engine oil type Acura RSX 2004 Owner's Manual
[x] Cancel search | Manufacturer: ACURA, Model Year: 2004, Model line: RSX, Model: Acura RSX 2004Pages: 250, PDF Size: 3.3 MB
Page 124 of 250
Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:Avoid full-throttle starts and rapid
acceleration.
Avoidhardbrakingforthefirst
200 miles (300 km).
Do not change the oil until the
scheduled maintenance time.
Do not tow a trailer. Your Acura is designed to operate on
unleaded gasoline with a pump
octane number of 86 or higher.
Your Acura is designed to operate on
premium unleaded gasoline with a
pump octane number of 91 or higher.
You should also f ollow these re-
commendations with an overhauled
or exchanged engine, or when the
brakes are replaced. Useof aloweroctanegasolinecan
cause a persistent, heavy, metallic
rapping noise in the engine that can
lead to mechanical f ailure.
We recommend gasoline containing
detergent additives that help prevent
f uel system and engine deposits. In
addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it is
available, the use of gasoline that
does NOT contain manganese-based
f uel additives such as MMT. Use ofgasoline with these additives may
adversely affect performance, and
cause the Malf unction Indicator
Lamp on your instrument panel to
come on. If this happens, contact
your authorized Acura dealer f or
service. For f urther important f uel-
related information, please refer to
your Quick Start Guide.
Some gasoline today is blended with
oxygenates such as ethanol or
MTBE. Your vehicle is designed to
operate on oxygenated gasoline
containing up to 10 percent ethanol
by volume and up to 15 percent
MTBE by volume. Do not use
gasoline containing methanol.
If you notice any undesirable
operating symptoms, try another
service station or switch to another
brand of gasoline.(All models except Type-S)
(Type-S)
Break-in Period Fuel Recommendation
Bef ore Driving
Break-in Period, Fuel Recommendation
121
Page 168 of 250
µ
An oil with a viscosity of 5W-30 is
pref erred f or improved f uel economy
and year-round protection in your
Acura. You may use a 10W-30 oil if
the temperature in your area never
goes below 20°F ( 7°C). Your Acura does not require any oil
additives. Additives may adversely
af f ect your engine’s or transmission’s
perf ormance and durability.Always change the oil and f ilter
according to the recommendations in
the maintenance schedule. The oil
and f ilter collect contaminants that
can damage your engine if they are
not removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
Run the engine until it reaches
normal operating temperature,
then shut it off.
You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals given in the maintenance
schedule.
1.
CONT INUED
Type-S
Maint enance
Synthetic Oil
Engine Oil A dditivesChanging the Oil and Filter
A dding Engine Oil, Changing the Oil and Filter
165
Ambient Temperature
Page 169 of 250
Open the hood and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.Remove the oil f ilter, and let the
remaining oil drain. A special
wrench (available f rom your Acura
dealer) is required.
Install a new oil f ilter according to
the instructions that come with it.Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten it to:
Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including f ilter):
4. 3.
2. (Type-S) (RSX and Premium models)
5.
6.
Type-S RSX and Premium models
Changing the Oil and Filter
Maint enance166
WASHER OIL DRAIN BOLT OIL FILTER
33 lbf·ft (44 N·m , 4.5 kgf·m)
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.8 US qt (4.5
)
4.2 US qt (4.0
)
Page 170 of 250
CONT INUED
Replace the engine oil f ill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn of f the
engine and check your work.
Let the engine run f or several
minutes, then check the drain bolt
and oil f ilter f or leaks.
Turn of f the engine, let it sit f or
several minutes, then check the oil
level on the dipstick. If necessary,
add more oil.Check the f luid level in the
windshield washer reservoir at least
monthly during normal use.
Fill the reservoir with a good-quality
windshield washer f luid. This
increases the cleaning capability and
prevents f reezing in cold weather.
When you ref ill the reservoir, clean
the edges of the windshield wiper
blades with windshield washer f luid
on a clean cloth. This will help to
condition them.
Always use Honda All Season
Antif reeze/Coolant Type 2. This
coolant is pre-mixed with 50 percent
antif reeze and 50 percent water.
Never add straight antifreeze or
plain water. If the coolant level in the reserve
tank is at or below the MIN line, add
coolant to bring it up to the MAX line.
Inspect the cooling system f or leaks.
7.
8.
