sensor ACURA RL 2012 Owner's Guide

The system may not sense thin or
low objects, or sonic-absorptive
materials such as snow, cotton, or
sponge.
The system cannot sense objects
directly under the bumper.
If a beeper sounds several times or
does not sound when you put the
transmission into reverse, there is a
problem with the backup sensor
system. You should have the system
checked by your dealer.Canadian Owners:
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the f ollowing two
conditions: (1) this device may not cause
interf erence, and (2) this device must
accept any interf erence that may cause
undesired operation of the device.
This ISM device complies with Canadian
ICES-001.
Backup Sensor System
Features
379
11/07/20 18:50:14 31SJA670_384
ProCarManuals.com

Store or secure all items that could
be thrown around and hurt
someone during a crash.
Do not put any items on top of the
rear shelf . They can block your
view and be thrown around the
vehicle during a crash.
Be sure items placed on the f loor
behind the f ront seats cannot roll
underneath and interf ere with the
proper operation of the seats, the
sensors under the seats, or the
driver’s ability to operate the
pedals.Distribute cargo evenly on the
f loor of the trunk, placing the
heaviest items on the bottom and
as far forward as possible.
If you carry large items that
prevent you f rom closing the trunk
lid, exhaust gas can enter the
passenger area. To avoid the
possibility of
, f ollow the instructions
on page .
If you carry any items on a roof
rack,besurethetotalweightof
the rack and the items does not
exceed 121 lbs (55 kg).
If you use an accessory roof rack,
the roof rack weight limit may be
lower. Ref er to the inf ormation
that came with your roof rack. Keep the glove box closed while
driving. If it is open, a passenger
could injure their knees during a
crash or sudden stop.
Keep all cargo below the bottom
of the windows. If it is higher, it
could interf ere with the proper
operation of the side curtain
airbags.56 Carrying Items in the Passenger
CompartmentCarrying Cargo in the T runk or on
a Roof Rack
carbon monoxide
poisoning
Carrying Cargo
396
11/07/20 18:52:31 31SJA670_401
ProCarManuals.com

µ
If equipped
The collision mitigation braking
system (CMBS ) can assist the
driver when there is a possibility of
colliding with the vehicle in f ront of
yours. It is designed to reduce the
speed of your vehicle bef ore an
unavoidable collision occurs and, if
possible, to alert you to a potential
collision while there is time f or the
driver to prevent it. Here is a brief
description of what the CMBS can
do:When your speed is above 10 mph
(15 km/h), the CMBS is monitoring
the vehicle ahead of you with radar.
When your vehicle is approaching
the vehicle ahead of yours too
quickly, the system may activate one
or more of the f ollowing: a visual
alert, an audible alert, apply the
brakes and e-pretensioners to
tighten the front seat belts first as
a warning, then to prepare for an
impending crash (see page ).
The CMBS consists of a radar
sensor in the f ront grille, a brake
actuator in the engine compartment,
an indicator on the instrument panel,
seat belt e-pretensioners on the f ront
seats,andanon/off buttononthe
dashboard. 24
Collision Mitigation Braking System (CMBS )
Overview
418
RADAR SENSOR
BRAKE
ACTUATORSEAT BELT
e-PRETENSIONERS
TM TM
TM TM
11/07/20 18:55:10 31SJA670_423
ProCarManuals.com

The radar sensor is located under
the Acura emblem in the f ront grille.
If the radar sensor cover is covered
with mud, dirt, dead leaves, wet
snow, etc., or if you put a sticker on
it, the CMBS will automatically shut
of f , and the CMBS indicator on the
instrument panel will come on. You
will also see a ‘‘CHECK CMBS
RADAR SENSOR’’ message on the
multi-inf ormation display f or about 5
seconds.There are three bolts on the sides of
the radar sensor. Do not tamper with
these bolts, or you may cause the
system to malf unction. Always keep the radar sensor cover
clean. If it gets dirty, clean it with
water or a mild detergent. Never use
chemical solvents or polishing
powder.
CONT INUED
Radar Sensor
Collision Mitigation Braking System (CMBS )
Driving
419
RADAR SENSOR COVERBOLTS
(Do not tamper)
TM TM
11/07/20 18:55:16 31SJA670_424
ProCarManuals.com

