Alfa Romeo 4C 2021 Instructieboek (in Dutch)

99
After a collision, turn the ignition key to
STOP to prevent the battery from
running down.
To restore the correct operation of the
car, proceed as follows:
❒ bring the left exterior light control
stalk to central position (neutral);
❒ turn the ignition key to MAR;
❒ activate the right direction indicator;
❒ deactivate the right direction
indicator;
❒ activate the left direction indicator;
❒ deactivate the left direction indicator;
❒ activate the right direction indicator;
❒ deactivate the right direction
indicator;
❒ activate the left direction indicator;
❒ deactivate the left direction indicator;
❒ ignition key turned to the OFF
position;
❒ turn the ignition key to MAR.TOWING THE VEHICLE
The tow hook provided with the car is
located in the tool box in the luggage
compartment.
The tow hook attachment is only
available at the front end of the car.
ATTACHING THE TOW RING
Take tow hook 1 fig. 86 and tighten it
fully onto the threaded pin.
113) 114) 115)
86A0L0107
112)If, after an impact, you smell fuel or
notice leaks from the fuel system, do not
reactivate the system to avoid the risk of
fire.
IMPORTANT

IN AN EMERGENCY
100
113)Before towing, turn the ignition key
to the MAR position and then to STOP
without removing it. The steering column
will automatically lock when the key is
removed and the wheels cannot be
steered. Also check that the transmission
is in neutral (N).
114) When towing, remember that the
assistance of the brake servo is absent.
Consequently, more force is required at
the pedal in order to brake. Do not use
flexible cables when towing and avoid
jerky movements. Make sure not to
damage parts in contact with the car
while towing.
When towing the vehicle, you must
comply with all specific traffic
regulations and adopt an appropriate
driving behaviour.
Do not start the engine while towing the
car. Before tightening the ring, clean the
threaded housing thoroughly. Make sure
that the ring is fully fastened in the
housing before towing the vehicle.
IMPORTANT115) The tow hook should be used only
for emergencies on the road. You are
allowed to tow the vehicle for short
distances using an appropriate device in
accordance with the highway code (a rigid
bar), to move the vehicle on the road in
readiness for towing or transporting via a
breakdown vehicle.
Tow hooks MUST NOT be used to tow
vehicles off the road or where there are
obstacles and/or for towing operations
using cables or other non-rigid devices.
In compliance with the above conditions,
towing must take place with the two
vehicles (one towing, the other towed)
aligned as much as possible along the
same centre line.

SERVICING AND CARE
SCHEDULED SERVICING ................................................................................. 102
SCHEDULED SERVICING PLAN ................................................................... 103
REGULAR INSPECTIONS ................................................................................. 105
DEMANDING USE OF THE CAR .................................................................... 105
CHECKING LEVELS ............................................................................................. 106
IF THE BATTERY IS FLAT ................................................................................ 106
AIR CLEANER .......................................................................................................... 112
WINDSCREEN WIPERS ..................................................................................... 112
NOZZLES .................................................................................................................. 113
BATTERY ................................................................................................................... 113
LIFTING THE CAR ................................................................................................. 114
BODYWORK ............................................................................................................ 115
INTERIORS ............................................................................................................... 117
Correct servicing permits the performance of the
car to be maintained over time, as well as limited running costs
and safeguarding the efficiency of the safety systems.
This chapter will tell you how.

SERVICING AND CARE
102
SCHEDULED SERVICING
Correct servicing is crucial for
guaranteeing a long life for the vehicle
under the best conditions.
This is why Alfa Romeo has programmed
a series of checks and servicing
operations every 20,000 km.
Check the items on the Scheduled
Servicing Plan (e.g. periodically check
level of liquids, tyre pressure, etc.)
before 20,000 km and then between the
services deadlines.
Scheduled Servicing is offered by the
dedicated Alfa Romeo Dealership at
predefined intervals. If, during each
operation, in addition to the ones
scheduled, the need arises for further
replacements or repairs, these may be
carried out with the owner’s explicit
agreement only.
IMPORTANT NOTES
2000 km before the maintenance is due,
a dedicated message appears on the
display, along with warning light.
Scheduled Servicing interventions are
set out by the Manufacturer. Failure to
have them carried out may invalidate the
warranty.
It is advisable to inform the dedicated
Alfa Romeo Dealership of any small
operating irregularities without waiting
for the next service.

103
2436486072
SCHEDULED SERVICING PLAN
1750 Turbo Petrol VERSIONS
Thousands of km
Months
40
12
206080100120
  
  
  

  
  
  
  
  
  
  
  Check battery charge status and possibly recharge
Check tyre conditions/wear and adjust pressure, if necessary
Check operation of lighting system (headlights, direction indicators,
hazard warning lights, luggage compartment, passenger compartment,
glove compartment, instrument panel warning lights, etc.)
Check vehicle fastenings
Check mechanical components fastenings
Check operation of windscreen washer system and adjust jets if necessary
Check position/wear of windscreen wiper blade
Check cleanliness of luggage compartment lock, cleanliness and lubrication of linkages
Visually inspect condition of: exterior bodywork, carbon monocoque, aerodynamic
bottom, pipes and hoses (exhaust, fuel supply system, brakes), rubber elements
(boots, driveshaft boots, sleeves, bushes, etc.)
Check condition and wear of front brake pads and discs,
and operation of pad wear indicator
Check condition and wear of rear brake pads and discs,
and operation of pad wear indicator
Check and, if necessary, top up fluid levels (engine cooling, brakes,
windscreen washer, etc.)