9.
Changing the Oil and Filter, Windshield Washers, Engine Coolant
Maint enance
A dding Engine Coolant
Windshield Washers
167
NOTICE:
NOTICE:
MAX
MIN
Do not use engine antif reeze
or vinegar/water solution in the
windshield reservoir. Antif reeze can
damage your vehicle’s paint, while a
vinegar/water solution can damage the
windshield washer pump. Use only
commercially available windshield
washer f luid.
Improper disposal of engine
oil can be harmf ul to the environment.
If you change your own oil, please
dispose of the used oil properly. Put it
in a sealed container and take it to a
recycling center. Do not discard it in a
trash bin or dump it on the ground.
Page 223 of 250
µµ
Î
Î
Î
Î
Î
Î
Î
ÎÎ
Î
Î
Î Î
Î
Î
Î
Î
Î
Î
Î
Specif ications
T echnical Inf ormation220
Dimensions
Weights Air Conditioning
Capacities
Engine 173.0 in (4,395 mm)
67.9 in (1,725 mm)
55.1 in (1,400 mm)
HFC-134a (R-134a)
17.6 19.4 oz (500 550 g) SP-10
13.2 US gal (50
)
1.35 US gal (5.1
)
101.2 in (2,570 mm)
58.3 in (1,482 mm)
58.3 in (1,481 mm)
3.19 x 3.50 in (81.0 x 88.9 mm) 121.9 cu-in (1,998 cm
)
9.8 : 1
11.0 : 1 1.32 US gal (5.0
)
1.69 US gal (6.4
)
1.66 US gal (6.3)
4.2 US qt (4.0
)
4.8 US qt (4.5)
4.2 US qt (4.0)
4.8 US qt (4.5)
5.6 US qt (5.3)
6.1 US qt (5.8)
0.16 US gal (0.6
)
Including the coolant in the reserve tank and that remaining in the
engine.
Reserve tank capacity:
Excluding the oil remaining in the engine.
Length
Width
Height
Wheelbase
Track
Gross vehicle weight rating See the certification label attached
to the driver’s doorjamb. Refrigerant type
Charge quantity
Lubricant type
Fuel tank
Engine
coolant
Engine oil
Type
BorexStroke
Displacement
Compression ratio
Spark plug Water cooled 4-stroke
DOHC VTEC in line,
4-cylinder gasoline engine.
IZFR6K11
IFR7G-11KS
SKJ20DR-M11
SK22PR-M11S Approx.
1:
2:
3:
4:
Front
Rear
ChangeManual
Automatic
Total Manual
Automatic
Change Including filter
Without filter
Total
RSX and Premium models
Type-S
1:
2:
RSX and Premium models
Type-S
NGK
DENSO
1
21
2
1
2 1
4
2
3
2
3
2
3
Page 250 of 250
Service Inf ormat ion Summary
Gasoline:
Fuel Tank Capacity:
Recommended Engine Oil:Automatic Transmission Fluid:
Manual Transmission Fluid:
Power Steering Fluid:
Brake Fluid:
Tire Pressure (measured cold):
13.2 US gal (50
)
33 psi (230 kPa , 2.3 kgf/cm
)
31 psi (220 kPa , 2.2 kgf/cm
)
1.6 US qt (1.5
)
4.2 US qt (4.0
)
4.8 US qt (4.5
) SAE 5W-20
SAE 5W-30
Unleaded gasoline, pump octane
number of 86 or higher.
Premium unleaded gasoline,
pump octane number of 91 or
higher.
API Premium grade detergent oil.
Oil change capacity (including
filter):
Honda Manual Transmission
Fluid preferred, or an SAE 10W-30
or 10W-40 motor oil as a
temporary replacement (see page
).
Capacity (including differential): Honda Power Steering Fluid
preferred, or another brand of
power steering fluid as a
temporary replacement. Do not
use ATF (see page ).
Honda Heavy Duty Brake Fluid
DOT 3 preferred, or a DOT 3 or
DOT 4 brake fluid as a temporary
replacement (see page ).
Front:
Rear:
Honda ATF-Z1 (Automatic
Transmission Fluid) preferred, or
aDEXRON
III ATF as a
temporary replacement (see page ).
(All except Type S)
(Type S)
(All except Type-S)
(Type-S)
Except Type-S:
Type-S: 169
170 173
171