Certain conditions may cause the
radar aim to be temporarily out of
proper range, such as the f ollowing
two examples:
If the radar sensor cover or the radar
sensor ever needs to be removed,
take your vehicle to a dealer. Do not allow anything to impact the
radarsensorortheradarsensor
cover. If either of these parts
receives a strong impact, switch the
system of f by pressing the CMBS
OFF button, and have your vehicle
checked by a dealer. If the f ront
grille ever needs to be repaired,
consult a dealer f irst.
Thetiresarenotcorrectly
maintained. Always make sure the
tire pressures are correct (see
page ), and that the tires are
thecorrectsizeandingood
condition (see Tires on page ). Your vehicle is tilted because of a
heavy load in the rear or from
modif ications to the suspension.
Do not overload your vehicle (see
Carrying Cargo on page ), and
do not make any modif ications to
the suspension (see Accessories
and Modif ications on page ).394
392
482
481
Collision Mitigation Braking System (CMBS )
420
TM TM
When the CMBS is on, the radar sensor
constantly scans f or vehicles directly
ahead of you. This means that driving
on a road with a f ew or no vehicles
could cause a CHECK CMBS RADAR
SENSOR message to appear on the
multi-inf ormation display. This is
normal and not a cause f or concern.
11/07/20 18:55:22 31SJA670_425
ProCarManuals.com

µµ
ÃŽ
ÃŽ
e-pretensioner The radar sensor
detects a vehicle.Braking Audio & Visual
WARNING
Stage one
Stage threeDistance between vehiclesCMBS
Stage two
Retracts the driver’s
seat belt gently a few
times, providing a
physical warning.
Forcef ully tightens
driver and front
passenger seat belts. There is a risk of a
collision with the
vehicle ahead of you.
The risk of a collision
hasincreased,timeto
respond is reduced.
The CMBS
determines that a
collision is
unavoidable.Lightly
applied
Forcefully
applied ‘‘BRAKE’’ f lashes
on the multi-
information
display.
A beep sounds
and ‘‘BRAKE’’
f lashes on the
multi-information
display.
:
Depending on the circumstances, CMBS may not go through all of the alert stages bef ore initiating the last stage.
Collision Mitigation Braking System (CMBS )
422
YOUR
VEHICLE YOUR
VEHICLE
YOUR
VEHICLEVEHICLE
AHEADVEHICLE
AHEAD
VEHICLE
AHEAD
TM TM
11/07/20 18:55:36 31SJA670_427
ProCarManuals.com

Any of the conditions below can
cause the CMBS to shut of f . When
the system shuts off, the CMBS
indicator in the instrument panel
comes on, and a CHECK CMBS
SYSTEM message appears on the
multi-inf ormation display f or about 5
seconds.
An abnormal tire condition is
detected (wrong tire size, f lat tire,
etc.).
Extended off-road or mountainous
driving.
Driving your vehicle with the
parking brake applied.
Driving your vehicle in bad
weather(rain,fog,snow,etc.).
A dirty radar sensor cover on the
f ront grille. To switch the CMBS of f , press the
CMBS OFF button on the dashboard
f or about 1 second. When you do this,
a beeper sounds, a CMBS indicator
on the instrument panel comes on,
and a CMBS OFF message appears
on the multi-information display. To
switch the system back on, press the
button again f or about 1 second.When you turn the ignition switch to
the ON (II) position, the system will
be in the previously selected on or
off setting.
CONT INUED
Collision Mitigation Braking System (CMBS )
Automatic Shut Of f CMBS OFF Button
Driving
423
CMBS OFF BUTTON
TM TM
11/07/20 18:55:46 31SJA670_428
ProCarManuals.com

When the VSA system indicator
comes on (see page ). The CMBS indicator normally comes
on under these conditions:
When you manually switch of f the
system.
When the system shuts off
automatically.
When you drive in bad weather
(rain, snow, f og, etc.).
If anything covers the radar
sensor cover (dirt, mud, dry leaves,
wet snow, etc.). The CMBS will automatically switch
on again if the conditions that caused
it to switch of f are improved.
This indicator comes on f or several
seconds when you turn the ignition
switch to the ON (II) position. It also
comesonandstaysonwhenyou
turn the CMBS off by pressing the
CMBS OFF button.
To switch the CMBS back on, make
sure the vehicle is stopped and the
ignition switch is in the ON (II)
position, then press the CMBS OFF
button f or about 1 second.435 CMBS Indicator
Collision Mitigation Braking System (CMBS )
424
CMBS INDICATOR
TM TM
11/07/20 18:55:54 31SJA670_429
ProCarManuals.com

