recommended oil Acura RL 2006 Owner's Manual

Install the engine oil f ill cap, and
tighten it securely. Wait a f ew
minutes, and recheck the oil level.
Do not f ill above the upper mark; you
could damage the engine.Oil is major contributor to your
engine’s perf ormance and longevity.
Always use a premium-grade
detergent oil displaying the API
Certif ication Seal. This seal indicates
the oil is energy conserving and that
it meets the American Petroleum
Institute’s latest requirements.
Unscrew and remove the engine oil
fill cap on top of the valve cover.
Pour in the oil slowly and caref ully so
you do not spill any. Clean up any
spills immediately. Spilled oil could
damage components in the engine
compartment. Honda Motor Oil is the pref erred
5W-20 lubricant f or your vehicle. It is
highly recommended that you use
Honda Motor Oil in your vehicle f or
optimum engine protection. Make
sure the API Certif ication Seal says
‘‘For Gasoline Engines.’’
The oil viscosity or weight is
provided on the container’s label.
5W-20 oil is f ormulated f or year-
round protection of your vehicle to
improve cold weather starting and
f uel economy.
CONT INUED
Recommended Engine Oil
A dding Engine Oil
Maint enance
363
API CERTIFICATION SEAL
ENGINE OIL FILL CAP
Ambient Temperature

Remove the oil f ilter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.Refill the engine with the
recommended oil.
Engine oil change capacity
(including f ilter):
Replace the engine oil f ill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn of f the
engine, and check your work.
Let the engine run f or several
minutes, then check the drain bolt
and oil f ilter f or leaks.
Turn of f the engine and let it sit
f or several minutes, then check
the oil level on the dipstick. If
necessary, add more oil. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Check the oil f ilter to make sure
its gasket did not stick to the
engine block. A stuck gasket could
cause an oil leak.
Install a new oil f ilter according to
the instructions that come with it.
3.
4.
5. 6.
7.
8.
9.
10.
Changing the Oil and Filter
Maint enance
365
OIL FILTER
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.5 US qt (4.3
) Improper disposal of engine oil can be
harmf ul to the environment. If you
change your own oil, please dispose of
the used oil properly. Put it in a sealed
container, and take it to a recycling
center. Do not discard it in a trash bin
or dump it on the ground.

Service Inf ormation Summary
Gasoline:
Fuel Tank Capacity:
Recommended Engine Oil:
Automatic Transmission Fluid:Rear Differential Fluid:
Brake Fluid:
Power Steering Fluid: Transfer Assembly Fluid: Tire Pressure (measured cold):
SpareTirePressure:
4.5US qt (4.3
)
Oil change capacity (including
filter): Premium unleaded gasoline,
pump octane number of91or
higher.
API Premium grade5W-20
detergent oil (see page ).
SAE90or SAE80W-90viscosity
hypoid gear oil, API service
classified GL4or GL5only.SH-AWD clutch case
Capacity:
SH-AWD differential case0.77US qt (0.73
)
Honda ATF-Z1(Automatic
Transmission Fluid) preferred, or
aDEXRON
III ATF as a
temporary replacement.
Honda Power Steering Fluid
preferred, or another brand of
power steering fluid as a
temporary replacement. Do not
use ATF (see page ). Honda Heavy Duty Brake Fluid
DOT3preferred, or a DOT3or
DOT4brake fluid as a temporary
replacement (see page ).
Front:
32psi (220kPa ,2.2kgf/cm
)
Rear:
30psi (210kPa ,2.1kgf/cm
)
60psi (420kPa ,4.2kgf/cm
)
Honda ATF-Z1(Automatic
Transmission Fluid) preferred, or
aDEXRON
III ATF as a
temporary replacement (see page ).
19.4US gal (73
)
2.8US qt (2.7
)
363
370 369
368