catalytic converter Alfa Romeo 8C 2007 Owner handbook (in English)

64
3
Low oil pressure (*)
In normal conditions, when turning
the key to MAR the warning light
should illuminate, and should go off once the
engine has started.
If the warning light remains on or illuminates
while driving, this indicates a too low engine
oil pressure. In this case, turn the engine off
immediately and carry out the necessary checks.
If the problem persists, contact an Authorised
Service Centre of the Manufacturer’s
Network.
High catalytic converter
temperature
It illuminates if the engine runs
irregularly with consequent high temperature in
the exhaust system.
CAUTION
IF THE WARNING LIGHT IS
ACCOMPANIED BY THE MESSAGE
“CATALYST TEMPERATURE TOO
HIGH, SLOW DOWN”: the catalytic
converters’ temperature is too
high. The driver must slow down immediately until the warning light
goes off.
Catalyst temperature too high
CAUTION
IF THE MESSAGE “CATALYST
TEMPERATURE TOO HIGH, DO
NOT CONTINUE” APPEARS AFTER
DECELERATING: dangerous catalyst
temperature, the catalysts can be
damaged. Stop the vehicle and contact
an Authorised Service Centre of the
Manufacturer’s Network.
CAUTION
If the warning light illuminates
permanently 3 times, the engine stops.
The engine can only be restarted
turning the key to off and then back to
on. Then go to the nearest Authorised
Service Centre of the Manufacturer’s
Network driving at low speed.CAUTION
Alfa Romeo declines all
responsibility for whatever damage
deriving from non compliance with the
above mentioned warnings.
Low Q-Select gearbox oil
The red symbol indicates that the
gearbox oil is low; stop the vehicle
and contact an Authorised Service Centre
of the Manufacturer’s Network to have the
vehicle checked.
Q-Select gearbox failure
It indicates a failure of the
electronically-controlled gearbox.
If the failure permits, slowly drive to
an Authorised Service Centre of the
Manufacturer’s Network.

131
5
USING THE VEHICLE
CAPACITIESWARNING: Use unleaded fuel only!
The use of fuel containing lead would
permanently damage the catalytic converters.For fluid and lubricant specifications and
quantities, follow the indications contained
in section 7 “CAPACITIES AND TECHNICAL
SPECIFICATIONS”.
SAFE DRIVING
Although the vehicle is fitted with active and
passive safety devices the driver’s behaviour is
always a decisive factor for road safety.
Below are some simple rules for travelling safely
in different conditions. You will, no doubt, be
familiar with some of them but, in any case, it
would be useful to read them carefully.BEFORE YOU DRIVE
- Make sure that the lights and headlights are
working properly.
- Adjust the position of the seat, steering
wheel and rear-view mirrors so that you
have the best driving position.
- Check that nothing (e.g. mat covers, etc.)
is blocking the pedals.
- Carefully arrange any objects in the luggage
compartment, to prevent sudden braking
from jerking them forward.
- Avoid heavy meals before a trip. A light
snack helps to keep the refl exes sharp. In
particular avoid drinking alcohol.
- Remember to read, at regular intervals,
the instructions contained in the chapter
“Before a trip”, in this section.
CAUTION
It is extremely dangerous and
moreover prohibited by law to travel
on the luggage shelf behind the seats.
In the event of an accident, persons
carried in this position are more
exposed to the risk of serious injury.
Passengers must only travel seated in
the vehicle seats, with the seat belts
fastened properly. Always check that
you and your passengers have your
seat belts fastened correctly.

135
5
USING THE VEHICLE
ANTI-POLLUTION
DEVICES Even if the vehicle is equipped with anti-pollution
devices, the environment deserves the greatest
respect from every one of us.
By following a few simple rules, the vehicle
driver can avoid damaging the environment and
very often can reduce fuel consumption as well.
In this regard, some useful information is listed
here below; please read it carefully.
The correct operation of the anti-pollution devices
not only assures respect for the environment, but
also has an impact on vehicle performance.
So, keeping these devices in good working
conditions is the first rule for driving that is both
ecologically sound and economical.
The first precaution is to follow the Scheduled
Maintenance plan scrupulously. Always use unleaded fuel.
If starting is difficult, do not make prolonged
attempts.
Especially avoid push starts, towing or hill starts:
these are all manoeuvres that can damage
catalytic converters.
Use an auxiliary battery only when making an
emergency start.
While driving, if the engine does not run
smoothly, you may continue driving but reducing
engine performance to a minimum; you should
then contact an Authorised Service Centre
of the Manufacturer’s Network as soon as
possible.
Never run the engine, even if only for testing,
with one or more spark plugs disconnected.
Do not warm up the engine letting it idle before
starting off, except in the event of very low
outside temperatures and, even then, for no
longer than 30 seconds.
CAUTION
During normal operation the
catalyst converter generates high
temperatures. Do not, therefore, park
the vehicle on flammable materials
(e.g. grass, dry leaves, pine needles,
etc.): risk of fire!
Do not install heat guards and do not remove
those already fitted to the catalytic converter and
to the exhaust manifold.
Do not spray anything on the catalytic converter,
lambda probe and exhaust manifold.
CAUTION
Failure to comply with these
rules can lead to fire hazards.