remote Acura TL 2004 User Guide

You can use the remote transmitter
or the key to operate the moonroof
f rom the outside. Ref er to pagef or details.
The moonroof has a key-of f delay.
You can still open and close the
moonroof f or up to 10 minutes af ter
you turn of f the ignition. The key-of f
delay cancels as soon as you open
either f ront door. You must then
turn the ignition to ON (II) for the
moonroof to operate.
100
Moonroof
Inst rument s and Cont rols
Operating the Moonroof with the
Remote Transmitter or the Key
102
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or its
motor.

The f ront ceiling light has a three-
position switch; ON, Door Activated,
and OFF.
Whenthe‘‘ ’’sideof theswitch
is pushed in, both f ront and rear
ceiling lights are ON all the time.
Whenthe‘‘ ’’sideispushedin,
the lights are of f all the time.When neither side is pushed in
(Door Activated), the lights come on
when you:
Open any door.
Unlock the doors with the key or
remote transmitter.
After all doors are closed tightly,
both f ront and rear ceiling lights
f ade out in 5, 15, or 30 seconds
depending on your custom setting
(see page ). Both f ront and rear ceiling lights
work as individual map lights. To
turn a map light on or of f , press its
lens. You can use the f ront map
lights regardless of the position of
the f ront ceiling light switch.
With the f ront ceiling light switch in
the OFF position, the rear map lights
do not work, and the interior lights
do not come on when you open a
door.
70
Interior Lights
Inst rument s and Cont rols
Ceiling L ight
104

ÛÝ´
µ ´
µ
´ µ
Three controls f or the audio system
are mounted in the steering wheel
hub. These let you control basic
f unctions without removing your
hand f rom the wheel. The VOL button adjusts the volume
up ( ) or down ( ). Press the top
or bottom of the button and hold it
until the desired volume is reached,
then release it.
If you are listening to the radio, use
the CH button to change stations.
Each time you press the top ( ) of
the button, the system goes to the
next preset station on the band you
are listening to. Press the bottom
( ) to go back to the previous
station.If youareplayingaCD,thesystem
skips to the beginning of the next
track each time you press the top
( ) of the CH button. Press the
bottom ( ) to return to the
beginning of the current track. Press
it again to return to the previous
track. You will see the disc and track
numbers in the display.
If youareplayingatape,pressthe
top ( ) of the CH button to advance
to the next selection. Press the
bottom( )togobacktothe
previous selection. The system
senses a silent period, then goes
back to Play mode.
The MODE button changes the
mode. Pressing the button
repeatedly selects FM1, FM2, AM,
XM Satellite Radio (U.S. models),
CD (if a CD is loaded), or a tape (if a
tape is loaded).
Comf ort and Convenience Feat ures
Audio System
Remote Audio Controls
139
MODE BUTTON
VOL BUTTON CH BUTTON

The security system sets
automatically 15 seconds after you
lock the doors, hood, and trunk. For
the system to activate, you must lock
the doors f rom the outside with the
key, lock tab, door lock switch, or
remote transmitter. The security
system indicator next to the driver’s
door lock starts blinking immediately
to show you the system is setting
itself .With the system set, you can still
open the trunk with the remote
transmitter without triggering the
alarm. The alarm will sound if the
trunk is opened with the trunk
releasebuttononthedriver’sdoor,
thetrunkreleasehandlebehindthe
trunk pass-through cover, or the
emergency trunk opener.
The security system will not set if
the hood, trunk, or any door is not
f ully closed. If the system will not set,
check the Door and Trunk Open
Monitor on the multi-inf ormation
display (see page ) to see if the
doors and trunk are f ully closed.
Since it is not part of the monitor
display, manually check the hood.
Do not attempt to alter this system
or add other devices to it.
The security system helps to protect
your vehicle and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lash if
someone attempts to break into your
vehicleorremovetheradio.This
alarm continues f or 2 minutes, then
the system resets. To reset an
alarming system bef ore the 2
minutes have elapsed, unlock the
driver’s door with the key or use the
remote transmitter.
Once the security system is set,
opening any door or the hood
without using the key or the remote
transmitter will cause the system to
alarm. It also alarms if the radio is
removed f rom the dashboard or the
wiring is cut. 60
Security System
Comf ort and Convenience Feat ures141
SECURITY SYSTEM LIGHT

