recommended oil Alfa Romeo GT 2008 Owner handbook (in English)

CAR MAINTENANCE
227
Oil consumption is very
low; if topping up again is
needed shortly afterwards,
have the system checked for pos-
sible leaks by Alfa Romeo Autho-
rised Services.Do not allow the power
steering fluid to touch hot
parts of the engine: it is in-
flammable.
fig. 12
A0A0217b
fig. 11
A0A0400b
BRAKE AND HYDRAULIC
CLUTCH FLUID
(fig. 12)
Check that the fluid level in the reservoir
is at maximum. Top up with the brake fluid
specified in the table “Fluids and lubricants”
(see section “Technical specifications").
NOTEClean accurately the tank cap A
and the surrounding surface. When opening
the cap take the utmost care to prevent im-
purities entering the tank. When topping up,
always use a funnel with built-in filter with
mesh equal to or lower than 0.12 mm.
IMPORTANTFor this operation it is
however recommended to contact Alfa
Romeo Authorised Services.
POWER STEERING FLUID
(fig. 11)
Check that the level of the oil in the reser-
voir is at maximum.
This operation should be carried out with
the car on a level surface and the engine
switched off and cold.
Check that the level reaches the MAX
mark on the reservoir or coincides with the
upper notch (maximum level) on the dip-
stick (A) integral with the reservoir cap.If the oil level in the reservoir is below the
specified one, top up only with one of the
products listed in the “Fluids and lubricants”
table in the “Technical specifications” chap-
ter proceeding as follows:
– Start the engine and wait for the oil lev-
el in the reservoir to stabilise.
– With the engine running, turn the steer-
ing wheel lock to lock a few times.
– Top up to the MAXlevel notch, then
refit the cap.

REFILLING
2.0JTS
Selespeed
63 (
▲)
7 (▲)
7,2
4.4
(❍)
2.0
0.6
1.2
0.52
2.5
4.2
3.2V6
63 (▲)
7 (▲)
7.2
5.9
(❍)
2.0
–
1.2
0.52
2.5
4.2
1.8 T.
SPARK
63 (▲)
7 (▲)
7.2
4.4 (❏)
2.0
–
1.2
0.52
2.5
4.2
2.0JTS
63 (
▲)
7 (▲)
7.2
4.4
(❍)
2.0
–
1.2
0.52
2.5
4.2TECHNICAL SPECIFICATIONS
252
JTD16V
63 (■)
7 (■)
7.2
4.5 (
●)
2.0
–
1.2
0.52
2.5
4.2
Fuel tank: litres
– including a reserve of litres
Engine cooling system litres
Oil sump and filter litres
Mechanical transmission/differential litres
Selespeed transmission litres
Hydraulic power steering litres
Hydraulic brake circuit
with ABS litres
Windscreen washer and rearscreen
washer fluid reservoir litres
– with headlamp washer litresRecommended products and
genuine lubricants
(▲)Unleaded petrol with no less than
95 R.O.N
(■)Diesel fuel for motor vehicles
(Specification EN590)
Mixture of distilled water
andPARAFLU UP at 50%
(❏)SELENIA 20 K for Alfa Romeo(❍)SELENIA RACING(●)SELENIA WR
TUTELA CAR TECHNYX
TUTELA CAR CS SPEED
TUTELA GI/A
TUTELA TOP 4
for Alfa Romeo
Mixture of water and fluid
TUTELA
PROFESSIONAL SC 35

TECHNICAL SPECIFICATIONS
253
FLUIDS AND LUBRICANTS
RECOMMENDED PRODUCTS AND THEIR SPECIFICATIONS
Should non-genuine products be used, lubricants with minimum ACEA A3 properties for petrol engines and ACEA B4 for Diesel engines are tolerated; in this
event top engine performance is not guaranteed.
Using low-quality products, not compliant with ACEA A3 and ACEA B4 properties and specifications could cause engine damages not covered by warranty.
For very cold temperatures, consult Alfa Romeo Authorised Services for the proper Seleniaproduct to use.
SELENIA 20K for
ALFA ROMEO
SELENIA RACING
SELENIA WRAs per Service
Schedule
As per Service
Schedule
As per Service
Schedule Use Fluid and lubricant specifications Genuine fluids Change
for correct car operation and lubricants intervals
Lubricants for
petrol engines
1.8 T. SPARK
Lubricants for
petrol engines
2.0 JTS - 3.2
V6
Lubricants for
Multijet engines
Synthetic-based oils, grade SAE 10W-40
FIAT 9.55535-G2qualification
Synthetic-based oil, grade SAE 10W-60
FIAT 9.55535-H3qualification
Synthetic-based oil, grade SAE 5W-40
FIAT 9.55535-N2qualification.