buttons Acura TL 2006 User Guide

The f low-through ventilation system
draws in outside air, circulates it
through the interior, then exhausts it
through vents near the rear window.Set the temperature to maximum.
Make sure the A/C is of f .
Select and fresh air mode.
Set the f an to the desired speed.
The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes bef ore you
f eel warm air coming f rom the
system. Select and fresh air mode.
Set the f an to the desired speed.
Adjust the warmth of the air with
the temperature control buttons.
When you select , the system
automatically switches to f resh air
mode and turns on the A/C.
Thedriver’ssidemodeand
passenger’s side mode can be
selected separately when the dual
button is pressed. However, when
is selected on the driver’s
side, mode selection on the
passenger’s side is not possible.
When is selected, the
passenger’s temperature cannot be
set separately f rom the driver’s.
You can set the temperatures and
modes f or the driver’s side and the
passenger’s side separately when
this button is pressed (indicator on).
When the indicator in the DUAL
button is off, you can adjust both
sides to the same temperature and
mode with the driver’s side
temperature control buttons and
mode control button.
Use the mode control button to
select the vents the air flows from.
Some air will flow from the
dashboard vents in all modes.
Air flows from the center
and corner vents in the dashboard.
Airf low is divided between
the f loor vents and the def roster
vents at the base of the windshield.
Air f lows f rom the def roster
vents at the base of the windshield. Airf low is divided between
the vents in the dashboard and the
f loor vents. Air f lows f rom the f loor
vents. When you select , the
system automatically switches to
f resh air mode. 1.
2.
3.
4.
1.
2.
3.
Vents, Heating, and A/C
Ventilation
Using the Heater
Dual Button
Mode Control Button
Features
123

When the AUTO button on the
driver’s side is pressed, the
temperature control buttons on the
passenger’s side are disabled, and
the interior temperature is regulated
to the temperature set on the driver’s
side.WhentheAUTObuttononthe
passenger’s side is pressed,
temperature can be set on the driver’s
side and passenger’s side separately.
The system automatically selects the
proper mix of conditioned and/or
heated air that will, as quickly as
possible, raise or lower the interior
temperature to your pref erence.
When you set the temperature to its
lower or its upper limit, the system
runs at f ull cooling or heating only. It
does not regulate the interior
temperature.
The automatic climate control
system adjusts the f an speed and
airflow levels to maintain the interior
temperature you select.
In the AUTO mode, the vehicle’s
interior temperature is
independently regulated f or the
driver and passenger. If the driver’s
side of the vehicle is getting too
much sun, the system will adjust to a
lower temperature.
Select . The system
automatically switches to f resh air
mode and turns on the A/C. (The
A/C indicator will not come on in
U.S. vehicles, if the A/C was of f to
start with.)
Select .
Set the f an and temperature
controls to maximum level.
Press the AUTO button.
Set the desired temperature with
the temperature control buttons.
You will see AUTO in the system’s
display.
To clear the windshield f aster, you
can close the dashboard corner vents
by rotating the wheel below each
vent. This sends more warm air to
the windshield def roster vents. Once
the windshield is clear, select f resh
air mode to avoid fogging the
windows.
For your saf ety, make sure you have
a clear view through all the windows
bef ore driving. 1.
2.
1.
2.
3.
On models with Navigation System
Climat e Cont rol
T o Cool or Heat A utomatically
Using A utomatic Climate Control
T o Remove Exterior Frost or Ice
From the Windows
Features
125

Playing the AM/FM Radio
Features
127
PRESET BUTTONSTUNE/SOUND
KNOB
AM/FM
BUTTON
SAT RADIO
BUTTON
SEEK
BUTTONS
VOL/PWR KNOB
SCAN
BUTTON
TUNE/SOUND
KNOB
PRESET BUTTONS VOL/PWR KNOB
SCAN
BUTTON FM
BUTTON
SEEK
BUTTONS
AM BUTTON
AUTO
SELECT
BUTTON AUTO
SELECT
BUTTON
U.S. Models (with Navigation System)
Canadian Models (without Navigation System)