SERVICING AND CARE
104
2436486072
Thousands of km
Months
40
12
206080100120


  
  




  
 Visually inspect condition of the accessory drive belt(s)
Inspect the conditions of toothed timing drive belt
Check handbrake lever travel and adjust, if necessary
(or every 12 months)
Use the diagnosis socket to check supply/engine and
gearbox/transmission management system operation and engine oil degradation
Check and, if necessary, top up oil level for the
twin clutch transmission
Replace spark plugs (1)
Replace accessory drive belt/s
Replace toothed timing drive belt (2)
Replace air cleaner cartridge
Replace engine oil and oil filter (3)
Change brake fluid (or every 24 months)
(1) The following are essential to ensure correct operation and prevent serious damage to the engine: only use spark plugs of the same make and type
which are specially certified for such engines (see the information in the “Engine” paragraph in the “Technical specifications” chapter); strictly
comply with the spark plug replacement interval given in the Scheduled Servicing Plan; for spark plug replacement, it is advisable to contact a
dedicated Alfa Romeo Dealership.
(2) Irrespective of the mileage, the timing drive belt must be replaced every 4 years for heavy-duty use
(cold climates, town use, long periods of idling) or, in any case, every 5 years.
(3) The actual interval for changing the oil and replacing the engine oil filter depends on the car usage conditions and is signalled by the warning light
or message (where provided) or the instrument panel or, in any case, every 12 months.

105
PERIODIC CHECKS
Every 1,000 km or before long journeys,
check and, if necessary, top up the
following:
❒ engine coolant level;
❒ brake fluid;
❒ windscreen washer fluid;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlights, direction indicators, hazard
warning lights, etc.);
❒ operation of windscreen
washing/wiping system and
positioning/wear of wiper blade.
Every 3,000 km check and top up if
required: engine oil level.
IMPORTANT To find out the correct oil
quantity, always check using the dipstick.
Carry out the check with the vehicle
parked on level ground.
DEMANDING USE OF THE CAR
If the vehicle is used mainly under one of
the following conditions:
❒ trailer or caravan towing;
❒ dusty roads;
❒ short repeated distances (less than
7-8 km) and with external temperatures
below zero;
❒ engine often idling or driving long
distances at low speeds or long periods
of inactivity;
❒ you should perform the following
inspections more frequently than shown
in the Scheduled Servicing Plan:
❒ check front disk brake pad conditions
and wear;
❒ check cleanness of locks, bonnet and
boot and lever cleanness and lubrication;
❒ visually inspect condition of: engine,
gearbox, transmission, pipes and hoses
(exhaust - fuel system - brakes) and
rubber elements (gaiters - sleeves -
bushes - etc.);
❒ check battery charge and battery fluid
level (electrolyte);❒ visually inspect conditions of the
accessory drive belts;
❒ check and, if necessary, change engine
oil and replace oil filter;
❒ check air cleaner and replace it, if
required.
Using the car on track should be regarded
as an exception. The car has been
designed and produced for road use.

SERVICING AND CARE
106
CHECKING LEVELS
The topping-up plug 2 and the dipstick 1 for checking the engine oil level and the reservoir 3 for the engine coolant can be accessed
by lifting the tailgate (see the procedure in the “Boot/Bonnet” paragraph in the “Knowing your car” chapter).
116) 117) 118)
14)
87A0L0152

107
The brake fluid and windscreen washer is located between the bonnet and the windscreen and can be reached by removing the
panel 4 and the protective grille 5, respectively; use the kit provided for topping up (see descriptions shown below).
14)
88A0L0153

SERVICING AND CARE
108
ENGINE OIL
Check that the oil level is between the
MIN and MAX marks on the dipstick
1 fig. 87.
For this check, take out the dipstick from
its seat, clean it with a lint-free cloth,
reinsert the dipstick; take it out again and
check the oil level.
119)
If the oil level is near or under the MIN
mark, add oil through the filler 2 fig. 87
until it reaches the MAX mark.
15)
Tool 1 shown in fig. 89 and stored in the
car, must be used to
undo and refasten the filler cap.
Take out the engine oil dipstick 1 fig. 87,
clean it with a lint-free cloth  and reinsert
it. Extract the engine oil dipstick again
and check that the level is between the
MIN and MAX marks on the dipstick.
119)
WARNING Make sure that the oil cap is
tightened properly in its seat after
topping the oil up.
After refitting the cap, remove tool 1 fig.
89 before closing the bonnet and place it
back in the housing to prevent misplacing
it and avoid the risk of causing damage to
the engine.
The range between the MIN and MAX
levels corresponds to approximately 1
litre of oil.
89A0L0231
Engine oil consumption
16) 4)
The maximum engine oil consumption is
usually 400 grams every
1000 km.
When the car is new, the engine needs to
be run in; therefore the engine oil
consumption can only be considered
stabilised after the first
5,000 - 6,000 km.
IMPORTANT After adding or changing
the oil, let the engine run for a few
seconds and wait a few minutes after
switching it off before checking the level.
ENGINE COOLANT FLUID
120) 17)
The coolant level must be checked when
the engine is cold and must range
between the MIN and MAX marks on the
reservoir.
If the level is too low, unscrew reservoir
plug 3 fig. 87 and add the fluid described
in the “Fluids and lubricants” paragraph of
the “Technical Specifications” chapter.