wheel ACURA RL 2011 User Guide

ÛÝThe multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably. Others help to keep
you aware of the periodic
maintenance your vehicle needs f or
continued trouble-f ree driving.You can change the display and
customize your vehicle control
settings by pressing the SEL/RESET
or INFO buttons on the right side of
the steering wheel.With the ignition switch in the ON
(II) position, the lower part of the
multi-inf ormation display changes as
shown in the illustration, each time
you press the SEL/RESET button.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from the ON
(II) position to the ACCESSORY (I)
position, a ‘‘Goodbye’’ message is
shownonthedisplay.
Multi-Inf ormation Display
Inst rument s and Cont rols
71
U.S.
SEL RESET BUTTON
INFO ( / ) BUTTONS
Canada
10/08/04 18:53:54 31SJA660_076
ProCarManuals.com

This monitor shows how much
torque is being delivered to each
wheel. For more inf ormation, see
page .Whenthetirepressuremonitoris
shown on the multi-inf ormation
display, press the SEL/RESET
button. The display changes as
shown.
You can see the pressure of each tire
in this monitor. If one or more tires
are low, inflate them to the correct
pressure. For more inf ormation, see
page .You can receive or make phone calls
f rom your cell phone through your
vehicle’s
HandsFreeLink
(HFL) system without touching your
cell phone.
412
432
Bluetooth
Multi-Inf ormation Display
SH-AWD T orque Distribution
MonitorTire Pressure MonitorHandsFreeL inkBluet oot h
76
U.S.
Canada
10/08/04 18:54:56 31SJA660_081
ProCarManuals.com

ÛÝÛÝ
With the multi-information display
and the INFO ( / ) and SEL/
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings f or ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’. If ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’ is not displayed,
customizing is not possible.
To have the driver’s ID detected,
make sure your remote is linked to
the system (see
on page ). Then use your
remote to unlock the doors (see on page
). To enter the customizing mode,
press and hold the INFO ( / )
button for more than 3 seconds while
the multi-information display is in its
normal mode.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shif t lever out
of Park, the display will change to
the normal screen.
When the multi-information
display does not show the driver’s
ID. The f irst customizing menu is:
CHG SETTING (see page )
If you disconnect the battery, and
then do not unlock the door. DEFAULT ALL (see page )
You cannot customize the settings
under these conditions:
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park. Ref er to the f ollowing table f or a
brief summary of each customizable
setting and its default. For more
inf ormation, ref er to the page
number ref erences in the table.
When the driving memory settings
are off (see page ).
104
108 87
85
174
CONT INUED
Customized Settings
Memory Position
Link
K eyless A ccess Setup
Multi-Inf ormation Display
Inst rument s and Cont rols
81
DRIVER’S ID
10/08/04 18:56:11 31SJA660_086
ProCarManuals.com

ÎÎ Î Î
ÎÎ
Î Î
Î
Î
µ™¶ ™
µ™¶ ™
Î
Î
Î CUSTOMIZE ENTRY
CHG SETTING
(see page 87) CUST OMIZE GROUP
ACC SETUP
(see page 89)
MET ER SET UP
(see page 94)
POSITION SETUP
(see page 103) CUST OMIZE SET UP
ON
OFF
mph
km/h
ENGLISH
FRENCH
SPANISH 5°F 0°F 5°F
3°C 0°C 3°C
ON
OFF
IGN OFF
TRIP A
TRIP B
ON
OFF
ON
OFF Page
90
92
95
97
99
101
104
106
CUST OMIZE MENU
PRE-RUNNING CAR
DET ECT BEEP
ACC DISPLAY SPEED
UNIT
LANGUAGE
SELECTION
ADJUST OUTSIDE
TEMP. DISPLAY
TRIP A RESET with
REFUEL
ELAPSED TIME
RESET
MEMORY POSIT ION
LINK
AUTO TILT &
TELESCOPIC Description
Causes the system to beep when a vehicle
ahead of you gets too close.
Changes the ACC display speed unit.
Changes the language used in the display.
Changes the outside temperature reading
above or below its current reading.
Causes trip meter A, the average fuel
economy, and the average speed to reset
when you refuel.
Resets the elapsed time of your current
trip.
Changes the driver’s seat, the steering
wheel, and the outside mirror positions to
your stored setting.
Moves the steering wheel fully in and out
when you get in/out of the vehicle.
1:
2:
3: Default setting
Default setting for U.S. models
Default setting for Canadian model previous
setting
1
2 3 1
23
1 1
1
1
Multi-Inf ormation Display
82
10/08/04 18:56:19 31SJA660_087
ProCarManuals.com

ÛÝÛÝ
UsetheINFO( / )buttononthe
steering wheel to select the settings
and the SEL/RESET button to enter
your selections. If you want the settings as they were
when the vehicle lef t the f actory,
select DEFAULT ALL, as described
on this page.
If you want to set the def ault settings,
press the INFO ( / ) button to
select DEFAULT ALL, then press
the SEL/RESET button.If you want to cancel DEFAULT
ALL, select CANCEL, then press the
SEL/RESET button. The screen
goes back to CUSTOMIZE ENTRY.
If you want to change any vehicle
control settings, select CHG
SETTING, then press the SEL/
RESET button.
CONT INUED
DEFAUL T AL L
Multi-Inf ormation Display
Inst rument s and Cont rols
85
10/08/04 18:56:46 31SJA660_090
ProCarManuals.com

