Acura RDX 2017 Manual PDF
Page 71 of 449
70
uuIndicators u
Instrument Panel
*1:On the left: Models without full color display 
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Supplemental 
Restraint System 
Indicator
●Comes on for a few seconds when 
you set the power mode to ON, 
then goes off.
●Comes on if a problem with any of 
the following is detected:
-Supplemental restraint system
- Side airbag system
- Side curtain airbag system
- Seat belt tensioner
●Stays on constantly or does not 
come on at all  - Have the vehicle 
checked by a dealer.
All-Wheel Drive 
( AWD ) with 
Intelligent 
Control System 
Indicator
*
●Comes on for a few seconds when 
you set the power mode to ON, 
then goes off.
●Comes on if there is a problem with 
the  AWD  with intelligent control 
system.
●Blinks when the  AWD with 
intelligent control system is 
overheated. The system is inactive.
●Stays on constantly  - the engine 
drives only the front wheels in this 
state. Have the vehicle checked by a 
dealer.
●Blinks while driving  - the engine 
drives only the front wheels in this 
state. Stop in a safe place, shift to 
(P, 
and idle the engine until the indicator 
goes off. If the indicator does not 
stop blinking, take your vehicle to a 
dealer.
2 All-Wheel Drive (AWD) with 
Intelligent Control System* 
P. 314
—
—
* Not available on all models 
Page 72 of 449
71
uuIndicators u
Continued
Instrument Panel
*1:On the left: Models wi thout full color display 
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Vehicle Stability 
Assist (VSA ®) 
System Indicator
●Comes on for a few seconds when 
you set the power mode to ON, then 
goes off.
●Blinks when VSA ® is active.●Comes on if there is a problem with 
the VSA® system or hill start assist 
system.
●Stays on constantly  - Have the 
vehicle checked by a dealer.
2 Vehicle Stability Assist (VSA ®), 
aka Electronic Stability Control 
(ESC), System  P. 309
Vehicle Stability 
Assist (VSA®) 
OFF  Indicator
●Comes on for a few seconds when 
you set the power mode to ON, then 
goes off.
●Comes on when you deactivate 
VSA ®.
2 VSA ® On and Off  P. 310—— 
Page 73 of 449
72
uuIndicators u
Instrument Panel
*1:On the left: Models without full color display 
On the right: Models with full color display
*2:Models without full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Door and 
Tailgate Open 
Indicator
*
●Comes on for a few seconds if you 
set the power mode to ON, then 
goes off.
●Comes on if any door or the tailgate 
is not completely closed.
●The beeper sounds and the indicator 
comes on if any door or the tailgate 
is opened while driving.
●Goes off when all doors and the 
tailgate are closed.
—
—
—
Electric Power 
Steering (EPS) 
System 
Indicator
●Comes on when you set the power 
mode to ON, and go es off when the 
engine starts.
●Comes on if there is a problem with 
the Electric Power Steering (EPS) 
System.
●Stays on constantly or does not 
come on at all  - Have the vehicle 
checked by a dealer.
2 If the Electric Power Steering 
(EPS) System Indicator Comes 
On  P. 422
*2
* Not available on all models 
Page 74 of 449
73
uuIndicators u
Continued
Instrument Panel
*1:On the left: Models wi thout full color display 
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Low Tire 
Pressure/TPMS 
Indicator
●Comes on for a few seconds when 
you set the power mode to ON.
●Comes on if the tire pressure of any 
of the tires becomes significantly 
low.
●Blinks for about one minute, and 
then stays on if there is a problem 
with the TPMS, or when a compact 
spare tire is temporarily installed.
●Comes on while driving  - Stop in a 
safe place, check tire pressures, and 
inflate the tire(s) if necessary.
●Blinks and remains on - Have the 
vehicle checked by a dealer. If the 
vehicle is fitted with a compact spare, 
get your regular tire repaired or 
replaced and put back on your vehicle 
as soon as you can.
Turn Signal and 
Hazard Warning 
Indicators
●The turn signal indicators blink when 
you operate the turn signal lever.
●If you press the hazard warning 
button, both indicators and all turn 
signals blink at the same time.
●Does not blink or blinks rapidly  - 
A turn signal light bulb has blown. 
Change the bulb immediately.
2 Front Turn Signal Light/Parking 
Light/Daytime Running Light 
and Front Side Marker Light 
Bulbs  P. 365——
High Beam 
Indicator●Comes on when the high beam 
headlights are on.——— 
Page 75 of 449
74
uuIndicators u
Instrument Panel
*1:On the left: Models without full color display 
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Lights On 
Indicator
●Comes on whenever the light 
switch is on, or in  AUTO when the 
exterior lights are on.●If you set the power mode to 
ACCESSORY or VEHICLE OFF (LOCK) 
while the lights are on, a chime sounds 
when the driver’s door is opened.
