width Acura TL 2006 Owner's Manual

µµÎ
Î
Î
Î
Specif ications
270
Dimensions
Weights
Capacities Capacities
Air Conditioning 186.2 in (4,730 mm)
72.2 in (1,835 mm)
56.7 in (1,441 mm)
107.9 in (2,740 mm)
62.1 in (1,577 mm)
62.0 in (1,576 mm)
HFC-134a (R-134a)
17.6 19.4 oz (500 550 g) ND-OIL8
2.6 US qt (2.5
)
7.6 US qt (7.2
)
3.1 US qt (2.9)
5.3 US qt (5.0)
4.2 US qt (4.0
)
4.5 US qt (4.3
)
0.16 US gal (0.6
)
2.3 US qt (2.2
)
2.6 US qt (2.5)
4.8 US qt (4.5
)
2.14 US gal (8.1
)
2.09 US gal (7.9)
1.66 US gal (6.3
)
1.69 US gal (6.4)
Length
Width
Height
Wheelbase
Track
Gross vehicle weight rating
Fuel tank Engine
coolant
Engine oil
Automatic
transmission
fluid
Manual
transmission
fluid
Windshield
washer
reservoir
Refrigerant type
Charge quantity
Lubricant type
See the certification label attached
to the driver’s doorjamb.
Excluding the oil remaining in the engine Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity:
Approx.
Front
Rear
1:
2:Change
Manual
Automatic
Total Manual
Automatic
Change Including
filter
Without
filter
Total
Change
Total
Change
Total
U.S. Vehicle
Canada Vehicle
1
2
17.1 US gal (64.7)

µ
The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
Quality grades can be f ound where
applicable on the tire sidewall
between the tread shoulder and the
maximum section width. For
example:
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades. The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices, and dif f erences in
road characteristics and climate.
The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
DOT Tire Quality Grading (U.S. Cars)
Unif orm T ire Quality Grading
T readwear 200
Traction AA
Temperature A Treadwear
Traction AA, A, B, C
272

µµ
µ
µ µ
µ
µ
µ
µ
µ
µ
µ
Warning: The temperature grade f or
this tire is established f or a tire that
is properly inf lated and not
overloaded. Excessive speed,
underinf lation, or excessive loading, either separately or in combination,
can cause heat buildup and possible
tire f ailure.
Speed symbol (an
alphabetical code indicating
the maximum speed rating). Load index (a numerical code
associated with the maximum
load the tire can carry). Rim diameter in inches. Tire construction code (R
indicates radial).
Whenever tires are replaced, they
should be replaced with tires of the
same size. Following is an example
of tire size with an explanation of
what each component means. Aspect ratio (the tire’s section
height as a percentage of its
width). Tire width in millimeters. Vehicletype(Pindicates
passenger vehicle).
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
The temperature grades are A (the
highest), B, and C, representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled
conditions on a specif ied indoor
laboratory test wheel. Sustained high
temperature can cause the material
of the tire to degenerate and reduce
tire life, and excessive temperature
can lead to sudden tire f ailure. The
grade C corresponds to a level of
perf ormance, which all passenger
vehicle tires must meet under the
Federal Motor Vehicle Saf ety
Standard No. 109 and No. 139.
Grades B and A represent higher
levels of perf ormance on the
laboratory test wheel than the
minimum required by law. The tire identif ication number (TIN)
is a group of numbers and letters
that look like the f ollowing example
TIN.
Date of manuf acture. Tire type code. Manuf acturer’s
identification mark. This indicates that the tire
meets all requirements of
the U.S. Department of
Transportation.
P R
DOT
2202
235
45 17
93
W
OBGN
PVC
Temperature A,B,C
Tire Labeling
DOT Tire Quality Grading (U.S. Vehicles), Tire L abeling
T ire Ident if icat ion Number
Tire Size
Technical Inf ormation
273
DOT OBGN PVC 2202
P235/45R17 93W