reset Acura TL 2010 Owner's Manual

Î
Î
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash. This indicator normally comes on
when you turn the ignition switch to
the ON (II) position and goes of f
af ter the engine starts. If it comes on
at any other time, there is a problem
in the electric power steering system.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. ON Mode
is the equivalent of ON (II). For
more inf ormation, see pagesand . If this happens, stop the vehicle in a
saf e place and turn of f the engine.
Reset the system by restarting the
engine. The indicator will stay on,
but should go of f af ter driving a
short distance. If it does not go of f ,
or comes back on again while driving,
take the vehicle to your dealer to
have it checked. With the indicator
on, the EPS may be turned of f ,
making the vehicle harder to steer.
If you turn the steering wheel to the
f ull lef t or right position repeatedly
while stopping or driving at very low
speed, you may f eel slightly harder
steering in order to prevent damage
to the steering box caused by
overheating.
You will also see a ‘‘CHECK POWER
STEERING SYSTEM’’ message on
the multi-information display.
:
181
178
524 528
Instrument Panel Indicators
Turn Signal and
Hazard Warning
Indicators
Electric Power Steering
(EPS) Indicator
70
09/07/29 16:54:18 31TK4610_075
2010 TL

ÎÎ
Î
ÛÝ
Î
ÛÝ
These messages go of f af ter several
seconds.
With the ignition switch in the ON
(II) position, the multi-inf ormation
display changes as shown on pageeach time you press the INFO
( / ) button or the SEL/RESET
button.
When you turn the ignition switch
to the ON (II) position, your last
selection is displayed.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. ON Mode
is the equivalent of ON (II). For
more inf ormation, see pages
and .
If you do not f asten your seat belt,
you will also see a ‘‘FASTEN SEAT
BELT’’ message on the multi-
inf ormation display when you turn
the ignition switch to the ON (II)
position.
These messages go of f several
seconds af ter the key is inserted into
the ignition switch. 80
:
178 181
On models with keyless access system
Multi-Inf ormation Display
78
SEL/RESET BUTTON
INFO BUTTONS ( / )
A/T model is shown.
09/07/29 16:55:36 31TK4610_083
2010 TL

ÛÝ
Î
ÎÎ Î
Multi-Inf ormation Display
80
U.S. model is shown.
: Press the INFO button ( / ).
: Press the SEL/RESET button.
1:
2 : SH-AWD models only Odometer (See page
81.)
Trip Meter (See page 81.)
Trip Computer (See page 82.) Engine Oil Life
(See page
84.)
Tire Pressure for each tire (See page 85.)
HFL (See page 86.) Outside Temperature (See page
84.)
SH-AWD Torque Distribution Monitor
(See page 85.)
Keyless Memory Settings (See page 92.)
On models without navigation system only
This display will be shown when theBluetoothHandsFreeLinkis activated.
1 2
TM
09/07/29 16:55:54 31TK4610_085
2010 TL

The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial/
territorial regulations to disconnect,
reset, or alter the odometer with the
intent to change the number of miles
or kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, and
then press and hold the SEL/RESET
button until the number resets to
‘‘0.0.’’When you reset Trip A, average f uel
economy A, average vehicle speed A,
and elapsed time A are reset at the
same time. When you reset Trip B,
average fuel economy B, average
vehicle speed B, and elapsed time B
are reset.
In the customizing mode, you can set
Trip A and average f uel economy A
to reset at the same time when you
ref uel your vehicle (see page ).
102
CONT INUED
Multi-Inf ormation Display
Odometer T rip Meter
Inst rument s and Cont rols
81
TRIP METER A
Canada
U.S. U.S.
Canada
TRIP METER B
ODOMETER
09/07/29 16:56:06 31TK4610_086
2010 TL

ÛÝ
Along with the trip meter, the trip
computer calculates these values:Average Fuel Economy
Average Vehicle Speed
Instant Fuel Economy Elapsed Time
Range
Trip Computer
Multi-Inf ormation Display
82
: Press the INFO button ( / ).
: Press the SEL/RESET button.
U.S. model is shown. Go to SH-AWD monitor (if equipped) or tire
pressure monitor. See page
80for how to
switch the main menu display.
09/07/29 16:56:17 31TK4610_087
2010 TL

