parking brake Acura TL 2004 Owner's Manual
[x] Cancel search | Manufacturer: ACURA, Model Year: 2004, Model line: TL, Model: Acura TL 2004Pages: 283, PDF Size: 3.84 MB
Page 52 of 283
This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your Acura. All the essential controls
are within easy reach............................
Control Locations .50
............................
Instrument Panel .51
..........
Instrument Panel Indicators . 52
.............................................
Gauges .57
...................
Temperature Gauge . 57
..................................
Fuel Gauge .57
.............
Multi-Inf ormation Display . 58
......
Controls Near Steering Wheel . 72
.
Windshield Wipers and Washers . 73
...........
Turn Signal and Headlights . 74
........................................
Fog Lights .75
........
Instrument Panel Brightness . 75
..................
Automatic Lighting Off . 76
.................
Hazard Warning Button . 76
.................
Rear Window Def ogger . 77
..........
Steering Wheel Adjustment . 78
..................................................
Keys .79
................................
Ignition Switch .80
........................
Immobilizer System .81
......................................
Door Locks .82
................................................
Trunk .83
............
Emergency Trunk Opener . 84
..................
Childproof Door Locks . 84
.......................
Remote Transmitter .85
.................................................
Seats .90
............
Trunk Pass-through Cover . 90.............................................
Mirrors .91
Driving Position Memory ..........................................
System .93
....................................
Seat Heaters .96
..............................
Power Windows .97
.......................................
Moonroof .100
..............................................
Clock .103
...............................
Parking Brake .103
...............................
Interior Lights .104
.........
Interior Convenience Items . 105
.......................
Beverage Holder .106
.........
Accessory Power Socket . 106
..................................
Glove Box .107
.............
Console Compartment . 107
....................
Front Door Pocket . 108
Instruments and Controls
Inst rument s and Cont rols49
Page 54 of 283
Inst rument s and Cont rols
Instrument Panel
51
HIGH BEAM INDICATOR
CHARGING SYSTEM
INDICATOR
SUPPLEMENTAL
RESTRAINT
SYSTEM INDICATOR
LIGHTS ON
INDICATOR
CRUISE MAIN
INDICATOR
SEAT BELT REMINDER
INDICATOR
CRUISE CONTROL
INDICATOR
VEHICLE
STABILITY
ASSIST (VSA)
SYSTEM
INDICATOR
LOW OIL PRESSURE
INDICATOR MULTI-INFORMATION
DISPLAY
SIDE AIRBAG OFF
INDICATOR
ANTI-LOCK BRAKE
SYSTEM INDICATOR LOW FUEL INDICATORPARKING BRAKE AND
BRAKE SYSTEM INDICATOR
VSA ACTIVATION
INDICATOR
FOG LIGHT
INDICATOR
MALFUNCTION INDICATOR LAMP
IMMOBILIZER SYSTEM
INDICATOR
(P.54)
(P.52)
(P.53) (P.55)
(P.54) (P.55)
(P.54)
(P.52, 240)
(P.56) (P.52,
240) (P.56) (P.52,
243) (P.53)
(P.59)
(P.56)
(P.52)
(P.53)
(P.54)
Page 55 of 283
The instrument panel has many
indicators to give you important
inf ormation about your vehicle.
If you turn the ignition switch to ON
(II) bef ore f astening your belt, the
beeper sounds and the indicator
f lashes. If you do not f asten your
seat belt bef ore the beeper stops, the
indicator stops f lashing but remains
on.The engine can be severely damaged
if this indicator f lashes or stays on
when the engine is running. For
more inf ormation, see page .
If this indicator comes on when the
engine is running, the battery is not
being charged. For more inf ormation,
see page .
See page .This indicator has two f unctions:
Itcomesonwhenyouturnthe
ignition switch to ON (II). It is a
reminder to check the parking
brake. Driving with the parking
brake not f ully released can
damage the brakes and tires.
