clutch Alfa Romeo 159 2010 Owner handbook (in English)
[x] Cancel search | Manufacturer: ALFA ROMEO, Model Year: 2010, Model line: 159, Model: Alfa Romeo 159 2010Pages: 331, PDF Size: 4.84 MB
Page 160 of 331
Gear selection
As soon as the conditions of the traffic
and road allow, use a higher gear. Us-
ing a low gear to obtain brilliant perfor-
mance increases consumption. In the
same way improper use of a high gear
increases consumption, emissions an en-
gine wear.
Top speed
Fuel consumption considerably increas-
es with speed. Avoid superfluous brak-
ing and accelerating, which cost in terms
of both fuel and emissions.
Acceleration
Accelerating violently increasing the revs
will greatly affect consumption and emis-
sions: acceleration should be gradual and
should not exceed the maximum torque.CONDITIONS OF USE
Cold starting
Short journeys and frequent cold starts
do not allow the engine to reach opti-
mum operating temperature. This results
in a significant increase in consumption
levels (from +15 to +30% on the urban
cycle) and emission of harmful sub-
stances.
Traffic and road conditions
Rather high consumption levels are tied
to situations with heavy traffic, for ex-
ample in queues with frequent use of
the lower gears or in cities with many
traffic lights. Also winding mountain
roads and rough road surfaces adverse-
ly affect consumption.
Traffic hold-ups
During prolonged hold-ups (e.g.: level
crossings) the engine should be
switched off.
DRIVING STYLE
Starting
Do not warm the engine with the car
at a standstill or at idle or high speed:
under these conditions the engine
warms up much more slowly, increasing
electrical consumption and emissions. It
is therefore advisable to move off im-
mediately, slowly, avoiding high speeds.
This way the engine will warm faster.
Unnecessary actions
Avoid accelerating when waiting at traf-
fic lights or before switching off the en-
gine. This and also double declutching
is absolutely pointless on modern cars
and also increase consumption and pol-
lution.
158
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
CORRECT USE
OF THE CAR
149-164 Alfa 159 GB 8-04-2009 10:51 Pagina 158
Page 227 of 331
35 70 105 140 175
●●●●●
●●●●●
●●●●●
●●●●●
●●●●●
●●●●●
●●●●●
●●●●●
●●●●●
●●●
●●
●
●
SERVICE SCHEDULE
Thousands of km
Check tyre conditions/wear and adjust pressure if required
Check light system operation (headlights, direction indicators, hazard lights,
boot lights, passenger compartment lights, glovebox lights, warning lights, etc.)
Check windscreen wiper/washer operation,adjust nozzles if required
Check windscreen/rear window blade position/wear
Check front disk brake pad conditions and wear and wear indicator operation
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts, underbody protection,
pipes and hoses (exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness
and lubrication
Check and top up, if required, fluid levels (brakes/hydraulic clutch,
power steering, windscreen washer, battery, engine coolant, etc.)
Check and adjust handbrake lever stroke
Sight inspect accessory drive belt conditions (except 1.8 140 HP version)
Sight inspect accessory drive belt conditions (1.8 140 HP version)
Sight inspect timing belt conditions (1.8 140 HP version)
CAR
MAINTENANCE
DASHBOARD
AND
CONTROLS
CORRECT USE
OF THE CAR
INDEX
TECHNICAL
SPECIFICATIONS
IN AN
EMERGENCY
WARNING
LIGHTS AND
MESSAGES
SAFETY
DEVICES
225
223-248 Alfa 159 GB 3-12-2009 14:11 Pagina 225
Page 257 of 331
255
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
TECHNICAL SPECIFICATIONS
FUEL FEED/IGNITION
1.8 140 HP1750 TURBO BENZINA 1.9 JTDM8V
2.2 JTS - 3.2 JTS 1.9 JTDM16v - 2.0 JTDM
2.4 JTDM
Fuel feed Multipoint fuel injection Direct injection Direct injection, Common Rail
Modifications or repairs to the fuel feed system that are not carried out properly or do not
take the system’s technical specifications into account can cause malfunctions leading to
the risk of fire.
