light Acura MDX 2008 User Guide

Page 99 of 489

ÛÝ
CONT INUED
Auto Interior Illumination
You can choose this customize item
f rom ‘‘METER SETUP’’ by pressing
the INFO ( / ) button repeatedly.
When your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘ELAPSED TIME RESET’’ and
repeat the procedure again. While the headlight switch is turned
on, the interior lights gradually dim,
as the outside light level gets low.
You can customize at which outside
light level the lights start to dim.
ThereareMAX,HIGH,MID,LOW
and MIN levels and OFF for the auto
interior illumination settings.
If you want the illuminations to start
dimming as early as possible, select
MAX. For illuminations to start
dimming as late as possible, select
MIN. Choose HIGH, MID, or LOW
f or levels in between.
To disable the auto interior
illumination f unction, select OFF.
Multi-Inf ormation Display
Inst rument s and Cont rols
95
\f—\f—\fy\fy
()-
\fy\f
\f\fy
2008 MDX

Page 104 of 489



ÛÝ
ÛÝ
INTERIOR LIGHT
DIMMING TIME
HEADLIGHT AUTO OFF TIMER
AUTO LIGHT SENSITIVITY
While ‘‘LIGHTING SETUP’’ is
shown, press the SEL/RESET
button to enter the customize mode.
Each time you press the INFO ( / ) button, the screen changes as
shown in the illustration. Press the
INFO ( / ) button until you see
the setting you want to customize,
then press the SEL/RESET button
to enter your selection.
Here are the three custom settings
f or the lighting setup:
Lighting Setup
Multi-Inf ormation Display
100
SEL/RESET
BUTTON
INFO ( or )
BUTTON
\f—\f—\fy\f\fy
()-
\fy\f
\fy
2008 MDX

Page 105 of 489

ÛÝÛÝ
CONT INUED
Interior Light Dimming Time
The interior lights f ade out when you
close all doors and tailgate. To
change how long the lights stay on
before they fade out, follow these
instructions:
You can choose this customize item
f rom ‘‘LIGHTING SETUP’’ by
pressing the INFO ( / ) button
repeatedly.Press the SEL/RESET button to see
the selections.
When your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘INTERIOR LIGHT DIMMING
TIME’’ and repeat the procedure
again.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
Multi-Inf ormation Display
Inst rument s and Cont rols
101
\f—\f—\fy\f

y
()-
\fy\f
\fy
2008 MDX

Page 106 of 489

ÛÝÛÝ
Headlight Auto Of f Timer
You can choose this customize item
f rom ‘‘LIGHTING SETUP’’ by
pressing the INFO ( / ) button
repeatedly.Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
The headlights, parking lights, side
marker lights, taillights, and license
plate lights go of f af ter the selected
time when you remove the key f rom
the ignition switch and close the
driver’s door. To change how long
thelightsstayonbeforetheygooff,
f ollow these instructions:
Multi-Inf ormation Display
102
\f—\f—\fy\f
y
()-
\fy\f
\fy
2008 MDX

Page 107 of 489

ÛÝ
µ µ

µ µ
CONT INUED
Auto Light Sensitivity
The headlights automatically come
on when the headlight switch is in
the AUTO position and the ambient
light reaches a changeable level. You
can select the auto light sensitivity
f rom the f ollowing f ive levels:
You can choose this customize item
f rom ‘‘LIGHTING SETUP’’ by
pressing the INFO ( / ) button
repeatedly.
When your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘HEADLIGHT AUTO OFF TIMER’’
and repeat the procedure again.
MIN
Theheadlightscomeonwhenitis
dark.
MAX
Theheadlightscomeonwhenitis
bright.
HIGH
Theheadlightscomeonwhenitis
somewhat bright.
MID
Theheadlightscomeonwhenitisas
bright as sunset or sunrise.
LOW
Theheadlightscomeonwhenitis
somewhat dark.
Multi-Inf ormation Display
Inst rument s and Cont rols
103
\f—\f—\fy\fy
()-
\fy\f
\fy
2008 MDX

Page 108 of 489

ÛÝWhen your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to ‘‘AUTO
LIGHT SENSITIVITY’’ and repeat
the procedure again.
Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
Multi-Inf ormation Display
104
\f—\f—\fy\fy
()-
\fy\f
\fy
2008 MDX

