mode Acura MDX 2007 User Guide

If a child who uses a booster seat
must ride in front, move the vehicle
seat as far back as possible and be
sure the child is wearing the seat
belt properly.
A child may continue using a booster
seat until the tops of their ears are
even with the top of the vehicle’s or
booster’s seat-back. A child of this
height should be tall enough to use
the lap/shoulder belt without a
booster seat. The
National Highway Traffic Safety
Administration and Transport
Canada recommend that all children
age 12 and under be properly
restrained in a back seat.
If the passenger’s front airbag
inflates in a moderate to severe
frontal collision, the airbag can cause
serious injuries to a child who is
unrestrained, improperly restrained,
sitting too close to the airbag, or out
of position.
A side airbag also poses risks. If any
part of a larger child’s body is in the
path of a deploying side airbag, the
child could receive possibly serious
injuries. Of
course, children vary widel y. And
while age may be one indicator of
when a child can safely ride in front,
there are other important f actors you
should consider.
Physically, a child must be large
enough f or the lap/shoulder belt to
properly fit (see pages and ). If
the seat belt does not f it properly,
with or without the child sitting on a
booster seat, the child should not sit
in f ront.
To saf ely ride in f ront, a child must
be able to f ollow the rules, including
sitting properly, and wearing the seat
belt properly throughout a ride. 15
54
Protecting L arger Children
When Can a L arger Child Sit in
Front
Physical Size
Maturity
56
——y
y
()-y
y

Your vehicle’s exhaust contains
carbon monoxide gas. Carbon
monoxide should not enter the
vehicle in normal driving if you
maintain your vehicle properly and
f ollow the inf ormation on this page.High levels of carbon monoxide can
collect rapidly in enclosed areas,
such as a garage. Do not run the
engine with the garage door closed.
Even with the door open, run the
engine only long enough to move the
vehicle out of the garage.
The vehicle is raised f or an oil
change.
You notice a change in the sound
of the exhaust.
The vehicle was in an accident
that may have damaged the
underside.
Have the exhaust system inspected
f or leaks whenever:
With the tailgate open, airflow can
pull exhaust gas into your vehicle’s
interior and create a hazardous
condition. If you must drive with the
tailgate open, open all the windows,
and set the climate control system as
shown below.
If you must sit in your parked vehicle
with the engine running, even in an
unconfined area, adjust the climate
control system as f ollows:
Select the f resh air mode.
Select the mode.
Turn the f an on high speed.
Set the temperature control to a
comfortable setting.
1.
2.
3.
4.
Carbon Monoxide Hazard
58
Carbon monoxide gas is toxic.
Breathing it can cause
unconsciousness and even kill
you.
Avoid any enclosed areas or
activities that expose you to
carbon monoxide.
——y
y
()-yy

CONT INUED
These labels are in the locations
shown. They warn you of potential
hazards that could cause serious
injury or death. Read these labels
caref ully.
If a label comes of f or becomes hard
to read (except for the U.S.
dashboard label which may be
removed by the owner), contact your
dealer f or a replacement.U.S. models only
Saf ety L abels
Driver and Passenger Saf ety
59
RADIATOR CAP
HOOD DASHBOARD
BATTERY LABEL
——y
y
()-yy

U.S. modelsCanadian models Canadian models
U.S. models
U.S. models
Saf ety L abels
60
SUN VISOR DOORJAMBS
——y

y
()-yy

Î Î
Î
The U.S. instrument panel is shown. Differences for the Canadian models are noted in the text.
:
: If equipped
Instrument Panel
Instru me ntsand Cont ro ls
63
LOW TIRE PRESSURE
INDICATOR
CRUISE CONTROL
INDICATOR
ANTI-LOCK
BRAKE SYSTEM
INDICATOR SYSTEM
MESSAGE INDICATOR
HIGH BEAM INDICATOR MULTI-INFORMATION
DISPLAY
LOW OIL PRESSURE INDICATOR
VSA ACTIVATION INDICATOR
MALFUNCTION
INDICATOR
LAMP
A/T TEMPERATURE INDICATOR LIGHTS
ON INDICATOR
SEAT
BELT REMINDER INDICATOR
SUPPLEMENTAL RESTRAINT
SYSTEM INDICATOR
CHARGING SYSTEM INDICATOR
SECURITY SYSTEM INDICATOR
(P.65)
SIDE
AIRBAG OFF
INDICATOR
SH-AWD INDICATOR
IMMOBILIZER SYSTEM
INDICATOR
FOG LIGHT INDICATOR
ACTIVE
DAMPER SYSTEM
INDICATOR
PARKING BRAKE AND BRAKE SYSTEM INDICATOR
CRUISE
MAIN INDICATOR
(P.68)
(P.70)
(P.71)
(P.66)
(P.69) (P.69)
(P.65)
(P.68)
(P.65) (P.70) (P.67)(P.67)
(P.71)
(P.70)
(P.70)
LOW
FUEL
INDICATOR (P.71)(P.68)
(P.66)
(P.66)
(P.70)
(P.64)
(P.73)
VEHICLE STABILITY ASSIST (VSA) SYSTEM INDICATOR
(P.431)
——y
y
()-yy

