Acura RSX 2002 Owners Manual

On Canadian models
Both f ront seats are equipped with
seat heaters. The ignition switch
must be ON (II) to use them. Push
the heater switch to turn the power
on or of f . The pilot lamp lights and
remains on while the heaters are on.Do not use the seat heaters when the
engine is of f or when idling f or a
long period of time. They can drain
the battery, making your car hard to
start.
Seat Heaters
Inst rument s and Cont rols88
S SE
EA
A T
T H
HE
EA
A T
TE
ER
R S
SWWI ITT C
CH H

The cargo area cover may be re-
moved to give you more cargo room.Open the hatch. Push up on the sides of the cargo
area cover to release the cover
f rom the hooks.
Pull down on the cover to remove
the mounting pins f rom the holes
in the hatch lining.
1. 2.
3.
CONT INUED
Cargo Area Cover
Inst rument s and Cont rols89
M MO
OUUNNTTI
INNG G P
PI
INN
H
H O
OO OKK

Reverse this procedure to install the
cargo area cover.Thereisareferencelineonthe
cargo area side panel. To avoid
damaging the cargo cover, remove it
if the cargo goes above that line.
Do not place items on the cargo area
cover, or stack objects higher than
the top of the back seat. They could
block your view and be thrown about
the vehicle during a crash or sudden
stop.Your car’s windows are electrically-
powered. Turn the ignition switch to
ON(II)toraiseorloweranywindow.
Each door has a switch that controls
its window. To open the window,
push the switch down and hold it.
Release the switch when you want
the window to stop. Close the
window by pulling back on the
switch and holding it. Power Windows
Inst rument s and Cont rols
Cargo A rea Cover, Power Windows
90
R RE
EF
FEE R
RE EN
NC CEE

µ
The driver’s armrest has a master
power window control panel. To
open the passenger’s window, push
down on the switch and hold it until
the window reaches the desired
position. To close the window, pull
back on the window switch. Release
the switch when the window gets to
the position you want. The master control panel also con-
tains these extra features:
To open the driver’s
window f ully, push the window
switch f irmly down, then release it.
The window automatically goes
down all the way. To stop the
window f rom going all the way down,
pull back on the window switch
brief ly.
To close the driver’s window f ully,
pull back the window switch f irmly,
then release it. The window
automatically goes all the way up. To
stop the window f rom going all the
way up, push down on the window
switch brief ly.
CONT INUED
AUTO
Power Windows
Inst rument s and Cont rols91
M M A
AI
INN S
SWWI ITT C
CH H
D
D R
RIIVV E
ER
R’ ’SS W
WI INND DO
OW W S
SWWI ITT C
CH H
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.

To open or close the driver’s window
partially, push down or pull back on
the window switch lightly and hold it.
The window will stop when you
release the switch.
If the driver’s window runs into any
obstacle while it is closing
automatically, it will stop, and then
reverse direction. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.The MAIN switch controls power to
the passengers’window. With this
switch of f , the passengers’window
cannot be raised or lowered. The
MAIN switch does not af f ect the driv-
er’s window. Keep the MAIN switch
off whenyouhavechildreninthecar
so they do not injure themselves by
operating the window unintentionally.
The lights inside the switches come
onwhenyouturntheparkinglights
or headlights on.
If your car’s battery is disconnected
or goes dead, or the driver’s window
f use is removed, the AUTO f unction
will be disabled. The power window
system needs to be reset af ter
reconnecting the battery or installing
the f use. You should do the f ollowing.
Start the engine. Push down on
the driver’s window switch until
the window is f ully open.
Pull back on the driver’s window
switch to close the window
completely, then hold the switch
f or a second or two more.
If the power windows do not operate
properly af ter resetting, have your
car checked by an Acura dealer. 1.
2.
Auto Reverse
Power Windows
Inst rument s and Cont rols92

Usetheswitchonthedashboardto
open and close the moonroof . The
ignition switch must be ON (II).
Pushandholdthe switchto
open the moonroof . Release the
switch when the moonroof reaches
the desired position. To close the
moonroof , press and hold theswitch.
U.S.:
Canada: All models
Premium and Type-S modelsonly
Inst rument s and Cont rols
Moonroof
93
Closing the moonroof on
someone’s hands or fingers can
cause serious injury.
Make sure passengers are
clear of the moonroof before
closing it. If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.

Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.Adjust the outside mirrors with the
adjustment switch on the lef t side of
the dashboard:
Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side). Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
1.
2. 3.
4.
Adjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols94
T T
A
A B
B
A
AD
DJ
JUUS STTM
M E
EN
NT T S
SWWI ITT C
CH H
S
SE EL
LEE C
CT TO
OR R S
SWWI ITT C
CH H

To apply the parking brake, pull the
lever up f ully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake light on
the instrument panel should go out
when the parking brake is f ully
released (see page ).
The outside mirrors are heated to re-
move fog and frost. With the ignition
switchON(II),turnontheheaters
by pressing the button. The light in
the button comes on as a reminder.
Press the button again to turn the
heaters off.
61Canada: Premium and Type-S models
only
Parking Brake
Inst rument s and Cont rols
Mirrors, Parking Brake
95
P PA
A R
RKKIINNG G B
BRRAA K
KEE L
LEE V
V E
ER
R
H
H E
EA
A T
TE
ED
D M
MI
IRRR ROOR R B
BUUT TT
TO
ON NDriving the car with the parking brake
applied can damage the rear brakes
and axles.

Touseavanitymirroronthebackof
the sun visor, pull up the cover.To use this coat hook, rotate the
hook down. Close it with a f irm push.
Vanity Mirror, Coat Hook
Vanity Mirror
Coat Hook
Inst rument s and Cont rols96

Be caref ul when you are using the
beverage holder. A spilled liquid that
is very hot can scald you or your
passengers. Spilled liquids can also
damage the upholstery, carpeting,
and electrical components in the
interior.
To open the beverage holder, push
the lef t knob and slide the cover
forward.
The beverage holders f or the rear
seat passenger’s are located in the
armrests.
CONT INUED
Beverage Holder
Inst rument s and Cont rols97
P P
u
us
shh