Page 114 of 489

ÛÝÛÝ
Keyless Lock Acknowledgment
When you push the LOCK button on
the remote transmitter, some
exterior lights f lash, and a beeper
sounds when you push the LOCK
button again within 5 seconds to
verify that the doors and the tailgate
arelockedandthesecuritysystem
has set (see page ). You can
customize the exterior lights not to
f lash and the beeper not to sound.
You can choose this customize item
f rom ‘‘DOOR/WINDOW SETUP’’ by
pressing the INFO ( / ) button
repeatedly.Press the SEL/RESET button to see
the selections.
Select ON or OFF by pressing the
INFO ( / ) button, then enter
your selection by pressing the SEL/
RESET button.
269
Multi-Inf ormation Display
110
\f—\f—\fy\fy
()-
\fy\f

y
2008 MDX

Page 119 of 489







Î To use the horn, press the center pad of the steering wheel. If equipped
1:
2:
Controls Near the Steering Wheel
Inst rument s and Cont rols
115
DRIVING POSITION
MEMORY SYSTEM VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
REAR WINDOW
DEFOGGER
HAZARD WARNING
BUTTON
MIRROR CONTROLS PASSENGER AIRBAG
OFF INDICATOR INSTRUMENT PANEL
BRIGHTNESS
WINDSHIELD
WIPERS/WASHERS
STEERING WHEEL
AUDIO CONTROLS
FUEL FILL DOOR
RELEASE BUTTON HEADLIGHT/TURN SIGNAL/
FRONT FOG LIGHTS
POWER DOOR LOCK
MASTER SWITCH POWER WINDOW
SWITCHES SEAT HEATER
SWITCHES
(P.117)
(P.122)
(P.122) (P.34) (P.123)
(P.116)
(P.118)
(P.130) ACCESSORY POWER
SOCKETS
HORN
HEADLIGHT WASHER
SWITCH
ACTIVE DAMPER
SYSTEM SWITCH
(P.233)
(P.360)
(P.155)
(P.157)
(P.149)
(P.323) (P.166)
(P.148)
(P.361)
CRUISE CONTROL
BUTTONS
STEERING WHEEL
ADJUSTMENTS
(P.124)
POWER TAILGATE
BUTTON (P.132)
HOOD RELEASE
HANDLE
(P.325) (P.270)
2
1
1
1
 — — y  y
()-
 y 
 y
2008 MDX

Page 121 of 489

The headlight washers can be
operated at any time by pressing the
headlight washer button located next
to the steering wheel column. The
headlights must be turned on to use
this button. In addition, the headlight
washer operates without pressing
the button, at the first time you turn
on the windshield washers af ter you
turn the ignition switch to the ON
(II) position.The headlight washers use the same
f luid reservoir as the windshield
washers.
Rotate the switch clockwise to
turn the rear window wiper ON.
Hold past ON to turn the rear
window wiper on and to spray the
rear window washer.
1.
2.
CONT INUED
Windshield Wipers and Washers
Headlight Washers
(On Canadian models)Rear Window Wiper and Washer
Inst rument s and Cont rols
117
\f—\f—\fy\f
y
()-
\fy\f
y
2008 MDX

Page 122 of 489

µµ
Rotate the switch
counterclockwise to spray the
window washer.
When you shif t the transmission
to the reverse position with the
f ront windshield wipers activated,
the rear window wiper operates
automatically.
When the wiper control lever
position is INT, the rear wiper
operates intermittently. When it is
LO or HI, the rear wiper operates
continuously. Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the key
removed f rom the ignition switch,
you will hear a reminder chime when
you open the driver’s door.
Turn signal
Of f
Parking and indicator lights
AUTO
Headlights on
High beams
Flashhighbeams
Fog lights of f
Fog lights on
Therearwindowwasherusesthe
same f luid reservoir as the wind-
shield washer. When you turn the wiper switch to
the ‘‘OFF’’ position, the wiper will
return to its parked position.
Turning the
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
1.
2.
3.
4.
5.
6.
7.
8.
9.
3.
4.
Turn Signal
Turn Signal and Headlights
Headlights On
Windshield Wipers and Washers, Turn Signal and Headlights
118
\f—\f—\fy\fy
()-
\fy\f
y
2008 MDX

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 ... 120 next >