µ´µ
µ
µ The SEEK f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press the or SEEK button, then
release it.
The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button, or
touch the SCAN icon (models with
navigation system), then release it.
You will see SCAN in the display.
The system will scan f or a station
with a strong signal. When it f inds
one, it will stop and play that station
f or about 5 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 5 seconds. When it plays a
station you want to listen to, press
the SCAN button again.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button (AM or FM button on
Canadian model). On the FM band,
ST will be displayed if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
You can use any of f ive methods to
f ind radio stations on the selected
band:
the
preset buttons, and .
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
VOL/PWR knob or the AM/FM
button (AM or FM button on
Canadian model). Adjust the volume
by turning the same knob. The audio system f or your vehicle
can also be operated using the voice
control system. See Navigation
section in your Quick Start Guide f or
an overview of this system and the
Navigation System manual f or
complete details.
Only on models equipped with
Navigation System
Playing the AM/FM Radio
SEEK
SCAN
To Select a Station
TUNE,SEEK,SCAN, AUTO SELECT
TUNE
To Play the AM/FM Radio Voice Control System
128

µµEach of the six preset
buttons or preset icons (on models
with navigation system) can store
one f requency on AM (LW, MW)
and two f requencies on FM.
Usethetune,seek,orscan
function to tune the radio to a
desired station.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM. If you are
traveling far from home and can no
longer receive your preset stations,
you can use the auto select feature to
find stations in the local area.
Press the A. SEL button or the
AUTO SELECT icon (models with
navigation system). ‘‘A.SEL’’ (AUTO
SEL) f lashes in the display, and the
system goes into scan mode f or
several seconds. It stores the
f requencies of six AM, and twelve
FM stations in the preset buttons. press the
A.SEL button (AUTO SELECT icon).
This restores the presets you
originally set.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button (icon).
Pick a preset button (icon), and
hold it until you hear a beep.
You will see a ‘‘0’’ displayed or see no
station number on the preset icons
af ter pressing a preset button (icon)
if auto select cannot f ind a strong
station f or every preset button. If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons (icons). Use the TUNE,
SEEK, or SCAN f unctions to f ind
stations, then store them in the
preset buttons (icons) as previously
described.
1.
2.
3.
4.
To turn of f Auto Select,
CONT INUED
Preset A UT O SEL ECT
Playing the AM/FM Radio
Features
129

Playing the XMSatellite Radio (U.S. Models)
134
TUNE KNOB
SATELLITE
RADIO
BUTTON
AUDIO
BUTTON
SCAN
BUTTON PWR/VOL KNOB PRESET BUTTONS SCAN
ICON
MODE
ICON DISPLAY/
MODE
BUTTON
CATEGORY
BUTTONS
PRESET BUTTONS TUNE KNOB
SCAN
BUTTON SATELLITE
RADIO
BUTTON
DISPLAY/
MODE
BUTTON
CATEGORY
BUTTONS
PWR/VOL KNOB
without Navigation System
with Navigation System

µ
µ Pick the preset button (icon) you
want f or that channel. Press and
hold the button (icon) until you
hear a beep.
Repeat steps 2 and 3 to store the
f irst six channels.
Press the button again.
The other XM band will show.
Store the next six channels using
steps 2 and 3.
Once a channel is stored, simply
press and release the proper preset
button (icon) to tune to it.
Youcanstoreupto12
preset channels using the six preset
buttons or preset icons (on models
with navigation system). Each button
stores one channel f rom the XM1
band and one channel f rom the XM2
band.
To store a channel: Press the button. Either
XM1 or XM2 will show in the
display.
Use the TUNE knob, or the
CATEGORY or SCAN buttons to
tune to a desired channel.
In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.
The SCAN f unction gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the stations within that
category are scanned. To activate
SCAN, press the SCAN button or
touch the SCAN icon on the audio
display (models with navigation
system). The system plays each
channel in numerical order f or 5
seconds, then selects the next
channel. When you hear a channel
you want to continue listening to,
press the button or touch the icon
again. 1.
2.3.
4.
5.
Playing the XMSatellite Radio (U.S. Models)
Preset
SCAN
136

