Tire Acura RL 2010 Workshop Manual

Bef ore mounting the spare tire,
wipeanydirtoff themounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully;itmaybehotfrom
driving.Put on the spare tire. Put the
wheel nuts back on f inger-tight,
then tighten them in a crisscross
pattern with the wheel nut wrench
until the wheel is f irmly against
the hub. Do not try to tighten the
wheel nuts f ully.Lower the vehicle to the ground,
and remove the jack.
10.
11.12.
CONT INUED
Changing a Flat Tire
T aking Care of t he Unexpect ed
491
BRAKE HUB
——y

y
(yy
2010 RL

Store the jack and tools in the tool
case. Place the tool case in the f lat
tire.
Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to: Place the flat tire face down in the
spare tire well.
Wrap the spacer cone and spare
tire wing bolt with cloth or paper,
and store them in the spare tire
well.Lower the trunk f loor, then close
the trunk lid.
Your vehicle’s original tire has a
tire pressure monitoring system
sensor. To replace a tire, ref er to
(see
page ).
14.
13.
15.16.
17.
18. 424
Changing a Flat Tire
Changing a T ire with T PMS
492
WING BOLTSPACER CONE
94 lbf·ft (127 N·m , 13 kgf·m)
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
——y
y
(yy
2010 RL

No.
No.No.
Circuits Protected
Circuits Protected Circuits Protected
Amps.
Amps. Amps.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2 17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
ACG
Fuel Pump
IGN SOL
Meter
SRS
IGP (PGM-FI ECU)
Left rear power window
ETS (telescopic)
ETS (tilt)
Driver’s power window
Moonroof
Adaptive Front Lighting
System
Air Conditioner
e-pretensioner
ACC
Option
Starter diag.
Starter signal DrivebyWire
Ignition coil
Daytime running light
LAF heater
Radio
Interior light
Back-up
Door lock
Accessory socket
Occupant position detection
system
Wiper
Rear heated seat
Driver’s power seat sliding
Driver’s power seat reclining
15 A
15 A
10 A
15 A
7.5 A
7.5 A 10 A
20 A
20 A
7.5 A
15 A
15 A
20 A
20 A
7.5 A 20 A
7.5 A
7.5 A 20 A
15 A
20 A
15 A
10 A
10 A
7.5 A 20 A
20 A
20 A
30 A
20 A
7.5 A
7.5 A
7.5 A 10 A
(7.5 A)Passenger’s power seat sliding
Passenger’s power seat reclining
Tire pressure monitoring system
Fuse Locations
T aking Care of t he Unexpect ed
511
INTERIOR FUSE BOX
Driver’s side
SECONDARY INTERIOR FUSE BOX
Driver’s side
——y
y
(y
y
2010 RL

To use the towing hook:Remove the cover f rom the f ront
bumper by pushing the right
corner edge of the cover with a
f inger until the cover comes out as
shown in the illustration.
The operator will load
your vehicle on the back of a truck.
Any other method of towing will
damage the drive system. When you
contact the towing agency, inf orm
them a f lat-bed is required. If your vehicle needs to be towed,
call a prof essional towing service or
organization. Never tow your vehicle
with just a rope or chain. It is very
dangerous. If your vehicle gets stuck in sand,
mud, or snow, call a towing service
to pull it out (see the previous
column).
For very short distances, such as
f reeing the vehicle, you can use the
detachable towing hook that mounts
on the anchor in the f ront bumper.
1.
CONT INUED
The only way you can saf ely tow
your vehicle is with f lat-bed
equipment. Emergency T owing If Your Vehicle Gets Stuck
Emergency Towing, If Your Vehicle Gets Stuck
T aking Care of t he Unexpect ed
513
COVER
Towing with only two tires on the
ground will damage parts of the
all-wheel-drive system. Your vehicle
should be transported on a f lat-bed
truck or trailer.
——y
y
(y
y
2010 RL

Screw the towing hook into the
hole, and tighten it with the wheel
nut wrench. Remove the towing hook and
wheel nut wrench f rom the tool
case in the spare tire.
The cover is attached to the bumper
with a tether.
2.
3.
If Your Vehicle Gets Stuck
514
WHEEL NUT WRENCH
COVER
TETHER
To avoid damage to your vehicle, use
the towing hook f or straight, f lat
ground towing only. Do not tow at an
angle. The tow hook should not be used
to tow the vehicle onto a f lat bed. Do
not use it as a tie down.
——y
y
(y
y
2010 RL

