71)
SEAT HEATER
SWITCHES
SEAT HEATER AND
SEAT VENTILATION
BUTTONS (P.
174 ) /
(P.175)
(P.141)
(P.134)
(P.136)
(P.328) (P.339) MULTI-INFORMATION
BUTTONS
TM
3 2

After all occupants have adjusted
their seats and put on seat belts, it is
very important that they continue to
sit upright, well back in their seats,
with their feet on the floor, until the
vehicle is parked and the engine is
of f .
Sitting improperly can increase the
chance of injury during a crash. For
example, if an occupant slouches,
lies down, turns sideways, sits
forward, leans forward or sideways,
or puts one or both f eet up, the
chance of injury during a crash is
greatly increased.
This could cause
very serious injuries in a crash.
See page f or additional
inf ormation about your seat belts
and how to take care of them. If a seat belt does not seem to work
properly, it may not protect the
occupant in a crash.
The front seats have adjustable seat
belt anchors. To adjust the height of
an anchor, press and hold the release
buttons, and slide the anchor up or
down as needed (it has f our
positions). Using a seat
belt that is not working properly can
result in serious injury or death.
Have your dealer check the belt as
soon as possible.
21 Maintain a Proper Sitting
Position
6.
Never place t he shoulder port ion of a
lap/shoulder belt under your arm orbehind your back.
No one should sit in a seat wit h aninoperat ive seat belt .
Protecting A dults and Teens
18
RELEASE
BUTTON

Î
Î
Control L ocations
60
AUDIO SYSTEM
POWER WINDOW
SWITCHES INSTRUMENT PANEL
INDICATORS
GAUGES
CLIMATE CONTROL
SYSTEM
TRUNK RELEASE BUTTON HOOD RELEASE LEVER
DRIVING POSITION
MEMORY SYSTEM
FUEL FILL DOOR RELEASE
BUTTON
POWER DOOR LOCK
MASTER SWITCH
CEILING CONSOLE
HomeLink BUTTONS
MOONROOF SWITCH
POWER REAR
TILT BUTTON SUNSHADE BUTTON OnStar BUTTONS MIRROR CONTROL
AUTO BUTTON
AUTOMATIC
TRANSMISSION
ACCESSORY POWER
SOCKETS
REAR HEAD RESTRAINT (P.62)
(P.70)
(P.156)
(P.148)
(P.177)
(P.265)(P.252)
(P.179)
(P.190)
(P.152) (P.149)
(P.297) (P.299)(P.154)
(P.194)
(P.203)
(P.313)
(P.188)

ÛÝ
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.You can change the display and
customize your vehicle control
settings by pressing the SEL/RESET
or INFO buttons on the right side of
the steering wheel.With the ignition switch in the ON
(II) position, the lower part of the
multi-inf ormation display changes as
shown in the illustration, each time
you press the SEL/RESET button.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from the ON
(II) position to the ACCESSORY (I)
position, a ‘‘Goodbye’’ message is
shownonthedisplay.
Multi-Inf ormation Display
Inst rument s and Cont rols
71
SEL
RESET
BUTTON
U.S.
CANADA
INFO ( / )
BUTTONS

ÛÝÛÝ
With the multi-information display
and the INFO ( / ) and SEL/
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings f or ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’. If ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’ is not displayed,
customizing is not possible.
To have the driver’s ID detected,
make sure your remote is linked to
the system (see
on page ). Then use your
remote to unlock the doors (see on page
). To enter the customizing mode,
press and hold the INFO ( / )
button for more than 3 seconds while
the multi-information display is in its
normal mode.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shif t lever out
of Park, the display will change to
the normal screen.
When the multi-information
display does not show the driver’s
ID. The f irst customizing menu is:
CHG SETTING (see page )
If you disconnect the battery, and
then do not unlock the door. When the keyless memory
settings are of f (see page ). DEFAULT ALL (see page )
You cannot customize the settings
under these conditions:
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park. 82
84
166
100
105
CONT INUED
Customized Settings
Memory Position
Link
K eyless A ccess Setup
Multi-Inf ormation Display
Inst rument s and Cont rols
81