Î
ÎThis shows your instant f uel
economy.
This shows the time passed traveled
since you last reset it. When you turn
the ignition switch to the ON (II)
position, ELAPSED TIME A or B is
reset.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. ON Mode
is the equivalent of ON (II). For
more inf ormation, see pagesand .
This shows your vehicle’s average
f uel economy in mpg (U.S. models)
or liter/100 km (Canadian models)
since you last reset Trip A or Trip B.
You can customize the Trip A and
AVG. FUEL A reset condition on the
multi-inf ormation display (see page
).
This shows the average speed you
are traveling in miles per hour (mph)
forU.S.modelsorkilometersper
hour (km/h) f or Canadian models. This shows the estimated distance
you can travel on the fuel remaining
in the f uel tank. This distance is
estimated f rom the f uel economy
you received over the last several
miles (U.S.) or kilometers (Canada),
so it will vary with changes in speed,
traf f ic, etc.
:
178
102
181
INST . MPG (U.S. models)/INST . L /100 km (Canadian models)
EL A PSED T IME A /B
AVG. FUEL A/B
A VG. SPEED A /B RANGE
Multi-Inf ormation Display
Inst rument s and Cont rols
83
09/07/29 16:56:29 31TK4610_088
2010 TL

This shows the outside Fahrenheit
temperature in U.S. models, and
Celsius temperature in Canadian
models.In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
You can adjust the outside
temperature display (see page ). The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
This shows the remaining engine oil
lif e. It shows 100% af ter the engine
oil is replaced and the display is reset.
The engine oil lif e is calculated
based on engine operating conditions.
For more inf ormation, see page .
101 497
Multi-Inf ormation Display
Outside Temperature
Engine Oil Lif e
84
OUTSIDE TEMPERATURE ENGINE OIL LIFE
U.S. CANADA
U.S. model is shown.
09/07/29 16:56:39 31TK4610_089
2010 TL

ÛÝRef er to the table on the f ollowing
pages about the settings you want to
customize.
If you want to change any vehicle
control settings, select Keyless
Memory Settings by pressing
either INFO button ( / ), then
press the SEL/RESET button. Select
CHG SETTING, then press the
SEL/RESET button.
If you use the key to unlock the
driver’s door, the system cannot
recognize either ‘‘DRIVER 1’’ or
‘‘DRIVER 2.’’
CONT INUED
On models without keyless access
system
Multi-Inf ormation Display
Inst rument s and Cont rols
93
DRIVER’S ID
Press the SEL/RESET
button.
U.S. model is shown.
TM
09/07/29 16:58:21 31TK4610_098
2010 TL

ÎÎ
ÎÎÎ
Î
Î
Î
Î
µ™¶ ™
µ™¶ ™
Î
Î LOW
MIN
OFF
LANGUAGE SELECT ION
ADJUST OUTSIDE
TEMP. DISPLAY
TRIP COMPUTER TRIP A
INFO RESET
ADJUST ALARM VOLUME
AUTO INTERIOR
ILLUMINATION
KEYLESS START GUIDANCE
SCREENS
MEMORY POSIT ION LINK
MET ER SET UP
(P.99)
POSITION SETUP
(P.108) 100
101
102
104
105
106
109
ENGLISH
FRENCH
SPANISH
5°F 0°F 5°F
(U.S.) 3°C 0°C 3°C
(Canada)
WITH REFUEL
MANUAL ONLY
IGN OFF
HIGH
MID
LOW
MAX
HIGH
MID
ON
OFF
ON
OFF
Changes the language used in the display.
Changes the outside temperature reading above or
below its current reading.
Causes trip meter A and the average fuel economy
to reset when you refuel.
Changes the indicator alarm volumes into three
levels.
Changes the interior light sensitivity to your liking.
Changes the display of the keyless start guidance
screens.
Changes the driver’s seat and the outside mirror
positions to a stored setting.
1:
2: Default setting
Only on models with keyless access system
Menu Item
Group Setup Page
Setting Option
Description
2 1
111
1
1
1
1
Multi-Inf ormation Display
94
09/07/29 16:58:28 31TK4610_099
2010 TL

ÛÝÛ
Ý
ÛÝ
Î
Î
You can customize some of the
vehicle control settings to your
pref erence. Here are the settings
you can customize: METER SETUP
When you want to change the
vehicle control settings, press the
INFO ( / ) button to select CHG
SETTING, then press the SEL/
RESET button. Each time you press the INFO ( /
) button, the screen changes as
shownonthenextpage.Pressthe
INFO( / )buttonuntilyousee
the setup you want to customize,
then press the SEL/RESET button
to enter your selection.
If you do not make any changes,
select ‘‘EXIT.’’ The display returns to
the normal display.
DOOR/WINDOW SETUP LIGHTING SETUP
If you want the settings as they were
when the vehicle lef t the f actory,
select DEFAULT ALL, as described
on page .
POSITION SETUP
KEYLESS ACCESS SETUP
: Only on models with keyless
access system
129
CONT INUED
Customize Settings
Multi-Inf ormation Display
Inst rument s and Cont rols
97
09/07/29 16:58:57 31TK4610_102
2010 TL