ignition Acura TL 2008 User Guide

The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.If this indicator comes on when the
ignition switch is turned to the ON
(II) position and the parking brake is
released, it means there is a problem
in the circuit. Have your vehicle
checked by your dealer.
This indicator comes on with the
high beam headlights. See page
f or inf ormation on the headlight
controls. This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. This indicator
will also come on when the light
switch is in AUTO and the lights
turn on automatically. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning of f the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash. 86
298
Turn Signal and
Hazard Warning
Indicators
Lights On Indicator
High Beam Indicator
Daytime Running L ights
Indicator
Instrument Panel Indicators
62
\f—\f—
y
\f\f\fy
(%\fy\f\fy
2008 TL

This indicator comes on brief ly when
you turn the ignition switch to the
ON (II) position. It will then go of f if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine’s f uel system will be
disabled (see page ).This indicator comes on when you
turn on the fog lights. See page
f or inf ormation on f og light
operation.
You will also see a ‘‘FUEL LOW’’
message on the multi-inf ormation
display (see page ).
This indicator also blinks several
times when you turn the ignition
switch f rom the ON (II) position to
the ACCESSORY (I) or LOCK (0)
position.
This indicator is in the f uel gauge. It
comesonasareminderthatyou
must ref uel soon. When the indicator
comes on, there is about 2.3 U.S. gal
(8.6
) of f uel remaining in the tank
bef ore the needle reaches E. There
is a small reserve of f uel remaining
in the tank when the needle does
reach E.
68 86
94
Immobilizer System
Indicator
L ow Fuel Indicator Fog L ight Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
63
LOW FUEL INDICATOR
\f—\f—
y
\f\fy
(%\fy\f\fy
2008 TL

This indicator comes on when there
is a system message on the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two f unctions:
If this indicator begins to f lash,
there is a problem with the tire
pressure monitoring system
(TPMS). You will also see a
‘‘CHECK TPMS SYSTEM’’
message on the multi-inf ormation
display. The indicator continues to
f lash f or a while (approximately 1
minute), then stays on. If this
happens, have your dealer check
the system as soon as possible.
For more inf ormation, see page.
If this happens, pull to the side of the
road when it is saf e, check which tire
has lost the pressure on the multi-
inf ormation display, and determine
the cause. If it is because of a flat tire,
replace the flat tire with the compact
spare (see page ), and have the
f lat tire repaired as soon as possible.
If two or more tires are underinf lated,
call a prof essional towing service.
For more inf ormation, see page .
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are signif icantly low
on pressure.
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the
multi-inf ormation display (see
page ).
Check the tire pressure monitor
on the multi-information display
and determine the cause (see page
). 66
68
1.
2.
275 319
272
274
273 Message Indicator
Low Tire Pressure/
TPMS Indicator
Instrument Panel Indicators
64
\f—\f—
y
\f\fy
(%\fy\f\fy
2008 TL

This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
may rise to the upper zone. If it
reaches the red (hot) mark, pull
safely to the side of the road. Turn to
page f or instructions and
precautions on checking the engine’s
cooling system.
This shows how much f uel you have.
It may show slightly more or less
than the actual amount. Driving
uphill or making turns can cause the
needle to f luctuate or the low f uel
indicator to come on early. The
needle returns to the bottom after
you turn of f the ignition.328
Temperature Gauge
Fuel Gauge
Gauges
Inst rument s and Cont rols
65
TEMPERATURE GAUGE
TACHOMETER SPEEDOMETER
FUEL GAUGE
Avoid driving with an extremely low f uel level. Running out of f uel could cause
the engine to misf ire, damaging the catalytic converter.
\f—\f—
y
\f
\fy
(%\fy\f\f\fy
2008 TL

ÛÝÛÝ
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display.
To change the display, press the
INFO( / )buttononthesteering
wheel repeatedly until the main
menu appears (see page ).With the ignition switch in the ON
(II) position, the multi-inf ormation
display changes as shown on page
each time you press the INFO
( / ) button or SEL/RESET
button.
When you turn the ignition switch to
the ON (II) position, what you last
selected is displayed.
In the multi-information display, the
system message is also displayed
(see page ) and you can
customize your vehicle control
settings (see page ).
69 69
6877
Multi-Inf ormation Display
66
SEL/RESET
BUTTON
INFO BUTTONS
\f—\f—
y
\f

y
(%\fy\f\f
y
2008 TL

When the main menu is ‘‘Keyless
Memory Settings ,’’ you can
customize some of the vehicle
control settings to your pref erence.To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park (A/T) or the parking brake set
(M/T).You can customize some vehicle
control settings f or ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately. If ‘‘DRIVER
1’’ or ‘‘DRIVER 2’’ is not displayed,
customizing is not possible.
Multi-Inf ormation Display
K eyless Memory Settings
76
AT model
MT model
TM
TM
\f—\f—
y
\fy
(%\fy\f\f
y
2008 TL