ÛÝ
When Memory Position Link is set
to ON, the driver’s seat, the steering
wheel, and the outside mirror
positions move to the positions
stored in memory. To cause the
memory to activate, open the driver’s
door with the remote, or grab the
door handle while carrying the
remote.
To set the seat memory position, see
page . For inf ormation on using
the remote, see page . While the multi-information display
is in the POSITION SETUP screen
of the CUSTOMIZE GROUP, press
the SEL/RESET button. The screen
changes to the above display.Press the SEL/RESET button. The
screen changes as shown above.
Select ON or OFF by pressing the
INFO ( / ) button, then press the
SEL/RESET button to enter your
selection.
164
174
Memory Posit ion L ink
Multi-Inf ormation Display
104
10/08/04 18:59:32 31SJA660_109
ProCarManuals.com

ÛÝÛÝ
When AUTO TILT & TELESCOPIC
is set to ON, the steering wheel
automatically moves f ully in and up
when you turn the ignition switch to
the LOCK (0) position and release it,
or when you remove the built-in key
from the ignition switch.
While the multi-information display
is in the POSITION SETUP screen
of the CUSTOMIZE GROUP, press
the SEL/RESET button. The screen
changes to CUSTOMIZE MENU.
Press the INFO ( / ) button until
you see the above display.Press the SEL/RESET button. The
screen changes as shown above.
Select ON or OFF by pressing the
INFO ( / ) button, then press the
SEL/RESET button to enter your
selection.
A ut o T ilt & T elescopic
Multi-Inf ormation Display
106
10/08/04 18:59:47 31SJA660_111
ProCarManuals.com

ÎÎ
Î Î
Î
Î
Î
Î
Î
Î
Î
Î
To use the horn, press the center pad of the steering wheel.
On models with navigation system, refer to the navigation system manual.
If equipped. Canadian models only
1:
2:
3:
4:
Controls Near the Steering Wheel
136
MIRROR CONTROLS
VEHICLE STABILITY ASSIST (VSA)
SYSTEM OFF SWITCH
PADDLE SHIFTERS
ADAPTIVE FRONT LIGHTING
SYSTEM (AFS) OFF SWITCH
(P.140, 142)
(P.137)
CRUISE CONTROL
BUTTONS
FRONT SEAT HEATER
SWITCHES
(P.145) (P.146)
DISTANCE BUTTON
(P.161)
(P.407)
(P.436) HEADLIGHT WASHER
BUTTON (P.138)
REMOTE AUDIO
CONTROLS (P.182)/
HEADLIGHTS/
TURN SIGNAL/
FOG LIGHTS
INSTRUMENT
PANEL BRIGHTNESS
(P.146)
WINDSHIELD
WIPER/WASHER
HAZARD WARNING BUTTON
(P.162)
ADAPTIVE CRUISE
CONTROL (ACC)
BUTTONS
FRONT SEAT HEATER AND
SEAT VENTILATION
BUTTONS
STEERING WHEEL
ADJUSTMENTS (P.148)BLUETOOTH HANDSFREELINK
VOICE CONTROL BUTTONS
(P.354)VOICE CONTROL BUTTONS(P.328, 333)
(P.278)
(P.304)HORN
(P.183)
MULTI INFORMATION
DISPLAY BUTTONS
(P.71)
(P.319, 324)
PASSENGER AIRBAG
OFF INDICATOR
(P.35)
REAR WINDOW
DEFOGGER BUTTON
(P.147)/
HEATED MIRROR
BUTTON
(P.316)/
COLLISION MITIGATION
BRAKING SYSTEM (CMBS)
OFF BUTTON
(P.423)
4
4
2 4
4
3
1
4
10/08/04 19:04:08 31SJA660_141
ProCarManuals.com

µPull back
and hold the wiper control lever.
The washers spray until you
release the lever. The wipers run
at low speed, then complete one
more sweep af ter you release the
lever.
The headlight washers can be
operated at any time by pressing the
headlight washer button located next
to the steering wheel column. The
headlights must be turned on to use
this button. In addition, the headlight
washer operates without pressing
the button at the first time you turn
on the windshield washers af ter you
turn the ignition switch to the ON
(II) position. The headlight washers use the same
f luid reservoir as the windshield
washers.
When you activate the windshield
washer with the headlights turned
on, the headlight washer will be
activated under certain conditions.
For more inf ormation, see sectioninthenextcolumn.
On Canadian models
Windshield Wipers and Washers
Windshield Washer Headlight Washers
Headlight
Washers Canadian models only
138
HEADLIGHT WASHER BUTTON
10/08/04 19:04:30 31SJA660_143
ProCarManuals.com

If the AFS indicator comes on and
starts blinking while driving, pull to
the side of the road when it is saf e,
andturnoff theengine.If theAFS
indicator keeps blinking, or starts
blinking again while driving af ter
turning the ignition switch to the ON
(II) position, the AFS is not working
properly (see page ). Have the
AFS inspected by your dealer.
When the AFS indicator comes on,
you will also see a ‘‘CHECK
ADAPTIVE FRONT LIGHTING
SYSTEM’’ message on the multi-
inf ormation display (see page ). Without AFS, your vehicle still has
normal lighting ability to continue
driving.
The adaptive f ront lighting system
(AFS) helps to improve visibility
during nighttime driving. The AFS
controls the aiming direction and
lighting distribution of the low
beams according to the amount of
turn applied to the steering wheel
during cornering or turning. Press
the AFS OFF switch to turn the AFS
on and off when the ignition switch
is in the ON (II) position and the
headlights are turned on.
69
69
If equippedAFS Indicator
A daptive Front L ighting System (A FS)
144
10/08/04 19:05:28 31SJA660_149
ProCarManuals.com