ECU Acura TL 2012 Workshop Manual

Acura TL 2012 Workshop Manual TL 2012 Acura Acura https://www.carmanualsonline.info/img/32/11098/w960_11098-0.png Acura TL 2012 Workshop Manual

Page 554 of 650

Acura TL 2012 Workshop Manual Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
If the level is below the lower
mark, add f luid into the dipstick
hole to bring it to the level
betwe

Page 556 of 650

Acura TL 2012 Workshop Manual The transmission should be drained
and ref illed with new f luid according
to the Maintenance Minder (see
page ).
If you are not sure how to check and
add f luid, contact your dealer.
Reinstall the un

Page 560 of 650

Acura TL 2012 Workshop Manual Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Remove the electrical connector
f rom the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb b

Page 562 of 650

Acura TL 2012 Workshop Manual Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.Start the engine. If you are
replacing a driver’s side bulb, turn
the steering wheel all the way to
the

Page 564 of 650

Acura TL 2012 Workshop Manual Your vehicle uses halogen light
bulbs. When replacing a bulb, handle
it by its plastic case, and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with de

Page 566 of 650

Acura TL 2012 Workshop Manual Remove the nuts f rom the stud
bolts with a socket or wrench.
Open the trunk.
Remove the screw in the center of
theholdingcliponthesideof the
trunk lining. Pull the lining back.
Insert the new bulb in

Page 590 of 650

Acura TL 2012 Workshop Manual Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to:
Remove the center cap before
s

Page 591 of 650

Acura TL 2012 Workshop Manual Store the center cap in the trunk.
Make sure it does not get
scratched or damaged. Store the jack and tools in the tool
kit case. Place the tool kit case in
the f lat tire.
To remove the spacer cone,

Page 608 of 650

Acura TL 2012 Workshop Manual µ
µ
µ
µ
µ
µ
µ
µµ
µ
µ
µ
µ
µ
µ
µ µ
µ
µ
Î
Î
Î
Î
Î
Î
Î
Î
Î Î
No.
Circuits Protected
No.
Amps. Amps.
Circuits Protected Amps.
No. Circuits Protecte

Page 645 of 650

Acura TL 2012 Workshop Manual Î
Recommended Shif t................................
Speeds .492, 503
........................................
Ref ueling .470
.......................
Reminder Indicators .64
Remote, Keyless Access
Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60