Lift Acura RL 2007 Owner's Manual

A child seat with a tether can be
installed in any seating position in
the back seat, using one of the
an chorage points shown above.
Since a tether can pro vide additional
security to the lap/shoulder belt
installation, we recommend using a
te ther whenever one is required or
available. Lift
the anchor cover, then attach
the tether strap hook to the
anchor, making sure the strap is
not twisted.
Tighten the strap according to the
seat maker’s instructions.
After properly securing the child
seat with the lap/shoulder belt
(see page ), pivot the head
restraint down (see page ) and
route the tether strap over the
head restraint.
1. 2.
3.
22 156
Installing a Child Seat
Installing a Child Seat with a
Tether
Driver and Passenger Saf ety
51
COVER TETHER STRAP
HOOK
ANCHOR
ANCHOR
TETHER ANCHORAGE P
OINTS
——
y
y
(yy

The rear beverage holder is in the
rear seat armrest. Open the
beverage holder by pushing the f ront
of it.To open the console compartment,
pull up on the lever and lif t the
armrest.
To close, lower the armrest, and
push it down until it latches.You can put small items in the tray
located in the console compartment
lid. To use the tray, pull up on the
lever, and lift the armrest pad.
The console compartment light is on
when the light switch is in the or position.
Console Compartment
Interior Convenience Items
Inst rument s and Cont rols
191
LEVER
LEVER
——
y
y
(y
y

Lif t the hood up most of the way.
The hydraulic supports will lif t it
uptherestof thewayandholdit
up.
If the hood latch handle moves
stif f ly, or if you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated. Reach between the hood and the
f ront bumper with your f inger.
Slide the latch handle up. To close the hood, lower the hood to
about a f oot (30 cm) above the
f ender, then f irmly press down on
the f ront edge of the hood. Make
sure it is securely latched.
3.
2.
Service Station Procedures
330
LATCH
——
y
y
(yy