Î
Î
ÎÎ
Canadian models only
1:
2 : Ref er to the navigation system manual.
Your Vehicle at a Glance
Inst rument s and Cont rols
133
MIRROR CONTROLS PASSENGER AIRBAG
OFF INDICATOR
HANDSFREELINK
BUTTONS HORN
HEADLIGHTS/
TURN SIGNAL/FOG
LIGHTS
VEHICLE STABILITY ASSIST (VSA)
SYSTEM OFF SWITCH
ADAPTIVE FRONT LIGHTING
SYSTEM (AFS) OFF SWITCH PADDLE SHIFTERS
VOICE CONTROL
BUTTONSREAR WINDOW
DEFOGGER BUTTON
HEATED MIRROR
BUTTON HAZARD WARNING
BUTTON
COLLISION MITIGATION
BRAKE SYSTEM (CMBS)
OFF SWITCH
DISTANCE BUTTONCRUISE CONTROL
BUTTONS
SEAT HEATER SWITCHES
SEAT HEATER AND
SEAT VENTILATION BUTTONS
MULTI INFORMATION BUTTONS
(P.315)
(P.339) (P.325)
(P.139)
(P.154) (P.143)STEERING WHEEL
AUDIO CONTROLS
(P.230)
STEERING WHEEL
ADJUSTMENTS (P.278)
(P.246)
(P.175)
(P.174) /
(P.71)
(P.237)(P.234)/
(P.155)
(P.142) / (P.35)
(P.141)
ADAPTIVE CRUISE
CONTROL (ACC)
BUTTONS
(P.136)
INSTRUMENT
PANEL BRIGHTNESS
WINDSHIELD
WIPER/WASHER
(P.134)
(P.141)
TM
2 1

The inside mirror can automatically
darken to reduce glare. To turn on
this feature, press the button on the
bottom of the mirror. The AUTO
indicator comes on as a reminder.
When it is on, the mirror darkens
when it senses the headlights of a
vehicle behind you, then returns to
normal visibility when the lights are
gone. Press the button again to turn
of f this sensing.
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
Mirrors
154
INDICATOR
AUTO BUTTONSENSOR

Store a driving position only when
the vehicle is parked.Adjust the steering wheel to a
comf ortable position (see page ).
Adjust the outside mirrors f or best
visibility (see page ). Adjust the seat to a comfortable
position (see page ).
Your vehicle has a memory feature
f or the steering wheel, driver’s seat,
and outside mirror positions.
Two seat, steering wheel, and
outside mirror positions can be
stored in separate memories. You
select a memorized position by
pushing the appropriate button.
Press the MEMO button on the
driver’s door. You will hear a beep.
The indicator in the memory
buttons (1 and 2) will blink.
Immediately press one of the
memory buttons (1 or 2) until you
hear two beeps. The indicator in
the memory button will stay on.
The current positions of the
driver’s seat, steering wheel, and
outside mirrors are now stored.
Turn the ignition switch to the ON
(II) position. You cannot add a
new driving position in the
memory unless the ignition switch
is the ON (II) position. You can
recall a memorized position with
the ignition switch in any position.
3.
1.
2.
111 151
155
Storing a Driving Position in
Memory
Driving Position Memory System
156
MEMORY
BUTTONS
MEMO BUTTON

To select a memorized position, do
this:Press the desired memory button
(1 or 2) until you hear a beep.
The system will move the seat,
steering wheel, and outside mirrors
to the memorized positions. The
indicator in the selected memory
button will f lash during movement.
When the adjustments are complete,
you will hear two beeps, and the
indicator will remain on.
Make sure the shif t lever is in
Park. To change the ‘‘MEMORY
POSITION LINK’’ setting, see page
.
To cancel the storing procedure
after pressing the MEMO button:
Do not press a memory button
within 5 seconds.
Readjust the outside mirror
position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory.
All stored driving positions will be
lost if your vehicle’s battery goes
dead or is disconnected. Readjust the seat or steering
position.
1. 2.
101
CONT INUED
Selecting a Memorized Position
Driving Position Memory System
Inst rument s and Cont rols
157
MEMORY BUTTONS