If it stays on after you have fully
released the parking brake while
the engine is running, or if it
comes on while driving, it can
indicate a problem in the brake
system. For more inf ormation, see
page .
If you drive without releasing the
parking brake, a chime will sound,
and you will see a ‘‘RELEASE
PARKING BRAKE’’ message in the
Multi-Inf ormation Display.
If you continue driving without
f astening your seat belt, the beeper
sounds and the indicator f lashes
again at regular intervals, and you
will see ‘‘FASTEN SEAT BELT’’ in
the multi-information display. 1.
2.
243 244
242
242
Instrument Panel Indicators
Inst rument s and Cont rols
Seat Belt Reminder
Indicator L ow Oil Pressure
Indicator
Charging System
Indicator
Malf unction Indicator
Lamp Parking Brake and
Brake System
Indicator
52
Canada
U.S.
Page 58 of 283
The lef t or right turn signal light
blinks when you signal a lane change
or turn. If the indicators do not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the Hazard Warning
button, both turn signals blink. All
turn signals on the outside of the
vehicle should f lash.This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. If you turn the
ignition switch to ACCESSORY (I)
or LOCK (0) without turning of f the
light switch, this indicator will
remain on. A reminder chime will
also sound when you open the driver’s
door.
This indicator comes on when you
turn the ignition switch to ON (II)
with the headlight switch off and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL.
This indicator comes on with the
high beam headlights. See page
f or inf ormation on the headlight
controls.
214
74
Canadian models only
Instrument Panel Indicators
Inst rument s and Cont rols
Turn Signal and
Hazard Warning
Indicators ‘‘Daytime Running
Lights’’ Indicator
Lights On Indicator
High Beam Indicator
55
Page 61 of 283
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages. Some of
the messages help you operate your
vehiclemorecomfortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.
Here is a list of the messages you
can see. The f ollowing pages give
you more inf ormation on these
messages.Driver 1 or 2 Detected
Door and Trunk Open
Fasten Seat Belt
Release Parking Brake
Check Fuel Cap
Odometer
Trip Meter
Outside Temperature
Engine Oil Lif e Maintenance Messages
Trip Computer
Keyless Memory Settings
HandsFree Link
Language Selection (Canada only)
With the multi-information display
and the two buttons next to it, you
can also customize these vehicle
control settings to your liking. Auto door lock conditions
Auto door unlock conditions
Whenever unlocking (driver’s
door, or all doors)
Keyless lock acknowledgment
conditions
Security relock timer
Headlight auto of f timer
Interior light dimming time
To customize these control settings,
see page .
Low Windshield Washer Fluid
Level (Canada only) 66
Multi-Inf ormation Display
Inst rument s and Cont rols58
SELECT/
RESET
BUTTON
INFO
BUTTON
TM
TM
Page 64 of 283
If you start driving without releasing
the parking brake, the multi-
inf ormation display interrupts the
current display and shows
‘‘RELEASE PARKING BRAKE!’’.
This message continues, and a
chime sounds, until you release the
parking brake or the vehicle speed
slows down to less than 0.5 mph (0.8
km/h).If the f uel f ill cap is missing or not
tightened properly, you will see
‘‘CHECK FUEL CAP’’. Make sure
the f uel cap is installed and tightened
properly to at least 3 clicks.The CHECK FUEL CAP message
should go of f af ter tightening the
f uel cap, turning the ignition switch
of f and on, then driving over 30 mph
f or at least 45 seconds. Due to
dif f erent driving conditions, it may
take a few drive trips to make the
message go of f .
If a loose or missing f uel cap was not
the cause of the CHECK FUEL CAP
message coming on, the message
will turn off and the Malfunction
Indicator Lamp will come on. If this
happens, have your vehicle checked
by an Acura dealer as soon as
possible.
Multi-Inf ormation Display
Inst rument s and Cont rols
Release Parking Brake
Check Fuel Cap
61
Page 77 of 283
µ
µ µ
Push down on the
lef t lever to signal a lef t turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever and
hold it. The lever will return to
center when you release it or
complete a turn.
