stop start Acura CL 2003 Owner's Manual

See page f or important saf etyinf ormation about how to properlyposition the steering wheel. 17
Make sure the rear window is clear
and you have good visibility bef ore
starting to drive. The def ogger and antenna wires on
the inside of the rear window can be
accidentally damaged. When
cleaning the glass, always wipe side
to side.
Make any steering wheel adjustment
bef ore you start driving. Steering Wheel A djustment
Controls Near the Steering Wheel
Inst rument s and Cont rols76
C Caarrss w
wi itth h n
na
avviigg a
attiioo n
n s
syys stteem m
Adjusting the steering wheel
position while driving may
cause you to lose control of the
car and be seriously injured in a
crash.
Adjust the steering wheel only
when the car is stopped.

Both f ront seats are equipped with
seat heaters. The ignition switch
must be ON (II) to use them. Push
the heater switch to turn the power
on or of f . The pilot lamp lights and
remains on while the heaters are on.Do not use the seat heaters when the
engine is of f or when idling f or a
long period of time. They can drain
the battery, making your car hard to
start.
Because of the sensors f or the side
airbag system, there is no heater in
the passenger’s seat-back.
Each door has a switch that controls
its window. To open the window,
push the switch down and hold it.
Release the switch when you want
the window to stop. Close the
window by pulling back on the
switch and holding it. Your car’s windows are electrically-
powered. Turn the ignition switch to
ON (II) to raise or lower either
window.
With M/T
Inst rument s and Cont rols
Seat Heaters, Power Windows
Power Windows
104
S SE
EA
A T
T H
HE
EA
A T
TE
ER
RS S

The power window system has a key-
of f delay f unction. The windows will
stilloperateforuptotenminutes
after you turn off the ignition.
Opening either door cancels the
delay function. You must turn the
ignition switch ON (II) again before
you can raise or lower the windows.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it. If the driver’s window runs into any
obstacle while it is closing
automatically, it will stop, and then
reverse direction. To close the
window, remove the obstacle, then
use the window switch again.
The MAIN switch controls power to
the passenger’s window. With this
switch of f , the passenger’s window
cannot be raised or lowered. The
MAIN switch does not af f ect the driv-
er’s window. Keep the MAIN switch
off whenyouhavechildreninthecar
so they do not injure themselves by
operating the window unintentionally.
The lights inside the switches come
onwhenyouturntheparkinglights
or headlights on.If your car’s battery is disconnected
or goes dead, or the driver’s window
f use is removed, the AUTO f unction
will be disabled. The power window
system needs to be reset af ter
reconnecting the battery or installing
the f use. You should do the f ollowing.
Start the engine. Push down on
the driver’s window switch until
the window is f ully open.
If the power windows do not operate
properly af ter resetting, have your
car checked by an Acura dealer. Pull back on the driver’s window
switch to close the window
completely, then hold the switch
f or a second or two more.
2. 1.
Inst rument s and Cont rols
Power Windows
Auto Reverse
106

To load multiple CDs in one
operation:Press and hold the Load button
until you hear a beep and see
‘‘____’’inthedisplay,then
release the button.
On the lef t side of the display, the
CD Loaded indicator f or an empty
position will begin blinking.
When LOAd appears again in the
display, insert the next disc into
the CD slot. Repeat this until all six positions
are loaded. The system will then
begin playing the last CD loaded.
If you are not loading CDs into all six
positions, press the Load button
again after the last CD has loaded.
The system will begin playing the
last CD loaded.
If you stop loading CDs bef ore all six
positions are f illed, and you do not
press the Load button, the system
will wait f or ten seconds, then stop
the load operation and begin playing
the last CD loaded. To load a single CD:
Press and release the Load button.
When the CD Loaded indicator f or
an empty position starts to blink,
andyouseeLOAdinthedisplay,
insert the disc into the CD slot.
Insert it only about halfway, the
drive will pull it in the rest of the
way.
The system will load the CD, and
begin playing it.
When you see LOAd in the display,
insert the disc into the CD slot.
Insert it only about halfway, the
drive will pull it in the rest of the
way. You will again see the dashes
in the display as the CD is loaded.
1.
2.
3.
4. 5.
1.
2.
3.
Audio System
Comf ort and Convenience Feat ures
L oading CDs in t he Changer
148

CONT INUED
If you press the Load button while a
CD is playing, the system will stop
playing that CD and start the loading
sequence. It will then play the CD
just loaded.
You can also load a CD into an empty
position while a CD is playing by
pressing the appropriate preset
button. Select an empty position (the
CD Loaded indicator is of f ), and
press the preset button f or that
position (1 to 6). The system will
stop playing the current CD and start
the loading sequence. It will then
play the CD just loaded.
Audio System
Comf ort and Convenience Feat ures149
L LOOA AD
D B
BUUT TT
TO
ON N
A
A M
M B
BUUT TT
TO
ON N P
PR
RE ES
SE ET
T B
BUUT TT
TO
ON NSS
C
CD
D S
SLLOOT T
F
FM M
B
BU UT TT
TO
ON N
C
CD
D L
LOOA AD
DE
ED
D
I
IN ND DI
ICCA A T
TO
OR R
T
TA
A P
PE
E B
BUUT TT
TO
ON N

With the clutch pedal depressed,
move the shift lever to the First/
Second gear side of the Neutral
gate, then shif t to Reverse.If you are still unable to shif t to
Reverse, apply the parking brake
and turn the ignition key to
ACCESSORY (I) or LOCK (0).
Depress the clutch pedal and shif t
to Reverse.
With the clutch pedal still de-
pressed, start the engine.
If you need to use this procedure to
shif t to Reverse, your car may be
developing a problem. Have the car
checked by your Acura dealer.
The 6-speed manual transmission
has an electric lockout so you cannot
accidentally shif t f rom Fif th to
Reverse instead of Sixth while the
car is moving. If you cannot shif t to
Reverse when the car is stopped:
1.2.
3.
4.
Driving
6-speed Manual T ransmission
Reverse Lockout
196