Ý
ÝÝ
Auto Door Unlock
On models with automatic transmission On models with manual transmission
Select the desired condition by
moving the pointer with the INFO
( ) button and enter your selection
by pressing the SEL/RESET button.
To designate the door(s) that unlock
under the previous step, select
‘‘DRVR DR’’ or ‘‘ALL DRS’’ by
moving the pointer with the INFO
( ) button and enter your selection
by pressing the SEL/RESET button.Select the condition and door(s) to
unlock by moving the pointer with
INFO ( ) button and enter your
selection by pressing the SEL/
RESET button.
There are f ive possible settings f or
automatic transmission models and
three possible settings f or manual
transmission models.
SHIFT TO P: The driver’s door or all
doors depending on your selection in
the next step, will unlock whenever
you move the shif t lever to P
(Models with automatic
transmission).
IGN OFF: The driver’s door or all
doors unlock when you turn the
ignition switch to the LOCK (0)
position.
OFF: The auto door unlock is
deactivated all the time.
Multi-Inf ormation Display
80
(AT) (MT)
\f—\f—
y
\f\f\fy
(%\fy\f\fy
2008 TL

µµ
µ
Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Turn Signal
Of f
Parking and instrument panel
AUTO
Headlights on
Fog lights of f
Fog lights on
High beams
Flashhighbeams When the light switch is in either of
these positions, the lights on
indicator comes on as a reminder.
This indicator stays on if you leave
the lights on and turn the ignition
switch to the ACCESSORY (I) or
LOCK (0) position.
To switch f rom low
beams to high beams, push the lef t
lever f orward until you hear a click.
The blue high beam indicator will
come on (see page ). Pull it back
to return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beamsstayonaslongasyouhold
the lever back.
Turning the
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the key
removed f rom the ignition switch,
you will hear a reminder chime when
you open the driver’s door.
1.
2.
3.
4.
5.
6.
7.
8.
9. 62
Turn Signal
High Beams
Headlights On
Turn Signals and Headlights
86
\f—\f—
y
\fy
(%\fy\f\f
y
2008 TL

µ
To turn on automatic lighting, turn
the light switch to AUTO at any time.
The lights will come on automatically
when the outside light level becomes
low (at dusk, f or example). The
lights on indicator comes on as a
reminder. The lights and indicator
will turn of f automatically when the
system senses high ambient light.
The lights will remain on when you
turn of f the ignition switch. They will
turn of f automatically when you
remove the key and open the driver’s
door. To turn them on again, either
turn the ignition switch to the ON
(II) position or turn the light switch
to the position. Even with the automatic lighting
f eature turned on, we recommend
thatyouturnonthelightsmanually
when driving at night or in a dense
f og, or when you enter dark areas
such as long tunnels or parking
f acilities.
Do not leave the light switch in
AUTO if you will not be driving the
vehicle f or an extended period (a
weekormore).Youshouldalsoturn
of f the lights if you plan to leave the
engine idling or of f f or a long time. The automatic lighting f eature is
controlledbyasensorlocatedontop
of the dashboard. Do not cover this
sensor or spill liquids on it.
The automatic lighting
f eature turns on the headlights and
all other exterior lights when it
senses low ambient light.
CONT INUED
Turn Signals and Headlights
AUTO
Inst rument s and Cont rols
87
LIGHT SENSOR
\f—\f—
y
\f\fy
(%\fy\f\fy
2008 TL

With the headlight switch off, the
daytime running lights come on
when you turn the ignition switch to
the ON (II) position and release the
parkingbrake.Theyremainonuntil
you turn the ignition of f , even if you
set the parking brake.
This f eature turns of f the headlights,
all other exterior lights, and the
instrument panel lights within 15
seconds after you remove the key
and close the driver’s door.
To change the ‘‘HEADLIGHT AUTO
OFF TIMER’’ setting, see page . If you turn the ignition switch to the
LOCK (0) position with the
headlight switch on, but do not open
the door and get out, the lights turn
of f af ter 10 minutes (3 minutes, if
the switch is in the ‘‘AUTO’’
position).
The lights turn on again when you
unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
go of f . With the driver’s door open,
you will hear a lights-on reminder
chime.
The automatic lighting of f f eature
activates if you leave the headlight
switch in the ‘‘ ’’ or ‘‘ ’’
position or if the lights are turned on
by setting the switch in the ‘‘AUTO’’
position, remove the key, then open
and close the driver’s door. 82
Automatic Lighting Of f Feature Daytime Running Lights
Turn Signals and Headlights
88
\f—\f—
y
\fy
(%\fy\f\fy
2008 TL