ECO mode ACURA RL 2012 User Guide

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
When you push the ACC button on
the steering wheel, this indicator
comes on green. You will also see
‘‘ACC’’ on the multi-inf ormation
display.
If the indicator comes on amber,
there is a problem with the ACC
system. You will also see a ‘‘CHECK
ACC SYSTEM’’ message on the
multi-inf ormation display (see page
). Take your vehicle to your
dealer to have it checked. For more
inf ormation, see page .This indicator is in the f uel gauge. It
comesonasareminderthatyou
must ref uel soon. You will also see a
‘‘FUEL LOW’’ message on the multi-
inf ormation display. When the
indicator comes on, there are about
2.69 U.S. gal (10.2
)of fuel
remaininginthetank.Whenthe
needle reaches E, there is a very
small amount of fuel in the tank.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If this indicator comes on at
any other time, there is a problem in
the SH-AWD system. You will also
see a ‘‘CHECK SH-AWD SYSTEM’’
message on the multi-inf ormation
display. Take your vehicle to a dealer
to have it checked. For more
inf ormation, see page .
If the indicator blinks while driving,
the dif f erential temperature is too
high.
You will also see an ‘‘SH-AWD DIFF
TEMP. HIGH’’ message on the
multi-inf ormation display (see page
).
319 332413412
On models with adaptive cruise control
(ACC)
Instrument Panel Indicators
A daptive Cruise Control
(A CC) IndicatorL ow Fuel Indicator Super Handling-A ll
Wheel Drive (SH-AWD)
Indicator
66
LOW FUEL INDICATOR
11/07/20 18:08:31 31SJA670_071
ProCarManuals.com

The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial/
territorial regulations to disconnect,
reset, or alter the odometer with the
intent to change the number of miles
or kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, then
press and hold the SEL/RESET
button until the number resets to
‘‘0.0’’.When you reset Trip A, average f uel
economy A is reset at the same time.
When you reset Trip B, average f uel
economy B is reset.
In the customizing mode, you can set
Trip A, average f uel economy A, and
average speed to reset at the same
time when you ref uel your vehicle
(see page ).99
Multi-Inf ormation Display
Odometer T rip Meter
72
ODOMETER
TRIP METER
11/07/20 18:09:20 31SJA670_077
ProCarManuals.com

When you turn of f the engine, INST.
MPG or INST. L/100 km is also
reset. This shows your instant f uel
economy. Along with the trip meter, the trip
computer calculates these values:
Instantaneous Fuel Economy
Range
Elapsed Time
Average Fuel Economy Average Vehicle Speed
This shows the estimated distance
you can travel on the fuel remaining
in the f uel tank. This distance is
estimated f rom the f uel economy
you received over the last several
miles (U.S.) or kilometers (Canada),so it will vary with changes in speed,
traf f ic, etc.
When the battery is disconnected, or
you ref uel, RANGE is also reset.
This shows the accumulated
traveling time since you last reset it.
When you turn the ignition switch to
the ON (II) position, ELAPSED
TIME is reset.
You can customize the ELAPSED
TIME reset conditions on the multi-
inf ormation display (see page ).
This shows the average speed you
are traveling in miles per hour (mph)
f or U.S. models or kilometers per
hour (km/h) f or Canadian models.
When you reset Trip A, average
speed is also reset.You can customize the average
speed reset condition on the multi-
inf ormation display (see page ).
This shows your vehicle’s average
f uel economy in mpg (U.S. models)
or liter/100 km (Canadian models)
since you last reset Trip A or Trip B.
The average f uel economy will be
reset when you reset the trip meter,
or if the vehicle’s battery goes dead
or is disconnected.
You can customize the average fuel
A reset condition on the multi-
inf ormation display (see page ). 10199
99
Multi-Inf ormation Display
INST.MPG(U.S.models)/INST.
L /100km (Canadian models) Trip Computer
RANGEEL A PSED T IME
A VERA GE SPEEDAVERAGE FUEL A/B
Inst rument s and Cont rols
75
11/07/20 18:09:50 31SJA670_080
ProCarManuals.com