µ
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
The HomeLink Transceiver stores
the code in a permanent memory.
There should be no need to retrain
HomeLink if your vehicle’s battery
goes dead or is disconnected.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink to operate it. They do not
have the safety feature that causes the motor to stop and reverse if an
obstacle is detected during closing,
increasing the risk of injury.
Always ref er to the opening
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with the HomeLink
Universal Transceiver. If you do not
have this information, contact the
manuf acturer of the equipment.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the f irst button. If you are training the second or
third buttons, go directly to Step 1.
Unplug the garage door opener
motor f rom the house current.
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom HomeLink. Make
sure you are not blocking your
view of the red light in HomeLink.
The HomeLink
Universal
Transceiver built into your vehicle
canbeprogrammedtooperateupto
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
Todothis,pressandholdthetwo
outside buttons on the HomeLink
transceiver for about 20 seconds,
until the red light f lashes. Release
the buttons, then proceed to Step 1.1.
2.
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
General Inf ormation
Important Saf ety Precautions
T raining HomeL ink
Bef ore you begin
145

Press and hold the remote control
button and one of the HomeLink
buttons at the same time.The remote control
you are training f rom may stop
transmitting after 2 seconds. This is
not long enough f or HomeLink to
learn the code. Release and press the
button on the remote control every 2
seconds until HomeLink has learned
the code.
The red light in HomeLink should
begin f lashing. It will f lash slowly
at first, then rapidly.
When the red light f lashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control.
Plug in the garage door opener
motor, then test the HomeLink
Transceiver button by pushing it. Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Inf ormation f rom
the remote control and the garage
door opener are needed bef ore
HomeLink can operate the garage
door opener.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The f ollowing procedure
synchronizes HomeLink to the
garage door opener so they send and
receive the correct codes.
If the button does not work, repeat
this procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
for2seconds,thenstayson,you
have a rolling code garage door
opener. Go to ‘‘Training With a
Rolling Code System’’.
3.
4.
5.
6.
7.
Canadian Owners:
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
T raining With a Rolling Code
System
146

Î..................................
Saf ety Belts .8, 19
.........
Safety Defects, Reporting . 268
.................................
Saf ety Features .7
...........................................
Airbags .9
..................................
Door Locks .11
..........................
Head Restraints .13
.......................................
Seat Belts .8
.....................
Seats & Seat-Backs .12
.............
Saf ety Labels, Location of . 47
...............................
Saf ety Messages . ii
................................
Satellite Radio .124
.....................................
Seat Belts .8, 19
...............
Additional Information . 19
Onboard Ref ueling Vapor
....................................
Recovery .260
..............................
Outside Mirrors .91
.....................
Outside Temperature .63
....................
Overheating, Engine .240
....
Owner’s Maintenance Checks . 198
..............
Panel Brightness Control . 75
........................
Park Gear Position .182
...........................................
Parking .187
...............................
Parking Brake .103
Parking Brake and Brake System ...............................
Indicator .52, 244
.................................
Parking Lights .74
..
Parking Over Things that Burn . 187
.............................
PGM-FI System .261
...............
Power Socket Locations . 106
.........
Pregnancy, Using Seat Belts . 17
.........
Protecting Adults and Teens . 11
...
Additional Safety Precautions . 18
.....
Advice f or Pregnant Women . 17
........................
Protecting Children .29
Installing a Child Seat Using ........................................
Latch .38 Installing a Child Seat with a
..................
Lap/Shoulder Belt . 40
Installing a Child Seat with a ......................................
Tether .41
.................
Selecting a Child Seat . 36
.......................
Protecting Inf ants .34
.......
Protecting Larger Children . 42
.........
Protecting Small Children . 35
..................
Protecting Your Discs . 134
...................
Radiator Overheating . 240
Radio/Cassette/Disc Sound ........................................
System .117
...................
Readiness Codes . 243,263
..
Rear Lights, Bulb Replacement . 215
..........................
Rear Seat Armrest .89
............................
Rear View Mirror .91
.................
Rear Window Def ogger . 77
...............
Reclining the Seat Backs . 88
.............................
Reminder Lights .52
................
Remote Audio Controls . 139
.......................
Remote Transmitter .85
Replacement Inf ormation ................
Engine Oil and Filter . 205..........................................
Fuses .245
................................
Light Bulbs .213
...........................................
Tires .224
.............................
Wiper Blades .219
Replacing Seat Belts Af ter a ............................................
Crash .21
...
Reserve Tank, Engine Coolant . 167
.........................
Restraint, Child .34 ,35
..................
Reverse Gear Position . 182
................................
Rotation, Tire .223
Index
P
RS
VI