ECU Acura RDX 2007 User Guide

Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure enough to
stay upright during normal driving
maneuvers. If the child seat is not
secure, unlatch the belt, allow it to
retract f ully, then repeat these
steps.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt. To deactivate the lockable retractor
and remove a child seat, unlatch the
buckle, unroute the seat belt, and let
the belt fully retract. A child seat with a tether can be
installed in any seating position in
the back seat.
Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
4.
5.
Installing a Child Seat
Installing a Child Seat with a
Tether
52
TETHER ANCHORAGE POINT
——
y
y
() yy

Tighten the strap according to the
seat maker’s instructions.
Attach
the tether strap hook to the
anchor, making sure the tether
strap is not twisted.
Remove
the cargo area cover, and
place it on the cargo area floor
(see page ). After
properly securing the child
seat (see page ), lift the head
restraint, then route the tether
strap over the seat-back and
th rough the head restraint legs.
Remove the head restraint (see
page ). Make sure the removed
he ad restraint is secured in the
cargo area. Reinstall the head
restraint when the child seat is
removed.
After properly securing the child
seat (see page ), route the
tether strap over the top of the
seat-back.
When you install the child seat in
the rear center seating position,
you cannot use the seat belt
behind the driver’s seat.
1.
4.
2.
3.
(Outer seating position)
(Rear center seating position)
51
146 51
167
Installing a Child Seat
Driver and Passenger Saf ety
53
TETHER STRAP HOOK
TETHER STRAP ANCHOR
——
y

y
() yy

If you decide that a child can saf ely
ride up f ront, be sure to:Caref ully read the owner’s manual,
and make sure you understand all
seat belt instructions and all saf ety
inf ormation.
Have the child sit up straight, back
against the seat, and feet on or
near the f loor. Move the vehicle seat to the rear-
most position. Devices intended to
improve a child’s comf ort or
reposition the shoulder part of a
seat belt can make the belt less
ef f ective and increase the chance
of serious injury in a crash.
This could result
in serious neck injuries during a
crash.
Check that the child’s seat belt is
properly and securely positioned. If they do, they
could be very seriously injured in a
crash. This could
cause very serious injuries during
a crash. It also increases the
chance that the child will slide
under the belt in a crash and be
injured.
Supervise the child. Even a mature
child sometimes needs to be
reminded to f asten the seat belt or
sit properly.Do not put any accessories on a seat belt.
Do not let a child wear a seat belt
across t he neck.
T wo children should never use thesame seat belt .
Do not let a child put the shoulder
part of a seat belt behind t he backor under t he arm.Additional Saf ety Precautions
Protecting L arger Children
Driver and Passenger Saf ety
57
——
y

y
() yy

CONT INUEDThe U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
Inst rument s and Cont rols
RDX model
63
ANTI-LOCK BRAKE SYSTEM (ABS)
INDICATOR
LOW OIL PRESSURE
INDICATOR LIGHTS ON INDICATOR
SH-AWD INDICATOR
LOW FUEL INDICATOR
CHARGING SYSTEM INDICATOR
A/T TEMPERATURE INDICATOR
MALFUNCTION INDICATOR LAMP
IMMOBILIZER
SYSTEM
INDICATOR
SECURITY SYSTEM INDICATORFOG LIGHT INDICATOR
TIRE PRESSURE MONITORING
SYSTEM (TPMS)INDICATOR
VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR
VSA ACTIVATION INDICATOR LOW TIRE PRESSURE INDICATOR
CRUISE MAIN INDICATORCRUISE CONTROL INDICATOR SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) INDICATOR
SEAT BELT REMINDER INDICATOR
(P.70)
(P.66) (P.74)
(P.69)DAYTIME RUNNING LIGHTS (DRL)
INDICATOR
(P.71) (P.70)
(P.72)
(P.71)
MAINTENANCE MINDER
INDICATOR (P.70)
HIGH BEAM INDICATOR
(P.69)
(P.71)
(P.67) (P.71)
(P.65,
393)
(P.66, 393)
(P.65, 394) (P.70)
(P.20, 65) (P.73, 309)
BRAKE SYSTEM INDICATOR (AMBER) (P.68,
396)
(P.33, 66)
SIDE AIRBAG OFF
INDICATOR (P.33, 67)
PARKING BRAKE AND
BRAKE SYSTEM
INDICATOR (RED)
(P.68, 395)
(P.73, 310)
(P.67, 307)
——
y


y
() yy

The U.S. instrument panel is shown. Differences for the Canadian models are noted in the text.
Instrument Panel
RDX with Technology Package model
64
ANTI-LOCK BRAKE SYSTEM (ABS)
INDICATOR
LOW OIL PRESSURE
INDICATOR LIGHTS ON INDICATOR
SH-AWD INDICATOR
LOW FUEL INDICATOR
CHARGING SYSTEM INDICATOR
A/T TEMPERATURE INDICATOR
MALFUNCTION INDICATOR LAMP
IMMOBILIZER
SYSTEM
INDICATOR
SECURITY SYSTEM INDICATORFOG LIGHT INDICATOR
VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR
VSA ACTIVATION INDICATOR CRUISE MAIN INDICATOR
CRUISE CONTROL INDICATOR SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) INDICATOR
SYSTEM MESSAGE INDICATOR (P.70)
(P.70)
(P.72)
(P.70)
(P.66) (P.74)
(P.69)
(P.71)
HIGH BEAM INDICATOR (P.70
) LOW TIRE PRESSURE INDICATOR
( P. 69)
(P.71)
(P.71)
(P.67)
(P.65, 393)
(P.66, 393)
(P.65, 394) (P.73, 309)
BRAKE SYSTEM INDICATOR (AMBER)
(P.33, 66) SIDE AIRBAG OFF
INDICATOR (P.33, 67)
PARKING BRAKE AND
BRAKE SYSTEM
INDICATOR (RED)
(P.68, 395)
(P.67, 307) (P.20, 65) (P.68,
396)
——
y