ÛÝÛÝ With the multi-information display
and the INFO ( / ) and SEL/
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings f or ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’. If ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’ is not displayed,
customizing is not possible.
To have the driver’s ID detected,
make sure your remote is linked to
the system (see
on page ). Then use your
remote to unlock the doors (see
on page
).To enter the customizing mode,
press and hold the INFO ( / )
button for more than 3 seconds while
the multi-information display is in its
normal mode.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shif t lever out
of Park, the display will change to
the normal screen.
When the multi-information
display does not show the driver’s
ID.The f irst customizing menu is:
CHG SETTING (see page )
If you disconnect the battery, and
then do not unlock the door.DEFAULT ALL (see page ) You cannot customize the settings
under these conditions:
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park.Ref er to the f ollowing table f or a
brief summary of each customizable
setting and its default. For more
inf ormation, ref er to the page
number ref erences in the table. When the driving memory settings
are of f (see page ). 104
10887
85 174
CONT INUED
Customized Settings
Memory Position
Link
K eyless A ccess Setup
Multi-Inf ormation Display
Inst rument s and Cont rols
81
DRIVER’S ID
11/07/20 18:10:51 31SJA670_086
ProCarManuals.com

Î
Î
Î
Î
Î
Î
Î
Î
Î
Î
µ™¶ ™
µ™¶ ™
Î
Î
ÎCUSTOMIZE ENTRY
CHG SETTING
(see page 87)CUST OMIZE GROUP
ACC SETUP
(see page 89)
MET ER SET UP
(see page 94)
POSITION SETUP
(see page 103)CUST OMIZE SET UP
ON
OFF
mph
km/h
ENGLISH
FRENCH
SPANISH
5°F 0°F 5°F
3°C 0°C 3°C
ON
OFF
IGN OFF
TRIP A
TRIP B
ON
OFF
ON
OFFPage
90
92
95
97
99
101
104
106 CUST OMIZE MENU
PRE-RUNNING CAR
DET ECT BEEP
ACC DISPLAY SPEED
UNIT
LANGUAGE
SELECTION
ADJUST OUTSIDE
TEMP. DISPLAY
TRIP A RESET with
REFUEL
ELAPSED TIME
RESET
MEMORY POSIT ION
LINK
AUTO TILT &
TELESCOPICDescription
Causes the system to beep when a vehicle
ahead of you gets too close.
Changes the ACC display speed unit.
Changes the language used in the display.
Changes the outside temperature reading
above or below its current reading.
Causes trip meter A, the average fuel
economy, and the average speed to reset
when you refuel.
Resets the elapsed time of your current
trip.
Changes the driver’s seat, the steering
wheel, and the outside mirror positions to
your stored setting.
Moves the steering wheel fully in and out
when you get in/out of the vehicle.
1:
2:
3:Def ault setting
Default setting for U.S. models
Default setting for Canadian modelprevious
setting
1
2
3
1
2
3
1
1
1
1
Multi-Inf ormation Display
82
11/07/20 18:10:57 31SJA670_087
ProCarManuals.com

