bulb Acura TSX 2005 Owner's Manual
[x] Cancel search | Manufacturer: ACURA, Model Year: 2005, Model line: TSX, Model: Acura TSX 2005Pages: 288, PDF Size: 4.14 MB
Page 58 of 288

The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicators do not blink,
or if they blink rapidly, it usually
means one of the turn signal bulbs is
burned out (see pages and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
WhenyouturnontheHazard
Warning button, both turn signal
indicators blink. All turn signals on
the outside of the vehicle should
flash.This indicator comes on as a
reminder that you must ref uel soon.
This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. This indicator
will also come on when the light
switch is in AUTO and the lights
turn on automatically. If you turn the
ignition switch to ACCESSORY (I)
or LOCK (0) without turning of f the
light switch, this indicator will
remain on. A reminder chime will
also sound when you open the driver’s
door.
217 219
Turn Signal and
Hazard Warning
Indicators
Lights On Indicator Low Fuel Indicator
Instrument Panel L ights
Inst rument s and Cont rols
57
LOW FUEL INDICATOR
Page 216 of 288

Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
trunk or pull a trailer, readjustment
may be required. Adjustments
should be perf ormed by your dealer
or other qualif ied mechanic.
The low beam headlight bulbs are a
type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch of f
and the key removed. Because of
this, you should not attempt to
examine or change a low beam
headlight bulb yourself . If a low
beam headlight bulb fails, take the
vehicle to your dealer to have it
replaced.Your vehicle has two bulbs on each
side, f our in total. Make sure you are
replacing the bulb that is burned out.
Your vehicle uses halogen headlight
bulbs. When replacing a bulb, handle
it by its plastic case and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with denatured alcohol and a
clean cloth.
CONT INUED
Headlight A iming
L ow Beam Headlight Bulb
Replacement
Replacing a High Beam Headlight
Bulb
Lights
Maint enance
215
NOTE:
Halogen headlight bulbs get
very hot when lit. Oil, perspiration, or a
scratch on the glass can cause the bulb
to overheat and shatter.
Page 217 of 288

Open the hood. To change a bulb
on the driver’s side, undo the
three fasteners and remove the air
intake cover.Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way and remove the bulb.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber weather seal
over the back of the headlight
assembly.Makesureitisright
side up; it is marked with an arrow.
1. 2.
3.6. 4.
5.
Lights
216
FASTENER
AIR INTAKE COVER
HOLD-DOWN WIREBULB
CONNECTOR
RUBBER WEATHER SEAL
Page 218 of 288

Open the hood.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to test the new
bulb.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Turn on the headlights to test the
new bulb.
On the driver’s side, reinstall the
air intake cover. Reinstall the
three fasteners and secure them
by pushing on the heads until they
lock. 3.
4.
5.
2. 1.
7.
8.
9.
Replacing the Front Side Marker/
Turn Signal Light Bulb
Lights
Maint enance
217
SOCKET
Page 219 of 288

To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, and turn of f the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
lef t.Use a f lat-tipped screwdriver to
remove the two holding clips f rom
the inner f ender.
Pull the inner f ender cover away
f rom the f ender and bumper.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
4. 5.
2.
1.
3.
Replacing a Front Parking L ight
Bulb
Lights
218
HOLDING CLIPS
Page 220 of 288

Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to test the new
bulb.
Put the inner f ender cover in place.
Install and lock each holding clip
bypushingonthecenter.Open the trunk.
Remove the light assembly cover
by pulling its outside edge.
Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.Push a new bulb straight into the
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Test the new bulb to make sure it
works.
Reinstall the light assembly cover.
1.
3. 2.
6.
7.
8.
4.
5.
6.
Lights
Replacing Rear Bulbs
(in Fenders)
Maint enance
219
COVER
Page 221 of 288

Open the trunk.
To replace a bulb on the lef t side,
remove the two trim clips. On the
right side, remove a trim clip.
Pull the lining back caref ully.Determine which of the two bulbs
is burned out: taillight or back-up
light.Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
1.
2. 5.
6.
4.
3. Replacing Rear Bulbs
(in T runk L id)
Lights
220
TRIM CLIPS SOCKETSBULBS
Page 222 of 288

Reinstall the trunk lid trim. Make
sure it is installed under the edge
of the trunk lid seal.
Press the trim clips back into their
holes.
Insert the socket back into the
light assembly. Turn it clockwise
to lock it in place.
Turn on the lights to test the new
bulb.
Open the trunk and remove the
socket f rom the light assembly by
turning it one-quarter turn counter-
clockwise.
Remove the burned-out bulb by
pulling it straight out of the socket.
Install the new bulb and reinstall
the socket. Make sure the new
bulb is working.
7.
8.
9.
10.
1.
2.
3.
Lights
Replacing a High-mount Brake
Light Bulb
Maint enance
221
Page 223 of 288

Each outside mirror has side turn
signal lights. The lights should be
replaced by your Acura dealer.The license plate has two lights
above it. The bulbs should be
replaced by your Acura dealer.
Lights
Side T urn Signal L ight
Rear L icense Plate Bulb
222
Page 280 of 288

CONT INUED
....................................
Accessories .160
ACCESSORY (Ignition Key .......................................
Position) .73
...............
Accessory Power Socket . 97
....................
Additives, Engine Oil . 202
...................................
Airbag (SRS) .11
..........
Airbag System Components . 23
............................
Air Conditioning .103
.........................................
Usage .105
.......................
Air Pressure, Tires .227
Anti-lock Brakes (ABS) ...............................
Indicator .55, 179
...................................
Operation .179
.
Anti-thef t Steering Column Lock . 73
........
Audio System . 112,120,128,133
.............
Automatic Speed Control . 143
..............
Automatic Transmission . 170
..........................
Capacity, Fluid .262
....
Sequential SportShif t Mode . 172
.......................................
Shif ting .170
.
Shif t Lever Position Indicator . 170
................
Shif t Lever Positions . 170
....................
Shif t Lock Release . 175Battery
Charging System ...........................
Indicator .54, 248
............................
Jump Starting .243
..............................
Maintenance .232
............................
Specif ications .263
..............................
Bef ore Driving .151
........................................
Belts, Seat .10
Brakes ...........
Anti-lock System (ABS) . 179
.............
Break-in, New Linings . 152
....................
Bulb Replacement .219
...........................................
Fluid .212
.........................................
Parking .93
.........................
System Indicator .54
........................
Wear Indicators .178
.............................
Braking System .178
........................
Break-in, New Car .152
..
Brightness Control, Instruments . 68
........................
Brights, Headlights .66
Bulb Replacement ..............................
Brake Lights .219
................
Front Parking Lights . 217
.................................
Headlights .215 .........
High-mount Brake Light . 221
............................
Specif ications .263
............
Turn Signal Lights . 217,219
..............................
Bulbs, Halogen .215
............................
Capacities Chart .262
.............
Carbon Monoxide Hazard . 48
.............................
Carrying Cargo .162
..............
CAUTION, Explanation of . ii
...................................
CD Changer .122
.......................................
CD Player .120
..........................
CD Pocket, Center .96
........................
Certif ication Label .260
............................................
Chains .231
....................
Changing a Flat Tire .237
Changing Oil ........................................
How to .204
.............................
When to .193, 195
...
Charging System Indicator . 54,248
............
Checklist, Bef ore Driving . 166
..................
Childproof Door Locks . 76
Index
AB
C
INDEX
I