torque Acura TSX 2011 Owner's Manual

Maintenance Under the Hood
Changing the Engine Oil and Oil Filter
239
Maintenance
6. Check that the filter gasket is not stuck to
the engine contact surface.
If it is stuck, you must detach it.
7. Wipe away dirt and dust adhering to the
contact surface of the engine block, and
install a new oil filter.
8. Put a new washer on the drain bolt, then
reinstall the drain bolt. Tightening torque: 29 lbf∙ft (39 N∙m, 4.0
kgf∙m)
9. Pour the recommended engine oil into the
engine. Engine oil change capacity (including
filter):
4-cylinder models 4.2 US qt (4.0 L) 6-cylinder models

4.5 US qt (4.3 L)
10. Reinstall the engine oil fill cap securely
and start the engine.
11. Run the engine for a few minutes, and
then check that there is no leak from the
drain bolt or oil filter.
12 . Stop the engine, wait for three minutes,
and then check the oil level on the
dipstick.
If necessary, add more engine oil.
Changing the Engine Oil and Oil Filter
You will need a special wrench to replace the oil
filter. You can buy this wrench from a dealer.

When installing the new oil filter follow the
instructions supplied with the oil filter.

Reinstall the engine oil fill cap. Start the engine.
The low oil pressure indicator should go off within
five seconds. If it does not, turn off the engine, and
check your work.
Oil Filter
4-cylinder models 6-cylinder models 6-cylinder models
Oil Filter Drain Bolt
Washer

Maintenance Under the Hood
Transmission Fluid
243
Maintenance
1. Park the vehicle on level ground.
2. Remove the bolts with a wrench, then
carefully remove the under cover.
3. Remove the transmission filler bolt and
washer. Carefully feel inside the bolt hole
with your fingers.
Check if the fluid level is up to the edge
of the bolt hole.
4. If the fluid level is not up to the edge
of the bolt hole, add Acura Manual
Transmission Fluid (MTF) until it runs out of
the hole.
5. Put a new washer on the filler bolt, then
reinstall the filler bolt. Tightening torque: 33 lbf∙ft (44 N∙m,
4.5 kgf∙m)
6. Reinstall the under cover with the bolts.
Manual Transmission Fluid
Check the fluid level when the engine is at normal operating temperature.Specified fluid: Acura Manual Transmission Fluid (MTF)
Manual Transmission Fluid
If Acura MTF is not available, you may use the API
certificated SAE 0W-20 or 5W-20 viscosity motor oil
as a temporary measure.
Replace with MTF as soon as possible. Motor
oil does not contain the proper additives for the
transmission and continued use can cause decreased
shifting performance and lead to transmission
damage. Under Cover
Bolt

If a Tire Goes Flat
Changing a Flat Tire
281
Continued
Handling the Unexpected
Replacing the Flat Tire
1. Remove the wheel nuts and flat tire.2. Wipe the mounting surfaces of the wheel
with a clean cloth.
3. Mount the compact spare tire.
4. Screw the wheel nuts until they touch the
lips around the mounting holes, and stop
rotating.
5. Lower the vehicle and remove the jack.
Tighten the wheel nuts in the order
indicated in the image. Go around,
tightening the nuts, two to three times in
this order.
Wheel nut torque:
80 lbf∙ft (108 N∙m, 11 kgf∙m)
Replacing the Flat Tire
Do not over tighten the wheel nuts by applying
extra torque using your foot or a pipe.