This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
may rise to the upper zone. If it
reaches the red (hot) mark, pull
safely to the side of the road. For instru
ctions and precautions on
checking the engine’s cooling
system, see page . This shows how much f uel you
have. It may show slightly more
or less than the actual amount.
428
Gauges
Temperature Gauge Fuel Gauge
72
U.S. model is shown.SPEEDOMETER
FUEL GAUGE
TEMPERATURE
GAUGE TACHOMETER
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
——y

y
()-yy

When the main menu is blank,
SH-AWD or TIRE PRESSURE,
pressing the SEL/RESET button
changes the display to ‘‘trip meter/
odometer’’ ‘‘outside temperature/
odometer’’ and ‘‘engine oil lif e/
odometer’’.The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, and
then press and hold the SEL/RESET
button until the number resets to
‘‘0.0.’’
CONT INUED
Multi-Inf ormation Display
Trip Meter
Odometer
Inst rument s and Cont rols
75
ODOMETER TRIP METER
——y
y
()-yy

The temperature sensor is in the
front bumper. The temperatu re
reading can be affected by heat
reflection from the road surface,
engine heat, and the exhaust from
surrounding traffic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not fully
acclimatized, therefore it may take
several minutes until the proper
te mperature is displayed.
In certain weather conditions,
temperature readings near freezing
(32°F, 0°C) could mean that ice is
forming on the road surface.
You can adjust the outside
temperature display (see page ).
This
shows the outside Fahrenheit
te mperature in U.S. models, and
Centigrade temperature in Canadian
models.
When
you reset Trip A, average fuel
economy A is reset at the same time.
When you reset Trip B, average fuel
economy B is reset.
In the customizing mode, you can set
Trip A and average fuel economy A
to reset at the same time when you
refuel your vehicle (see page ).
92
91
Outside Temperature
Multi-Inf ormation Display
76
OUTSIDE TEMPERATURE
U.S.
CANADA
——y


y
()-y
y

This shows the estimated distance
you can travel on the fuel rema ining
in the fuel tank. This distan ce is
estimated from the fuel economy
you received over the last several
miles(U.S.) or kilometers (Canada),
so it will vary with changes in speed,
traffic, etc.
This
shows your vehicle’s average
fuel economy in mpg (U.S. model s)
or liter/100 km (Canadian models)
since you last reset the Trip A or
Trip B.
You can customize the Trip A and
AVERAGE FUEL A reset condition
in the multi-information display (see
page ).
This shows the average speed you
are traveling in miles per hour (mph)
forU.S.modelsorkilometersper
hour (km/h) for Can adian models.
To reset the AVERAGE SPEED you
have traveled, press and hold the
SEL/RESET button until the
number resets. This
shows the time passed traveled
since you last reset it. When you turn
the ignition switch to the ON (II)
pos ition, ELAPSED TIME is reset.
If you want to reset the ELAPSED
TIME manually, go to the trip
computer’s ELAPSED TIME display,
andpressandholdtheSEL/RESET
button until the number resets.
You can customize the ELAPSED
TIME reset condition in the multi-
inf ormation display (see page ). 94
92
AVERAGE FUEL A/B
RANGE
A VERA GE SPEED EL A PSED T IME
Multi-Inf ormation Display
Inst rument s and Cont rols
79
——y

y
()-yy

When the main menu displays
‘‘Keyless Memory Settings ,’’ you
can customize some vehicle control
settings.
To enter the customizing mode,
press the SEL/RESET button. If
you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shift lever out
of Park, the display will change to
the normal screen.
You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separate ly. If ‘‘DRIVER
1’’ or ‘‘DRIVER 2’’ is not displayed,
cu stomizing is not possible.
To have the driver’s ID detected,
make sure your remote transmitter
is linked to the system (see Keyless
Memory Settings on page ).If
you want the settings as they were
when the vehicle left the factory,
select DEFAULT ALL, as described
on page .
Ref er to the table on the f ollowing
pages about the settings you want to
customize. If you want to change any vehicle
control settings, select CHG
SETTING, then press the SEL/
RESET button.
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park. 86
139TM
CONT INUED
Multi-Inf ormation Display
Customize Settings
Inst rument s and Cont rols
83
TM
—

—yy
()-yy