Your vehicle is equipped with a tire
pressure monitoring system (TPMS)
that turns on every time you start the
engine and monitors the pressure in
your tires while driving.
Each tire has its own pressure
sensor. If the air pressure of a tire
becomes signif icantly low, the
sensor in that tire immediately sends
a signal that causes the low tire
pressure/TPMS indicator in the
instrumental panel and the
appropriate tire position indicator on
thetirepressuremonitoronthe
multi-inf ormation display (see page
)tocomeon.Refer to page for tire inflation
guidelines.
If there is a problem with the TPMS,
this indicator begins to f lash. It stops
flashing after approximately 1
minute, then stays on. You will also
see a ‘‘CHECK TPMS SYSTEM’’
message on the multi-inf ormation
display (see page ). When the low tire pressure/TPMS
indicator is on, one or more of your
tires is signif icantly underinf lated.
The multi-inf ormation display also
shows a ‘‘CHECK TIRE PRESSURE’’
message (see page ). You should
stop and check your tires as soon as
possible, and inflate them to the
proper pressure as indicated on the
vehicle’s tire inf ormation placard.
Driving on a signif icantly under
inf lated tire causes the tire to
overheat and can lead to tire failure.
Underinf lation also reduces f uel
efficiency and tire tread life, and may
af f ect the vehicle’s handling and
stopping ability.
Becausetirepressurevariesby
temperature and other conditions,
the low tire pressure/TPMS
indicator may come on unexpectedly.For example, if you check and fill
your tires in a warm area, then drive
in extremely cold weather, the tire
pressure will be lower than
measured and could be underinf lated
and cause the low tire pressure/
TPMS indicator to come on. Or, if
youcheckandadjustyourtire
pressure in cooler conditions, and
drive into extremely hot conditions,
the tire may become overinf lated.
However, the low tire pressure/
TPMS indicator will not come on if
thetiresareoverinflated.
431431
481
433
CONT INUED
Low Tire Pressure/
TPMS Indicator
Tire Pressure Monitoring System (TPMS)
Driving
429
11/07/20 18:56:33 31SJA670_434
ProCarManuals.com

Although your tire pressure is
monitored, you must manually check
thetirepressuresmonthly.
Each tire, including the spare, should
be checked monthly when the
vehicle is cold, and set to the
recommended inf lation pressure as
specif ied on the vehicle placard and
intheowner’smanual(seepage
).
If the tire is f lat, or if the tire
pressure is too low to continue
driving, replace the tire with the
compact spare tire (see page ). If you think you can saf ely drive a
short distance to a service station,
proceed slowly to the station, then
inflate the tire to the recommended
pressure.If you have a f lat tire, the low tire
pressure/TPMS and tire monitor
indicators will come on. Replace the
indicated f lat tire with the compact
sparetire(seepage ).
After the flat tire is replaced with the
spare tire, the low tire pressure/
TPMS indicator stays on while
driving. Af ter several miles
(kilometers) driving, this indicator
begins to f lash, then stays on again.
You will also see a ‘‘CHECK TPMS
SYSTEM’’ message on the multi-
inf ormation display. This is normal;
the system cannot monitor the spare
tire pressure. Manually check the
sparetirepressuretobesureitis
correct.
This indicator and the warning
message on the multi-inf ormation
display will go of f , af ter several miles
(kilometers) driving, when the spare
tire is replaced with the specifiedregular tire equipped with the tire
pressure monitor sensor.
Never use a puncture-repairing agent
in a f lat tire. If used, you will have to
replace the tire pressure sensor.
Havetheflattirerepairedbyyour
dealer as soon as possible.
Each wheel is equipped with a tire
pressure sensor. You must use
TPMS specif ic wheels. It is
recommended that you always have
your tires serviced by your dealer or
a qualif ied technician. 482
496497 Changing a T ire with T PMS
Tire Pressure Monitoring System (TPMS)
430
11/07/20 18:56:41 31SJA670_435
ProCarManuals.com