1.8 140 HP
Five forward gears + reverse
and synchronisers for speeds
Dry single disk
with hydraulic control
Front2.4 JTDM210 HP 4x4
3.2 JTS 4x4
Six forward gears + reverse
and synchronisers for speeds
Dry single disk
with hydraulic control
Four-wheel drive 1750 TURBO BENZINA
3.2 JTS 4x2 - 1.9 JTD
M8V1.9
JTD
M16v 2.4 JTDM200 HP
2.0 JTD
M- 2.4 JTDM210 HP
Six forward gears + reverse
and synchronisers for speeds
Dry single disk
with hydraulic control
Front
TRANSMISSION
Gearbox
Clutch
Drive
IMPORTANTIn the event of difficult disengagement, due to significant difference of grip between front and rear axle, do
not insist with heavy accelerations: it is actually more effective an attempt of disengagement at medium slow engine rpm,
with pauses of a few seconds if several attempts are necessary.
249-270 Alfa 159 GB 3-12-2009 15:51 Pagina 255
Page 270 of 331
268
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
TECHNICAL SPECIFICATIONS
Synthetic-based oil, grade SAE 75W-85
that passes API GL 4 specifications.
Qualification FIAT 9.55550-MZ1
Synthetic-based oil, grade SAE 75W-90 that passes
API GL-5 specifications, ZF-TE ML 18.
Qualification FIAT 9.55550-DA3
Synthetic fluid for hydraulic and electrohydraulic systems.
Qualification FIAT 9.55550-AG3.
Grease containing Molybdenum bisulphide for high temperature
appliances. NLGI 1-2 consistency.
Qualification FIAT 9.55580.
Grease for homokinetic joints with low friction coefficient.
NLGI 0-1 consistency.
Qualification FIAT 9.55580.
Synthetic fluid for Brake and clutch controls FMVSS n° 116
DOT 4, ISO 4925, SAE J1704, CUNA NC 956-01
Qualification FIAT 9.55597.
Protective with antifreeze action, red colour based on inhibited
monoethylen glycol and organic formula, that passes
CUNA NC 956-16, ASTM D 3306 specifications.
Qualification FIAT 9.555523.
Additive for diesel fuel with anti-freeze action,
protecting Diesel engines.
Mixture of alcohol and surfactants CUNA NC 956-11.
Qualification FIAT 9.55522.TUTELA CAR
MATRYX
Contractual Technical
Reference N° F108.F02
TUTELA
MULTIAXLE
Contractual Technical
Reference N° F426.E06
TUTELA GI/RContractual Technical
Reference N° F428.H04
TUTELA ALL STARContractual Technical
Reference N° F702.G07
TUTELA STAR 700Contractual Technical
Reference N° F701.C07
TUTELA TOP 4Contractual Technical
Reference N° F001.A93
PARAFLUUP(●)Contractual Technical
Reference N° F101.M01
TUTELA DIESEL ARTContractual Technical
Reference N° F601.L06
TUTELA
PROFESSIONAL SC 35
Contractual Technical
Reference N° F201.D02
Mechanical gearbox
and differential
Rear differential and
transmission unit
(3.2 JTS 4X4 and
2.4 JTD
M4x4 version)
Power steering
CV joints
on wheel side
CV joints
on differential side
Brake and clutch
hydraulic controls
Radiator antifreeze
proportion:
50% water and
50% PARAFLU
UP(❏)
To be mixed with fuel oil
(25 cc per 10 litres)
To be used diluted
or undiluted
Windscreen/
headlight washer
fluid Protective agent
for radiators Brake fluid
(●) IMPORTANTDo not top up or mix with fluids having different specifications from those described here.
(
❏) For particularly hard climate conditions, we recommend use of a 60% PARAFLUUPand 40% demineralized water mixture.
Additive for
diesel fluid
Use Fluid and lubricant specifications Original fluids Applications
for correct car operation and lubricants
Lubricants and
greases
for transmission
249-270 Alfa 159 GB 3-12-2009 15:51 Pagina 268