µ
Thediagramsinthissectiongive
you the dimensions and capacities of
your vehicle, and the location of
identif ication numbers. It also
includes inf ormation you should
know about your vehicle’s tires and
emissions control systems.
................
Identif ication Numbers . 516
................................
Specif ications .518
DOT Tire Quality Grading ......................
(U.S. Vehicles) .520
.................................
Treadwear .520
......................................
Traction .520
.............................
Temperature .521
.................................
Tire Labeling .522
Tire Pressure Monitoring System (TPMS) Required Federal ............................
Explanation .524 .......................
Emissions Controls .526
.....................
The Clean Air Act .526
Crankcase Emissions Control ....................................
System .526
Evaporative Emissions Control ....................................
System .526
Onboard Ref ueling Vapor ................................
Recovery .526
...
Exhaust Emissions Controls . 527
....................
PGM-FI System .527
Ignition Timing Control ................................
System .527
Exhaust Gas Recirculation ...................
(EGR) System . 527
Three Way Catalytic ...........................
Converter .527
....................
Replacement Parts . 527
Three Way Catalytic .................................
Converters .528
........................
Emissions Testing .529
T echnical Inf ormation
Technical Inf ormation
515
——y
y
(yy
2010 RL

µ
µ
µ
µ
Î µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
Specif ications
Technical Inf ormation
519
Engine
Alignment
Tires
Battery
Fuses Lights 12 V
12 V60 W
24/2.2CP
3.54x3.78in(90x96mm)
223.5 cu-in (3,664 cm
)
11.2 : 1
ILZKR7B-11S
SXU22HCR11S
SOHC VTEC V-6 gasoline engine
Type
BorexStroke
Displacement
Compression ratio
Spark plugs
0.00 in (0.0 mm)
0.08 in (2.0 mm)0°8’
1°15’
2°10’
P245/45R18 96V
Toe-in
Camber
Caster
Size
Pressure
T155/70D17 110M
32 psi (220 kPa , 2.2 kgf/cm
)
30 psi (210 kPa , 2.1 kgf/cm)
60 psi (420 kPa , 4.2 kgf/cm)
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
1.5 CP
Capacity 12 V 55 AH/5 HR
72 AH/20 HR
12 V
Interior
Under-hood Low beam headlight bulbs are a type of high voltage discharge
tube (D2S). 21 W
21 W
35 W
5W
8W
8W
2W
2CP
5W
Headlights (High Beam)
Front turn signal
Front side marker/Parking lights
Rear turn signal lights
Back-up light
Fog lights
License plate lights
Ceiling lights
Vanity mirror lights
Door courtesy lights
Trunk lights
12 V 5 W
See page 511and 512or the fuse
label attached to the inside of
each fuse box cover.
See page 510or the fuse box
cover. Front
Rear
Front
Rear
Front
NGK:
DENSO:
(HB3)
: Front/Rear
Spare
Front
Rear
Spare
(Amber)
(H8)
Front
Rear
inside trunk
trunk lid (Amber)
——y
y
(yy
2010 RL

The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades. Quality grades can be f ound where
applicable on the tire sidewall
between tread shoulder and
maximum section width. For
example:The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices and dif f erences in
road characteristics and climate.The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
DOT Tire Quality Grading (U.S. Vehicles)
T readwear 200
Traction AA
Temperature A
Unif orm T ire Quality Grading T readwear
T raction
520
——y
y
(yy
2010 RL

The temperature grades are A (the
highest), B, and C, representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled
conditions on a specif ied indoor
laboratory test wheel. Sustained high
temperature can cause the material
of the tire to degenerate and reduce
tire life, and excessive temperature
can lead to sudden tire f ailure. The
grade C corresponds to a level of
perf ormance which all passenger car
tires must meet under the Federal
Motor Vehicle Saf ety Standard No.
109. Grades B and A represent
higher levels of perf ormance on the
laboratory test wheel than the
minimum required by law.Warning: The temperature grade f or
this tire is established f or a tire that
is properly inf lated and not
overloaded. Excessive speed,
underinf lation, or excessive loading,
either separately or in combination,
can cause heat buildup and possible
tire f ailure.
DOT Tire Quality Grading (U.S. Vehicles)
Temperature
Technical Inf ormation
521
——y
y
(yy
2010 RL

µ
µ
µ
µ
µ
µ
µ µ
µ
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
Load index (a numerical code
associated with the maximum
load the tire can carry).
Speed symbol (an
alphabetical code indicating
the maximum speed rating).
The tire identif ication number (TIN)
is a group of numbers and letters
that look like the f ollowing example.
TIN is located on the sidewall of the
tire.
Whenever tires are replaced, they
should be replaced with tires of the
same size. Following is an example
of tire size with an explanation of
what each component means.
Vehicletype(Pindicates
passenger vehicle).
Tire width in millimeters.
Aspect ratio (the tire’s section
height as a percentage of its
width).
Tire construction code (R
indicates radial).
Rim diameter in inches. This indicates that the
tire meets all
requirements of the U.S.
Department of
Transportation.
Manuf acturer’s
identification mark.
P
R
V
DOT
245
B97R
45
18 96
Tire Labeling
T ire Ident if icat ion Number (T IN)
Tire Size
522
TIRE LABELING EXAMPLE
(1)
(1)
(3)(4)
(1)
(2)
(3)
(4) Maximum Tire Load (2)
Tire Size
Tire Identification Number (TIN)
Maximum Tire Pressure
DOT B97R FW6X 2202
P245/45R18 96V
——y
y
(yy
2010 RL