——
Fog Light 
Indicator*
●Comes on when the fog lights are 
on.———
Immobilizer 
System Indicator
●Comes on briefly when you set the 
power mode to ON, then goes off.
●Comes on if the immobilizer system 
cannot recognize the key 
information.
●Blinks  - You cannot start the engine. 
Set the power mode to VEHICLE OFF 
(LOCK), then select the ON mode 
again.
●Repeatedly blinks  - The system may 
be malfunctioning. Have the vehicle 
checked by a dealer.
●Do not attempt to alter this system or 
add other devices to it. Electrical 
problems can occur.
——
* Not available on all models 
Page 76 of 449
75
uuIndicators u
Continued
Instrument Panel
*1:On the left: Models wi thout full color display 
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Security System 
Alarm Indicator●Blinks when the security system 
alarm has been set.
2 Security System Alarm P. 137——
System 
Message 
Indicator
●Comes on for a few seconds when 
you set the power mode to ON, 
then goes off.
●Comes on along with a beep when 
a problem is detected. A system 
message on the multi-information 
display appears at the same time.
●While the indicator is on, press the 
 /   (information) button to see 
the message again.
●Refer to the Indicators information in 
this chapter when a system message 
appears on the multi-information 
display. Take the appropriate action for 
the message.
●The multi-information display does not 
return to the normal screen unless the 
warning is canceled, or the   /   
button is pressed.
—— 
Page 77 of 449
76
uuIndicators u
Instrument Panel
*1:On the left: Models without full color display 
On the right: Models with full color display
*2:Models with full color display
*3:Models without full color display
IndicatorNameOn/BlinkingExplanationMessage*1
CRUISE MAIN  
Indicator*
●Comes on when you press the 
CRUISE  button.
2Cruise Control * P. 279——
CRUISE 
CONTROL  
Indicator
*
●Comes on if you have set a speed 
for cruise control.
2 Cruise Control * P. 279——
Keyless Access 
System Indicator
●Comes on for a few seconds when 
you change the power mode to ON, 
then goes off.
●Comes on as soon as a problem is 
detected in the keyless access 
system or keyless starting system.
●Have your vehicle ch ecked by a dealer.
*2
*3
*2
*3
* Not available on all models 
Page 78 of 449
77
uuIndicators u
Continued
Instrument Panel
*1:On the left: Models wi thout full color display 
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Blind spot 
information (BSI) 
System 
Indicator
*
●Comes on for a few seconds when 
you change the power mode to 
ON, then goes off.
●Stays on while BS I is turned off.
—
●Comes on when mud, snow, or ice 
accumulates in the vicinity of 
sensor.●Comes on while driving  - Remove 
the obstacle in the vicinity of sensor.
2 Blind spot information (BSI) 
System* P. 311
●Comes on if there is a problem with 
the system.●Comes on while driving  - Have your 
vehicle checked by a dealer.
* Not available on all models 
Page 79 of 449
78
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Lane Departure 
Warning (LDW) 
Indicator
●Comes on for a few seconds when 
you change the power mode to ON, 
then goes off.
●Comes on if there is a problem with 
the LDW system.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
●Comes on when the LDW system 
shuts itself off.●Stays on  - The temperature inside the 
camera is too high.
Use the climate control system to cool down 
the camera.
The system activates when the temperature 
inside the camera cools down.
2 Front Sensor Camera* P. 282
●Stays on  - The area around the camera is 
blocked by dirt, mud, etc. Stop your vehicle 
in a safe place, and wipe it off with a soft 
cloth.
●Have your vehicle checked by a dealer if the 
indicator and message come back on after 
you cleaned the area around the camera.
2 Front Sensor Camera* P. 282
Models with LDW
* Not available on all models 
Page 80 of 449
79
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Adaptive Cruise 
Control (
ACC) 
Indicator (Amber)*
●Comes on for a few seconds when 
you set the power mode to ON, then 
goes off.
●Comes on if there is a problem with 
ACC.
●Comes on while driving  - Have your 
vehicle checked by a dealer.
Adaptive Cruise 
Control (
ACC) 
Indicator (Green)*
●Comes on when you press the  MAIN 
button.
2 Adaptive Cruise Control (ACC)* P. 284—
Lane Keeping 
Assist System 
(LKAS ) Indicator 
(Amber)
*
●Comes on for a few seconds when 
you set the power mode to ON, then 
goes off.
●Comes on if there is a problem with 
the LKAS.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
Lane Keeping 
Assist System 
( LKAS ) Indicator 
(Green)
*
●Comes on when you press the  MAIN 
button.
2 Lane Keeping Assist System (LKAS)* 
P. 301—
* Not available on all models