ABS Acura RSX 2003 User Guide

µµ
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ì
Ì
Î
CONT INUED
Maint enance201
U.S. Owners
Canadian Owners A, B, C, D
A
B
C
D
Refer to page to determine which schedule to use.
Use the Maintenance Schedule for Severe Conditions.
5,000 mi/8,000 km/6 mos
10,000 mi/16,000 km/1 yr
15,000 mi/24,000 km
15,000 mi/24,000 km/1-½ yrs
20,000 mi/32,000 km/1 yr
25,000 mi/40,000 km/2 yrs
30,000 mi/48,000 km
30,000 mi/48,000 km/2 yrs
35,000 mi/56,000 km/2-½ yrs
40,000 mi/64,000 km/2 yrs
3yrs
45,000 mi/72,000 km
45,000 mi/72,000 km/3 yrs
50,000 mi/80,000 km/3 yrs
55,000 mi/88,000 km/3-½ yrs
60,000 mi/96,000 km
60,000 mi/96,000 km/3 yrs
65,000 mi/104,000 km/4 yrs
70,000 mi/112,000 km/4 yrs
75,000 mi/120,000 km
75,000 mi/120,000 km/4-½ yrs
80,000 mi/128,000 km/4 yrs
85,000 mi/136,000 km/5 yrs
90,000 mi/144,000 km
90,000 mi/144,000 km/5 yrs Do items in A.
Do items in A, B.
Clean air cleaner element (independent of
time).
Do items in A.
DoitemsinA,B,C.
Do items in A. Replace air cleaner element (independent of
time).
DoitemsinA,B,D.
Do items in A.
DoitemsinA,B,C. Replace brake fluid (independent of mileage).
Clean air cleaner element (independent of
time).
Do items in A.
Do items in A, B.
Do items in A. Replace air cleaner element (independent of
time). Replace transmission fluid (M/T, A/T).
DoitemsinA,B,C,D.
Do items in A.
Do items in A, B. Clean air cleaner element (independent of
time).
Do items in A.
DoitemsinA,B,C.
Do items in A. Replace air cleaner element (independent of
time). Replace transmission fluid (A/T).
DoitemsinA,B,D.
Service at the indicated distance or time, whichever comes first. Do the items in as required for each distance/time.
Replace engine oil.
Inspect front and rear brakes.
Rotate tires (follow pattern on page238).
Lubricate all hinges, locks, and latches.
Replace engine oil filter.
Inspect tie rod ends, steering gear box and boots.
Inspect suspension components.
Inspect driveshaft boots.
Check parking brake adjustment.
Inspect brake hoses and lines (including ABS).
Check all fluid levels, condition of fluids, and check
for leaks. Inspect exhaust system.
Inspect fuel lines and connections.
Check all lights.
Inspect the underbody.
Inspect and adjust drive belts.
Replace dust and pollen filter.
196
1
Maintenance Schedule for Severe Conditions (listed by distance/time)

Remove the blade f rom its holder
by grasping the tabbed end of the
blade. Pull f irmly until the tabs
come out of the holder.Examine the new wiper blades. If
they have no plastic or metal rein-
f orcement along the back edge,
remove the metal reinf orcement
strips f rom the old wiper blade and
install them in the slots along the
edge of the new blade.Slide the new wiper blade into the
holder until the tabs lock.
Slide the wiper blade assembly
onto the wiper arm. Make sure it
locks in place.
Lower the wiper arm down against
the windshield or rear window.
3. 4. 5.
6.
7.
Wiper Blades
Maint enance230
BLADE
BLADE
REINFORCEMENT

To replace it:Open the glove box. Remove the
hooks on the side panels by pulling
out on the tabs. Pivot the glove
box out of the way.
The dust and pollen f ilter is located
behind the glove box.
This f ilter should be replaced every
30,000 miles (48,000 km) under
normal conditions. It should be
replaced every 15,000 miles (24,000
km) if you drive primarily in urban
areas that have high concentrations
of soot in the air f rom industry and
diesel-powered vehicles. Replace it
more of ten if air f low f rom the
heating and cooling system becomes
less than usual. The dust and pollen f ilter removes
pollen and dust that is brought in
f rom the outside through the heating
andcoolingsystem.
Remove the dust and pollen f ilter
cover by pushing up on the lock
tab, then pivoting up the cover.
1. 2.
U.S. : All models
Canada : Premium and Type-S Optional on RSX Replacement
Dust and Pollen Filter
Maint enance232
HOOKS
TABCOVER

If you ever need to replace a wheel,
make sure the wheel’s specif ications
match those of the original wheel
that came on your car. Replacement
wheels are available at your Acura
dealer. TheABSworksbycomparingthe
speed of the wheels. When replacing
tires, use the same size originally
supplied with the car. Tire size and
construction can af f ect wheel speed
and may cause the system to work
inconsistently.
It is best to replace all f our tires at
thesametime.If thatisnotpossible
or necessary, then replace the two
f ront tires or the two rear tires as a
pair. Replacing just one tire can
seriously af f ect your car’s handling.
The tires that came with your car
were selected to match the perform-
ance capabilities of the car while
providing the best combination of
handling, ride comf ort, and long lif e.
Youshouldreplacethemwithradial
tires of the same size, load range,
speed rating, and maximum cold tire
pressure rating (as shown on the
tire’s sidewall). Mixing radial and
bias-ply tires on your car can reduce
its braking ability, traction, and
steering accuracy.
CONT INUED
Replacing T ires and Wheels
Tires
Maint enance239
Installing improper tires on your
car can affect handling and
stability. This can cause a crash
in which you can be seriously
hurt or killed.
Always use the size and type of
tires recommended in this
owner’s manual.

Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way and remove the bulb.Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
(Passenger’s side)
Install the power steering
reservoir on the bracket.
3.
4.
5. 6.
7.
8.
9.
Lights
Maint enance245
BULB
WEATHER
SEAL
HOLD
DOWN WIRE CONNECTOR

Removethelensbycarefully
prying on the edge of the lens with
a f ingernail f ile or a small f lat-tip
screwdriver. Do not pry on the
edge of the housing around the
lens.Remove the bulb by pulling it
straight out of its metal tabs.
Push the new bulb into the metal
tabs. Snap the lens back in place.
Remove the cargo area light
assembly by caref ully prying on
the lef t edge of the lens with a f lat-
tip screwdriver and pulling the
assembly out. Open the hatch.
1. 2.
3.
1.
2.
Lights
Maint enance
Replacing a Ceiling L ight Bulb Replacing a Cargo A rea L ight
Bulb
250
BULB
BULB

Repair chips and scratches in the
paint as soon as you discover them.
Inspect and clean out the drain
holes in the bottom of the doors
and body.
Check the f loor coverings f or
dampness. Carpeting and f loor
mats may remain damp f or a long
time, especially in winter. This
dampness can eventually cause
the f loor panels to corrode.
Two f actors normally contribute to
causing corrosion in your car:
Moisture trapped in body cavities.
Dirtandroadsaltthatcollectsin
hollows on the underside of the
car stays damp, promoting
corrosion in that area.
Removal of paint and protective
coatings f rom the exterior and
underside of the car. Many corrosion-preventive measures
are built into your Acura. You can
help keep your car f rom corroding
by perf orming some simple periodic
maintenance:
Use a high-pressure spray to clean
the underside of your car. This is
especially important in areas that
useroadsaltinwinter.Itisalsoa
good idea in humid climates and
areas subject to salt air. Cars
equipped with ABS have a sensor
and wiring at each wheel. Be
caref ul not to damage them.
Have the corrosion-preventive
coatings on the underside of your
car inspected and repaired
periodically.
1.
2.
Corrosion Prot ect ion
Appearance Care259

Î
ÎÎ
ÎÎ
Î
No. Circuits Protected No.
Circuits Protected
1
2
3
4
5
6
7
8
9
10
11
12 Ignition Coil
Laf Heater
Daytime Running Lights
ACG (IG)
Not Used
Power Window Relay
Moon roof
Radio
Rear Wiper
Gauge panel
ABS
Daytime Running Lights 13
14
15
16
17
18
19
20
21
22
23
24
25
SRS
Power Mirror
Bass Speaker
Heated Seats
Fuel Pump
Accessory Power Socket
Turn Signal
Front Wiper
Not Used
Front Passenger’s Power Window
Driver’s Power Window
Not Used
Not Used
Canadian models only
Type-S only
1:
2:
1
1 2
1
Fuses
T aking Care of t he Unexpect ed283
INTERIOR FUSE BOX

µ
No.Circuits Protected
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21 25 Condenser f an
Small Light
Interior Light
Cooling Fan
Hazard
FI ECU
Horn, Stop
ABS (F/S)
Back Up
ABS Motor
Rear Demister
Heater Mortor
Power Window
Option
Lef t Headlight
Door Lock
Right Headlight
Not Used
Main Fuse Battery
Main Fuse Ignition
Spare Fuse
T aking Care of t he Unexpect ed
Fuses
284
UNDER HOOD FUSE BOX

CONT INUED
...
Accessories and Modif ications . 162
................................
Accessories .162
...
Additional Safety Precaution . 163
............................
Modif ications .163
ACCESSORY (Ignition Key .......................................
Position) .78
...............
Accessory Power Socket . 99
....................
Additives, Engine Oil . 209
.............................
Airbag (SRS) .10, 48
.....................
Air Cleaner Element .222
..............
Air Conditioning System . 102
..............................
Maintenance .231
.........................................
Usage .102
.......................
Air Outlets (Vents) .102
.......................
Air Pressure, Tires .235
.......................
Alcohol in Gasoline .294
......................................
Antif reeze .212
Anti-lock Brakes (ABS) ...............................
Indicator .61, 183
...................................
Operation .182
Anti-thef t Steering Column ..............................................
Lock .78
..........................
Appearance Care .253
................................
Audio System .109 .............
Automatic Speed Control . 149
..............
Automatic Transmission . 173
..........................
Capacity, Fluid .290
...............
Checking Fluid Level . 217
.......................................
Shif ting .173
.
Shif t Lever Position Indicator . 173
................
Shif t Lever Positions . 173
....................
Shif t Lock Release . 179
Battery Charging System ...........................
Indicator .61, 275
............................
Jump Starting .269
..............................
Maintenance .226
............................
Specif ications .291
..............................
Bef ore Driving .153
....................................
Belts,Seat .8,44
.............................
Beverage Holder .97
...................................
Body Repair .260
Brakes ...........
Anti-lock System (ABS) . 182
.............
Break-in, New Linings . 155
....................
Bulb Replacement .249
...........................................
Fluid .219 .........................................
Parking .95
.................
System Indicator . 60,278
........................
Wear Indicators .181
.............................
Braking System .181
........................
Break-in, New Car .155
..
Brightness Control, Instruments . 70
........................
Brights, Headlights .69
Bulb Replacement ..........................
Back-up Lights .249
..............................
Brake Lights .249
......................
Cargo Area Light .250
..............................
Ceiling Light .250
................
Front Parking Lights . 247
.........
Front Turn Signal Lights . 246
.................................
Headlights .244
.........
High-mount Brake Light . 247
...................
License Plate Light . 248
.........
Rear Side Marker Lights . 249
............................
Specif ications .291
...................................
Spotlights .251
..............................
Bulbs, Halogen .244
Index
A
B
I