The shif t lever has nine positions. It
must be in Park or Neutral to start
the engine. When you are stopped in
D,D,D,2,1,N,R,orthe
Sequential SportShif t mode, press
f irmly on the brake pedal and keep
your f oot of f the accelerator pedal.To select the Sequential SportShif t
mode, slide the shif t lever toward the
lef t f rom the ‘‘D ’’ position.
In this mode the shif t lever allows
youtoshiftupanddownmanually.
YoucannotshiftoutofParkwiththe
brake pedal depressed when the
ignition switch is in LOCK (0) or
ACCESSORY (I). Whenever you move the shif t lever,
slide it along the guide on the
console.
543 5
To shift from:
PtoR
RtoN
NtoD
DtoD
DtoD Dto22to1
1to2
2toD
DtoD
DtoD DtoN NtoRRtoP Do this:
Press the brake pedal, then
move the shift lever.
Move the lever.
5
54
43 3
3
34
45 5
Shif t L ever Positions
Automatic Transmission
Driving198
S SH H I
IFFT T L
LE
E V
V E
ER
R
S
SE EQ
QU UEEN
NT TI
IAA L
L
S
SP PO
OR RTTS
SH H I
IFFT T
M
M O
ODDE
E
P
P O
OS SIITT I
IOON N

µµ
µµ
This position mechani-
cally locks the transmission. Use
Park whenever you are turning of f or
starting the engine. To shif t out of
Park, you must press on the brake
pedal and have your f oot of f the
accelerator pedal. Move the shif t
lever to the right to shif t out of the
Park position.
To avoid transmission damage, come
to a complete stop bef ore shif ting
into Park. The shif t lever must be in
Park bef ore you can remove the key
from the ignition switch. To shif t to Reverse
f rom Park, see the explanation under
Park. To shif t to Reverse f rom
Neutral, come to a complete stop and
then shift.
If you have done all of the above and
still cannot move the lever out of
Park, see Shif t Lock Release on page . Your car has a reverse lockout so
you cannot accidentally shif t to
Reverse from Neutral or any other
driving position when the vehicle
speed exceeds 7 9 mph (12 14
km/h).
If you cannot shif t to Reverse when
the car is stopped, press the brake
pedal and slowly shif t to Neutral, and
then to Reverse.
If there is a problem in the reverse
lockout system, or your car’s battery
is disconnected or goes dead, you
cannot shif t to Reverse. (Ref er to
Shif t Lock Release on page ).
204
204
CONT INUED
Park (P)Reverse (R)
Automatic Transmission
Driving199

µ
µ µ
´
´
µ
µ
Use Neutral if you
need to restart a stalled engine, or if
it is necessary to stop brief ly with
the engine idling. Shif t to Park posi-
tion if you need to leave the car for
any reason. Press on the brake pedal
when you are moving the shif t lever
f rom Neutral to another gear.
Use this position f or
your normal driving. The
transmission automatically selects a
suitable gear for your speed and
acceleration. You may notice the
transmission shif ting up at higher
speeds when the engine is cold. This
helps the engine warm up f aster. With
the shif t lever in ‘‘D ’’ position, you
can select the Sequential SportShif t
mode to shif t gears; much like a
manual transmission, but without a
clutch pedal.
Even with the Sequential SportShift
Mode selected, the transmission will
automatically upshif t and downshif t
between f irst and second gear.
To enter the Sequential SportShif t
mode, move the shif t lever to the lef t.
To return to ‘‘D ’’, move the shif t
lever to the right.
When you move the shif t lever f rom
‘‘D ’’ to the Sequential SportShift
mode, the display shows the selected
gear.
In the Sequential SportShif t mode,
each time you push f orward on the
shif t lever, the transmission shif ts to
a higher gear. Pull back on the lever
to downshif t. The number of the
gear selected is displayed next to the
‘‘D ’’ indicator (see page ).
197
5
5
5
5
Neutral (N)
Drive (D )
5
Sequent ial Sport Shif t Mode
Automatic Transmission
Driving200
D D o
ow
wn ns
shh i
iff t
t
U
Up
ps
shh i
iff t
t

à
à
à
à
When you accelerate away f rom a
stop, the transmission will start in
first gear and then automatically
upshif t to second gear. You have to
manually upshif t between second
and f if th gears. Make sure you
upshif t bef ore the engine speed
reaches the tachometer’s red zone.
The transmission remains in the
selected gear (5, 4, 3). There is no
automatic downshif t when you push
the accelerator pedal to the floor.
The transmission may automatically
downshif t f rom the higher gear to
the lower gear under the f ollowing
conditions:
To shift from 43
54 Speed range
under 18 mph
(29 km/h)
under 34 mph
(55 km/h)
To shift from 43
54 Speed range
under 34 mph
(55 km/h)
under 47 mph
(75 km/h) Downshif ting gives you more power
when climbing or provides engine
braking when going down a steep hill.
The transmission will also shif t
automatically as the vehicle comes to
a complete stop. It will downshif t to
f irst gear when the vehicle speed is
under 9 mph (15 km/h).
If you try to manually downshif t at a
speed that would cause the engine to
exceed the redline in a lower gear,
the transmission will not downshif t.
Thegearindicatorwillflashthe
numberof thelowergearseveral
times, then return to the higher gear.
Driving uphill Driving on level roads and downhill
CONT INUED
Driving
Automatic Transmission
201