run flat Alfa Romeo GT 2006 Owner handbook (in English)

IN AN EMERGENCY
218
Hand the instruction
brochure to the personnel
charged with treating the
tyre repaired with the kit.
In the event of a puncture
caused by foreign bodies,
it is possible to repair tyres
showing damages on the track or
shoulder up to max 4 mm diame-
ter. IT SHOULD BE NOTICED THAT:
The sealing fluid of the quick tyre repair kit
is effective with external temperatures be-
tween –20°C and +50°C. The sealing flu-
id has limited life.
Holes and damages on
the tyre side walls cannot
be repaired. Do not use the
quick tyre repair kit if damaging
is due to running with flat tyre.
Repairs are not possible
in case of damages on the
wheel rim (bad groove dis-
tortion causing air loss). Do not re-
move foreign bodies (screws or
nails) from the tyre.The cylinder contains eth-
ylene glycol. The cylinder
contains latex: it can cause
allergic reactions. It is harmful if in-
gested or inhaled and irritant for
the eyes and in case of contact. In
case of contact rinse immediately
with water and take off contami-
nated clothes. If swallowed, do not
induce vomit, rinse out the mouth,
drink a lot of water and call the
doctor immediately. Keep away
from children. This product must
not be used by asthmatics. Do not
inhale vapours. Call the doctor im-
mediately in case of allergic reac-
tions. Keep the cylinder in the
space provided for the purpose and
far from heat. The sealing fluid has
limited life.

IN AN EMERGENCY
219
The compressor shall not
be operated for more than
20 minutes. Risk of over-
heating!. Tyres repaired with the
quick tyre repair kit shall be used
temporarily only.
Replace the cylinder if
sealer has run out. Do not
throw away the cylinder
and the sealing fluid. Have the
sealing fluid and the cylinder dis-
posed of in compliance with na-
tional and local regulations.INFLATING PROCEDURE
Put on the protection
gloves provided together
with quick tyre repair kit.
Proceed as follows:
– set the wheel to be repaired with valve
A-fig. 13in the position shown in the fig-
ure, then pull up the handbrake, take
the quick tyre repair kit and put it on the
ground near the wheel to be repaired;– loosen tyre inflation valve cap, take out
the filler hose A-fig.1 4and screw the ring
nutB-fig. 15on the tyre valve;
fig. 13
A0A1097bfig. 14
A0A1098b
fig. 15
A0A1099b

VEHICLE MAINTENANCE
264
Incorrect pressure causes abnormal tyre
wear:
(A): Normal pressure: tread evenly
worn.
(B): Low pressure: tread particularly
worn at the edges.
(C): High pressure: tread particularly
worn in the centre.
Tyres should be changed when the tread
thickness is reduced to 1,6 mm.
In any case follow local regulations.
You are also reminded that services with
high current absorption switched on by the
user, such as for example: baby bottle
warmers, vacuum cleaner, mobile phone,
mini fridge, etc., quicken the battery
draining processif they are turned on
with the engine off or running at idle
speed.
IMPORTANT When installing addi-
tional systems on the vehicle, bear in
mind that improper branches on connec-
tions of the vehicle wiring are dangerous,
particularly if safety devices are involved.
WHEELS AND TYRES
TYRE PRESSURE
Check the tyre pressure of every wheel,
including the spare, every two weeks and
before a long journey. The pressure should
be checked with the tyre rested and cold.
It is normal for the pressure to increase
when the car is in use; for the correct tyre
inflation pressure, see “Wheels” in the
“Technical Specifications” chapter.
Battery
60 Ah
70 AhMaximum permissible
loadless absorption
36 mA
42 mA
The maximum absorption of all the
accessories (standard and fitted after-
wards) should be 0,6 mA x Ah (of the bat-
tery), as shown in the following table:
fig. 14
A0A0225b