Î
Î
Î
Î
Î
Î
Î
Î
CONT INUED
CUSTOMIZE ENTRY
CHG SETTING
(see page 87)CUST OMIZE SET UP
DRIVER DOOR
ONLY
ALL DOORS
ON
OFF
ON
OFF
60 SEC
30 SEC
15 SEC
60 SEC
30 SEC
15 SEC
MAX
HIGH
MID
LOW
SHIFT FROM P
WITH VEH SPD
OFF CUST OMIZE GROUP
KEYLESS ACCESS
SETUP
(see page 108)
LIGHTING SETUP
(see page 115)
DOOR/WINDOW
SETUP
(see page 122)Page
109
111
113
116
118
120
123 CUST OMIZE MENU
DOOR UNLOCK
MODE
KEYLESS ACCESS
LIGHT FLASH
KEYLESS ACCESS
BEEP
INTERIOR LIGHT
DIMMING T IME
HEADLIGHT AUT O
OFF TIMER
AUTO LIGHT
SENSITIVITY
AUTO DOOR LOCKDescription
Changes which doors unlock when you use
the remote or grab the driver’s door handle.
Causes some exterior lights to blink when
you lock/unlock the doors.
Cause the beeper to sound when you lock/
unlock the doors.
Changes how long (in seconds) the interior
lights stay on af ter you close the doors.
Changes how long (in seconds) the exterior
lights stay on after you close the driver’s
door.
Changes the timing of when the headlights
to come on. The headlight switch needs to
be in the AUTO position.
Changes when the doors automatically lock.
: Default setting0SEC
MIN
Multi-Inf ormation Display
Inst rument s and Cont rols
83
11/07/20 18:11:04 31SJA670_088
ProCarManuals.com

Î
Î
Î
Î
Î
ÎCUST OMIZE MENU
AUTO DOOR
UNLOCK
DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGMENT
SECURITY RELOCK
TIMER
WIPER ACTION CUST OMIZE GROUP
DOOR/WINDOW
SETUP
(see page 122)
WIPER SETUP
(see page 133)CUST OMIZE SET UP
SHIFT TO P
IGN OFF
OFF
DRIVER DOOR
ALL DOORS
ON
OFF
90 SEC
60 SEC
30 SEC
INTERMITTENT
WITH VEH SPD
SET
CANCEL CUSTOMIZE ENTRY
CHG SETTING
(see page 87)
DEFAULT ALL
(see page 85)Description
Changes when the doors automatically
unlock.
Changes which doors unlock with the f irst
push of the remote’s unlock button.
The exterior lights f lash each time you
press the LOCK or UNLOCK button.
Changes how long it takes (in seconds) f or
the doors to relock and the security system
to set after you unlock the driver’s door
without opening it.
Changes the wiper operation among two
settings when the wiper switch is in the INT
position.
Changes all settings to the default.Page
125
127
129
131
134
85
: Default setting
Multi-Inf ormation Display
84
11/07/20 18:11:10 31SJA670_089
ProCarManuals.com

To set the def ault settings again,
select DEFAULT ALL, and press the
SEL/RESET button. Then select
SET, and press the SEL/RESET
button.When DEFAULT ALL is set, you will
see the above display for several
seconds, then the screen returns to
CUSTOMIZE ENTRY.If DEFAULT ALL is not set, you will
see the above display for several
seconds, then the screen goes back
to the normal message mode. Repeat
the procedure to select DEFAULT
ALL.
Multi-Inf ormation Display
86
11/07/20 18:11:23 31SJA670_091
ProCarManuals.com

ÛÝ To exit DOOR UNLOCK MODE
without changing the current setting,
select EXIT by pressing the INFO
( / ) button, then press the SEL/
RESET button. The screen goes
back to CUSTOMIZE MENU. When your choice is set, you will see
the above display f or several seconds,
then the screen goes back to
CUSTOMIZE ENTRY.If your choice is not set, you will see
the above display f or several seconds,
then the screen goes back to
CUSTOMIZE SETUP. If this
happens, you need to repeat the door
unlock mode setup.
Multi-Inf ormation Display
110
11/07/20 18:14:03 31SJA670_115
ProCarManuals.com

ÛÝ When your choice is set, you will see
the above display f or several seconds,
then the screen goes back to
CUSTOMIZE ENTRY.To exit DOOR LOCK MODE
without changing the current setting,
select EXIT by pressing the INFO
( / ) button, and then press the
SEL/RESET button. The screen
goes back to CUSTOMIZE MENU. If your choice is not set, you will see
the above display f or several seconds,
then the screen goes back to
CUSTOMIZE SETUP. If this
happens, you need to repeat the door
lock mode setup.
Multi-Inf ormation Display
128
11/07/20 18:16:01 31SJA670_133
ProCarManuals.com