light Acura TSX 2014 Repair Manual

249Continued

Replacing Light Bulbs
Headlight Bulbs
When replacing, use the following bulbs.1.Remove all the engine compartment covers.
2 Engine Compartment Covers * P. 235
2. Remove the engine coolant reservoir.
High beam headlight:60 W (HB3 for halogen bulb type)
Low beam headlight:55 W (H1 for halogen bulb type)
35 W (D2S for high voltage discharge type)
■High Beam Headlight
1Headlight Bulbs
NOTICE
Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to overhe at and shatter.
The headlight aim is set by the factory, and does not
need to be adjusted. Howeve r, if you regularly carry
heavy items in the trunk or tow a trailer, have the
aiming readjusted at a de aler or by a qualified
technician.
When replacing a halogen bulb, handle it by its base,
and protect the glass from c ontact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Engine Coolant Reservoir
4-cylinder models6-cylinder models
Passenger side
All models
6-cylinder models
Engine Coolant Reservoir
* Not available on all models
14 ACURA TSX 4D-31TL16500.book 249 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

uu Replacing Light Bulbs u Headlight Bulbs
250


3. Remove the fasteners, using a flat-tip
screwdriver. Remove the cover of the air
intake duct and its upper part.
3.Remove the fasteners, and remove the air
intake duct cover.
1Headlight Bulbs
The exterior lights’ inside lenses (headlights, brake
lamps, etc.) may fog temporarily after a car wash or
while driving in the rain. This does not impact the
exterior light function.
However, if you see a larg e amount of water or ice
accumulated inside the le nses, have your vehicle
inspected by a dealer.4-cylinder modelsFastener
Cover
Air Intake
Duct
Driver side
4-cylinder models
6-cylinder modelsFastener
Cover6-cylinder models
14 ACURA TSX 4D-31TL16500.book 250 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

251
uu Replacing Light Bulbs u Headlight Bulbs
Continued

4. Remove the coupler.
u It can be removed by pushing the tab.
5. Rotate the old bulb to the left to remove.
6. Insert a new bulb into the headlight
assembly and turn it to the right.
7. Insert the coupler into the connector of
the bulb.
4-cylinder models
BulbCoupler
Tab
6-cylinder models
Bulb
TabCoupler
Driver and passenger side
All models
14 ACURA TSX 4D-31TL16500.book 251 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

uu Replacing Light Bulbs u Headlight Bulbs
252


High voltage can remain in the circuit for a long period of time after the light is
switched off. Do not attemp t to inspect or replace the high voltage discharge type
bulbs yourself. Ask a dealer to insp ect and replace low beam headlights.
1.Turn the steering wheel all the way to
the opposite side from the headlight
being replaced.
Passenger side: Turn the steering wheel
to the left.
Driver side: Turn the steering wheel to
the right.
2. Remove the holding clips and screws, and
pull the inner fender back.
3. Rotate the cover to the left, and remove.
■Low Beam Headlights
■Low Beam Headlights
High Voltage Discharge Types
Halogen Types
1Low Beam Headlights
Insert a flat-tip screwdriver, lift and remove the center
pin to remove the clip.
Inner Fender
Cover
Screw
Clip
14 ACURA TSX 4D-31TL16500.book 252 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

Continued253
uu Replacing Light Bulbs u Fog Light Bulbs

4. Unhook the hook, and pull out
the connector.
5. Remove the old bulb and insert the
new bulb.
6. Put the connector back into the
headlight assembly.
Fog Light Bulbs
When replacing, use the following bulbs.
1.Remove the clips using a flat-tip
screwdriver, and lower the under cover.
1Low Beam Headlights
Insert the clip with the center pin raised, and push
until it is flat.
Push until the
pin is flatHook Bulb
Connector
Fog Light:
55 W
1 Fog Light Bulbs
NOTICE
Halogen bulbs get very hot wh en lit. Oil, perspiration,
or a scratch on the glass can cause the bulb to
overheat and shatter.
The fog lights ar e halogen bulbs.
When replacing a bulb, handl e it by its plastic case,
and protect the glass from c ontact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Clip
Under Cover
14 ACURA TSX 4D-31TL16500.book 253 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

254
uu Replacing Light Bulbs u Front Turn Signal/Parking/Side Marker Light Bulbs


2. Remove the coupler.
u It can be removed by pushing the tab.
3. Rotate the old bulb to the left to remove.
4. Insert a new bulb into the fog light
assembly and turn it to the right.
5. Insert the coupler into the connector of the
bulb.
Front Turn Signal/Parking/Side Marker Light Bulbs
When replacing, use the following bulbs.
Turn the steering wheel and pull the inner fender back in the same way as when
replacing the low beam headlights.
2 Changing the Low Beam Headlight P. 252
1. Turn the socket to the left and remove it.
2. Push in the old bulb, rotate to the left until
it unlocks, and remove.
3. Insert a new bulb.
Bulb
Coupler
Tab
Front Turn Signal/Parking/Side Marker: 21/5W
Socket
Bulb
14 ACURA TSX 4D-31TL16500.book 254 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

255
uu Replacing Light Bulbs u Side Turn Signal/Emergency Indicator Light Bulbs
Continued

Side Turn Signal/Emerge ncy Indicator Light Bulbs
Door mirrors have the side turn lights. Have an authorized Acura dealer inspect and
replace the light bulbs.
Brake Light, Taillight, Rear Turn Signal
Light and
Rear Side Marker Light Bulbs
When replacing, use the following bulbs.
1.Pull out and remove the cover.
Brake/Taillight: 21/5 W
Rear Turn Signal Light: 21 W
Rear Side Marker Light: 3 CP
Cover
14 ACURA TSX 4D-31TL16500.book 255 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

256
uu Replacing Light Bulbs u Back-Up Light Bulbs


2. Turn the socket to the left and remove it.
Remove the old bulb.
3. Remove the old bulb and insert a new bulb.
Back-Up Light Bulbs
When replacing, use the following bulbs.
1.Remove the clip in the trunk using a
flat-tip screwdriver.
2. Pull out the lining.
Back-Up Light: 21 W
Lining
Clip
14 ACURA TSX 4D-31TL16500.book 256 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

257
uu Replacing Light Bulbs u Rear License Plate Light Bulbs

3. Turn the socket to the left and remove.
4. Remove the old bulb and insert the new
bulb.
Rear License Plate Light Bulbs
Have an authorized Acura dealer inspect and replace the light bulbs.
Lining
Clip
Socket Bulb
14 ACURA TSX 4D-31TL16500.book 257 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC

258
uu Replacing Light Bulbs u High-Mount Brake Light Bulbs


High-Mount Brake Light Bulbs
When replacing, use the following bulbs.
1.Open the trunk.
2. Turn the socket to the left and remove it.
3. Remove the old bulb and insert a new bulb.
High-Mount Brake Light: 21 W
Bulb
Socket
14 ACURA TSX 4D-31TL16500.book 258 ページ ２０１３年６月１７日　月曜日　午前９時４０分
QRG
Index
MaintenanceTOC