´´
µ
µ
Playing Discs
140
DISC
BUTTON LOAD
BUTTON
SEEK
BUTTONS
EJECT
BUTTON
SEEK
BUTTONS DISC
SLOT
DISC BUTTON
DISC BUTTON
RANDOM BUTTON
DISC BUTTON
RANDOM BUTTON REPEAT BUTTON
SCAN BUTTON DISC
SLOT
CD/DVD BUTTON
U.S. Models (with Navigation System)
Canadian Models (without Navigation System)
REPEAT
BUTTON SCAN
BUTTON LOAD
BUTTON DISC/TAPE
BUTTON AM/FM
BUTTON
PWR/VOL
KNOB PWR/VOL
KNOB
EJECT
BUTTON AM
BUTTON
FM
BUTTON

µ´µ´
µ
µ
´
Select the disc changer by pressing
the DISC/TAPE button (U.S.
models) or CD/DVD button
(Canadian models). The system will
begin playing the last selected disc in
the disc changer. You will see the
disc and track numbers displayed.
To select a dif f erent disc when all six
positions are loaded, use the preset 5
(DISC ) or preset 6 (DISC )
button. Otherwise, press the
corresponding number on the preset
buttons or icons. On models with
navigation system, you can also
touch the appropriate disc icon (1
6) to select a dif f erent disc.
WhenyoupressandholdtheSCAN
button until you see D-SCAN in the
display, or when you touch the DISC
SCAN icon on the audio display
(models with navigation system), the
f irst track of the current disc plays
f or about 10 seconds. You will see D-
SCAN (DISC SCAN) in the display.
To hear the rest of the disc, press
the SCAN button or touch DISC
SCAN again, within 10 seconds. If
you don’t, the system advances to
the next disc, plays about 10 seconds
of it, and continues throughout the
rest of the discs the same way.
When the system reaches the last
disc, DISC SCAN is cancelled, and
the disc you originally had on plays
normally.
Each time you press and release the
SEEK button, the player skips
f orward to the beginning of the next
track. Press and release the SEEK
buttontoskipbackwardtothe
beginning of the current track or to
skip back to previous track.
When you press the SCAN button or
touchtheTRACKSCANicononthe
audio display (models with
navigation system), the f irst track of
the current disc plays f or about 10
seconds. You will see SCAN
(TRACK SCAN) highlighted in the
display. To hear the rest of the track,
press the SCAN button or touch
TRACK SCAN again within 10
seconds. If you don’t, the system
advances to the next track, plays
about 10 seconds of it, and continues
through the rest of the tracks the
same way.
The preset 5 (DISC ) and preset 6
(DISC ) buttons are f or use with
an optional, external CD changer. T o Play a Disc
T o Change T racks Disc Scan
Track Scan
Playing Discs
Features
142

Playing a T ape
147
DOLBY BUTTON
CD/DVD BUTTON
REWIND BUTTON
PLAY/PROGRAM BUTTON Canadian Models (without Navigation System)
U.S. Models (with Navigation System)
FAST FORWARD BUTTON FAST FORWARD BUTTON
DOLBY BUTTON SEEK
BUTTONS EJECT
BUTTON
REWIND BUTTON
PLAY/PROGRAM BUTTON REPEAT
BUTTON PWR/VOL
KNOB DISC/TAPE
BUTTON AM/FM
BUTTON PWR/VOL
KNOB FM
BUTTON
REPEAT
BUTTON
AM
BUTTON
EJECT
BUTTON
SEEK
BUTTONS
TAPE BUTTON