The rotating switch
on the lef t lever controls the lights.
Turning this switch to the ‘‘ ’’
position turns on the parking lights,
taillights, instrument panel lights,
side-marker lights, and rear license
plate lights. Turning the switch to
the ‘‘ ’’ position turns on the
headlights. If you leave the lights on
with the key removed from the
ignition switch, you will hear a
reminder tone when you open the
driver’s door. To switch f rom low
beams to high beams, push the lef t
lever f orward until you hear a click.
The blue high beam indicator will
come on (see page ). Pull it back
to return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beams will stay on as long as you
hold the lever back.
With the headlight switch off, the
daytime running lights come on
when you turn the ignition switch to
ON (II) and release the parking
brake. They remain on until you turn
the ignition of f , even if you set the
parking brake.
Turn Signal
Of f
Parking and instrument panel
Headlights on
Fog lights of f (U.S. models)
Fog lights on (U.S. models)
High beams
Flashhighbeams
1.
2.
3.
4.
5.
6.
7.
8. 55
Turn Signal and Headlights
Inst rument s and Cont rols
Turn Signal
Headlights
High Beams
Daytime Running L ights
(Canadian Models)
74
Page 97 of 283
Doing any of the f ollowing af ter
pressing the MEMO button will
cancel the storing procedure.Not pressing a memory button
within 5 seconds.
Readjusting the seat position.
Readjusting the outside mirror
position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button. To select a memorized position, do
this:
Make sure the parking brake is set
(M/T) or the shif t lever is in Park
(A/T).
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button. The system will move the seat and
outside mirrors to the memorized
positions. The indicator in the
selected memory button will f lash
during movement. When the
adjustments are complete, you will
hear two beeps, and the indicator will
remain on.
You cannot select a memorized
position if the transmission is in
Reverse. Shif t to another gear,
then select.
If the parking brake is not set, you
must press and hold the memory
button until the adjustment is
complete.
1.
2.
Notes f or vehicles with M/T
Driving Posit ion Memory Syst em
Inst rument s and Cont rols
Selecting a Memorized Position
94
MEMORY BUTTONS
Page 106 of 283
To apply the parking brake, pull the
lever up f ully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake
indicator on the instrument panel
should go out when the parking
brake is f ully released (see page ).
The clock displays the time with the
ignition switch in the ON (II)
position. If your vehicle’s battery is
disconnected or goes dead, you will
need to reset the clock.
For example: 1:06 will reset to 1:00
1:52 will reset to 2:00
The clock is set automatically. Change the hour by pressing and
holding the H button until the
numbers advance to the desired time.
Change the minutes by pressing and
holding the M button until the
numbers advance to the desired time.
You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, press the R
button to set the clock back to the
previous hour. If the displayed time
is af ter the half hour, the clock sets
f orward to the beginning of the next
hour.
52On models without Navigation SystemOn models with Navigation System
Clock, Parking Brake
Inst rument s and Cont rols
Clock Parking Brake
103
Driving the vehicle with the parking
brake applied can damage the rear
brakes and axles.
Page 169 of 283
Park the vehicle, and set the
parking brake. Pull the hood
release handle located under the
lower lef t corner of the dashboard.
The hood will pop up slightly.
Put your f ingers between the f ront
edge of the hood and the f ront
grille to locate the hood latch
handle. Push this handle up until it
releases the hood. Lif t the hood.If the hood latch handle moves
stif f ly, or if you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated (see page ).
Lif t the hood up most of the way.
The hydraulic supports will lif t it
uptherestof thewayandholdit
up.
Lower the hood to about a f oot (30
cm) above the f ender, then press
down firmly with your hands. Make
sure it is securely latched.
1.
2.
3.212
Service Station Procedures
Opening the Hood
T o Close the Hood
Bef ore Driving166
HOOD RELEASE HANDLE
LATCH