clock Acura TSX 2010 User Guide

Acura TSX 2010 User Guide TSX 2010 Acura Acura https://www.carmanualsonline.info/img/32/11143/w960_11143-0.png Acura TSX 2010 User Guide

Page 292 of 524

Acura TSX 2010 User Guide To set the time, press the CLOCK
button until you hear a beep. The
displayed time begins to blink.
Change the hours by pressing the H
(hour) button until the numbers
advance to the desired time. Chang

Page 293 of 524

Acura TSX 2010 User Guide Ú
Turn the selector knob to select
‘‘CLOCK ADJUST.’’
Press the selector knob (ENTER)
to enter your selection. The
display changes to the clock
adjusting display. Turn the selector knob to se

Page 294 of 524

Acura TSX 2010 User Guide While setting the clock, pressing
the RETURN button will go back
to the previous display.
Pressing the MENU button again
will cancel this setting mode.
Turn the selector knob to change
the setting bet

Page 295 of 524

Acura TSX 2010 User Guide Once the security system is set,
opening any door (without using the
key or the remote transmitter), the
hood, or the trunk will cause the
alarm to activate. It will also activate
if the audio unit is

Page 424 of 524

Acura TSX 2010 User Guide CONT INUED
Make sure the engine and radiator
are cool.Remove the radiator cap cover.
Relieve any pressure in the cooling
system by turning the radiator cap
counterclockwise, without
pressing down.
If

Page 425 of 524

Acura TSX 2010 User Guide The coolant level should be up to
the base of the f iller neck. Add
coolant if it is low.
Pourthecoolantslowlyand
caref ully so you do not spill any.
Clean up any spill immediately; it
could damage co

Page 433 of 524

Acura TSX 2010 User Guide To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
lef t, and turn of f the engine. To
change the driver’s side bulb, turn
the steering wheel to the

Page 434 of 524

Acura TSX 2010 User Guide Open the hood.
Insert the new bulb into the hole,
making sure the tabs are in their
slots.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Pivot the hold-down wire

Page 436 of 524

Acura TSX 2010 User Guide Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
n

Page 437 of 524

Acura TSX 2010 User Guide Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
To remove the burned out bulb,
push it in and turn it
counterclockwise until it unlocks.
Use a f lat-tip
Page:   < prev 1-10 11-20 21-30 next >