y
() yy

If you see a ‘‘CHECK DRL
SYSTEM’’ message on the multi-
info rmation display, there is a
problem in the high beam headlight’s
ci rcuit. Take your vehicle to a deal er
to have it checked (see page ).This
indicator comes on when the
security system is set. For more
info rmation, see page .
If
this indicator comes on when the
ignition switch is turned to the ON
(II) position and the parking brake is
rele ased, it means there is a problem
in the high beam headlight’s circuit.
Have your vehicle checked by your
dealer. This
indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning off the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door and remove the key
from the ignition switch.
This indicator comes on when you
turn on the f og lights. For more
inf ormation, see page . 122
85 240
On RDX with Technology Package
model
On RDX model only
Instrument Panel Indicators
Security System Indicator
Daytime Running L ights
Indicator Lights On Indicator
Fog L ight Indicator
Inst rument s and Cont rols
71
SECURITY SYSTEM INDICATOR
——
y

y
() yy

Î
Î
Î
Î
Î
Menu Item Page
Group Setup Setting Option
Description
DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGMENT
SECURITY RELOCK TIMER
AUTO DOOR UNLOCK 110
112
114
116
90
DOOR SETUP
(P.107)
DEFAULT ALL DRIVER DOOR
ALL DOORS
ON
OFF
30 sec
60 sec
90 sec
DRIVER’S DOOR WITH
SHIFT TO P
ALL DOORS WITH
SHIFT TO P
DRIVER’S DOOR WITH
IGN OFF
ALL DOORS WITH IGN
OFF
OFF
SET
EXIT
Changes which doors unlock with the remote
transmitter in a first push.
The exterior lights flash each time you press the
LOCK or UNLOCK button. A beeper will also
sound when you press the LOCK button twice.
Changes how long it takes (in seconds) for the
doors to relock and the security system to set after
you unlock and not opening the door.
Changes when the doors automatically unlock.
Changes all the customized settings as they were
the vehicle left the factory.
: Default setting
Multi-Inf ormation Display
Inst rument s and Cont rols
89
——
y

y
() yy

ÛÝÛ
Ý
ÛÝ
ÛÝ
CONTINUED
There are five settings to choose
from in the door setup:
AU TO DOOR LOCK
DOOR LOCK MODE
SECURITY RELOCK TIMER
KEYLESS
LOCK
ACKNOWLEDGMENT
AUTO DOOR UNLOCK
While CUSTOMIZE GROUP is
shown in the multi-info rmation
display, select DOOR SETUP by
pressing INFO ( / ) button, then
press the SEL/RESET button.
Each time you press the INFO ( /
) button, the screen changes as
shown in the illustration. Press the
INFO ( / ) button until you see
the setting you want to customize,
then press the SEL/RESET button
to enter your selection.
Multi-Information Display
Door Setup
Instrument sand Cont ro ls
107
Seepage108
See page 110
See page 112
Seepage114
See page 116
:
Press the SEL/
RESET button
or the Select/
Reset knob
: Press the INFO ( / ) button or
rotate the
Select/Reset knob
——
y


y
() y

y

ÛÝ
ÛÝ Press
the SEL/RESET button. The
screen changes as shown above.
Se lect ON or OFF by pressing the
INFO ( / ) button, then press the
SEL/RESET button to enter your
selection.
While
DOOR SETUP is shown in the
CUSTOMIZE GROUP of the multi-
info rmation display, press the SEL/
RESET button. The screen changes
to CUSTOMIZE MENU. Press the
INFO ( / ) button until you see
the above display.
When
you press the UNLOCK
button on the remote transmitter to
unlock the doors and the tailgate, the
exterior lights blink twice to veri fy
that the doors and the tailgate are
unlocked and the security system is
turned off.
When you push the LOCK button on
the remote transmitter, some
exterior lights flash, and a beeper
sounds when you push the LOCK
button again within 5 seconds to
verify that the doors and the tailgate
arelockedandthesecuritysystem
has set (see page ). You can
customize the exterior lights not to
f lash and the beeper not to sound. 140
Multi-Inf ormation Display
K eyless L ock A cknowledgment
112
——
y
y
() y

y

ÛÝ
ÛÝ
If you unlock the doors and the
tailgate with the remote transmitter,
but do not open any of the doors or
thetailgatewithin30seconds,the
doors and the tailgate automatically
relock and the security system sets.
You can change this relock time
f rom 30 seconds to 60 or 90 seconds.
Press the SEL/RESET button. The
screen changes as shown above.
Select the relock time you want (30,
60, or 90 seconds) by pressing the
INFO ( / ) button, then press the
SEL/RESET button to enter your
selection.
While DOOR SETUP is shown in the
CUSTOMIZE GROUP of the multi-
inf ormation display, press the SEL/
RESET button. The screen changes
to CUSTOMIZE MENU. Press the
INFO ( / ) button until you see
the above display.
Multi-Inf ormation Display
Securit y Relock T imer
114
——
y
y
() y

y