oil Acura TL 2004 Owner's Manual

Your vehicle’s exhaust contains
carbon monoxide gas. You should
have no problem with carbon
monoxide entering the vehicle in
normal driving if you maintain your
vehicle properly.High levels of carbon monoxide can
collect rapidly in enclosed areas,
such as a garage. Do not run the
engine with the garage door closed.
Even with the door open, run the
engine only long enough to move the
vehicle out of the garage.With the trunk lid open, air f low can
pull exhaust gas into your vehicle’s
interior and create a hazardous
condition. If you must drive with the
trunk lid open, open all the windows,
and set the climate control system as
shown below.
If you must sit in your parked vehicle,
even in an unconf ined area, with the
engine running, adjust the climate
control system as f ollows:
Select the Fresh Air mode.
Select the mode.
Set the f an speed to high.
Set the temperature control to a
comfortable setting.
The vehicle is raised f or an oil
change.
You notice a change in the sound
of the exhaust.
The vehicle was in an accident
that may have damaged the under-
side.
Have the exhaust system inspected
f or leaks whenever:
1.
2.
3.
4.
Carbon Monoxide Hazard
Driver and Passenger Saf ety46
Carbon monoxide gas is toxic.
Breathing it can cause
unconsciousness and even kill
you.
Avoid any enclosed areas or
activities that expose you to
carbon monoxide.

Inst rument s and Cont rols
Instrument Panel
51
HIGH BEAM INDICATOR
CHARGING SYSTEM
INDICATOR
SUPPLEMENTAL
RESTRAINT
SYSTEM INDICATOR
LIGHTS ON
INDICATOR
CRUISE MAIN
INDICATOR
SEAT BELT REMINDER
INDICATOR
CRUISE CONTROL
INDICATOR
VEHICLE
STABILITY
ASSIST (VSA)
SYSTEM
INDICATOR
LOW OIL PRESSURE
INDICATOR MULTI-INFORMATION
DISPLAY
SIDE AIRBAG OFF
INDICATOR
ANTI-LOCK BRAKE
SYSTEM INDICATOR LOW FUEL INDICATORPARKING BRAKE AND
BRAKE SYSTEM INDICATOR
VSA ACTIVATION
INDICATOR
FOG LIGHT
INDICATOR
MALFUNCTION INDICATOR LAMP
IMMOBILIZER SYSTEM
INDICATOR
(P.54)
(P.52)
(P.53) (P.55)
(P.54) (P.55)
(P.54)
(P.52, 240)
(P.56) (P.52,
240) (P.56) (P.52,
243) (P.53)
(P.59)
(P.56)
(P.52)
(P.53)
(P.54)

The instrument panel has many
indicators to give you important
inf ormation about your vehicle.
If you turn the ignition switch to ON
(II) bef ore f astening your belt, the
beeper sounds and the indicator
f lashes. If you do not f asten your
seat belt bef ore the beeper stops, the
indicator stops f lashing but remains
on.The engine can be severely damaged
if this indicator f lashes or stays on
when the engine is running. For
more inf ormation, see page .
If this indicator comes on when the
engine is running, the battery is not
being charged. For more inf ormation,
see page .
See page .This indicator has two f unctions:
Itcomesonwhenyouturnthe
ignition switch to ON (II). It is a
reminder to check the parking
brake. Driving with the parking
brake not f ully released can
damage the brakes and tires.
If it stays on after you have fully
released the parking brake while
the engine is running, or if it
comes on while driving, it can
indicate a problem in the brake
system. For more inf ormation, see
page .
If you drive without releasing the
parking brake, a chime will sound,
and you will see a ‘‘RELEASE
PARKING BRAKE’’ message in the
Multi-Inf ormation Display.
If you continue driving without
f astening your seat belt, the beeper
sounds and the indicator f lashes
again at regular intervals, and you
will see ‘‘FASTEN SEAT BELT’’ in
the multi-information display. 1.
2.
243 244
242
242
Instrument Panel Indicators
Inst rument s and Cont rols
Seat Belt Reminder
Indicator L ow Oil Pressure
Indicator
Charging System
Indicator
Malf unction Indicator
Lamp Parking Brake and
Brake System
Indicator
52
Canada
U.S.

The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages. Some of
the messages help you operate your
vehiclemorecomfortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.
Here is a list of the messages you
can see. The f ollowing pages give
you more inf ormation on these
messages.Driver 1 or 2 Detected
Door and Trunk Open
Fasten Seat Belt
Release Parking Brake
Check Fuel Cap
Odometer
Trip Meter
Outside Temperature
Engine Oil Lif e Maintenance Messages
Trip Computer
Keyless Memory Settings
HandsFree Link
Language Selection (Canada only)
With the multi-information display
and the two buttons next to it, you
can also customize these vehicle
control settings to your liking. Auto door lock conditions
Auto door unlock conditions
Whenever unlocking (driver’s
door, or all doors)
Keyless lock acknowledgment
conditions
Security relock timer
Headlight auto of f timer
Interior light dimming time
To customize these control settings,
see page .
Low Windshield Washer Fluid
Level (Canada only) 66
Multi-Inf ormation Display
Inst rument s and Cont rols58
SELECT/
RESET
BUTTON
INFO
BUTTON
TM
TM

This shows the remaining lif e of the
engine oil. It shows 100% af ter the
engine oil is replaced and the display
is reset. The engine oil lif e is
calculated based on engine operating
conditions and accumulated engine
revolutions.When the engine oil lif e reaches 15
percent, the display shows
‘‘SERVICE DUE SOON’’ and the
code f or the maintenance items to be
perf ormed.
When the engine oil lif e reaches 5
percent, the display shows
‘‘SERVICE DUE NOW’’ along with
the same maintenance items.Have your dealer do the indicated
maintenance as soon as you see this
message, and have them reset the
display af ter completing the service.
If you do not perf orm the indicated
maintenance or do not reset the
display, the message changes to
‘‘SERVICE PAST DUE’’ when the
engine oil lif e becomes 0 percent.
These messages appear on the multi-
inf ormation display each time you
turn the ignition switch to ON (II).
For details on engine oil lif e and
maintenance messages, ref er to page
.
Also ref er to page f or important
maintenance saf ety precautions. 195
194
Multi-Inf ormation Display
Inst rument s and Cont rols
Engine Oil L if e Maintenance Messages
64

Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:Avoid full-throttle starts and rapid
acceleration.
Avoidhardbrakingforthefirst
200 miles (300 km).
Do not change the oil until the
multi-inf ormation display indicates
it is needed.
Youshouldfollowthesesame
recommendations with an
overhauled or exchanged engine, or
when the brakes are relined.
Your Acura is designed to operate on
unleaded gasoline with a pump
octane number of 91 or higher.
Useof aloweroctanegasolinecan
cause occasional metallic knocking
noises in the engine and will result in decreased engine perf ormance.
You may hear a knocking noise from
the engine if you drive the vehicle at
low engine speed (below about 1,000
rpm) in a higher gear. To stop this,
raise engine speed by shif ting to a
lower gear.
We recommend gasolines containing
detergent additives that help prevent
f uel system and engine deposits. In
addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it is
available, the use of gasoline that
does NOT contain manganese-based
f uel additives such as MMT.
Use of gasoline with these additives
may adversely af f ect perf ormance,
and cause the Malfunction Indicator
Lamp on your instrument panel to
come on. If this happens, contactyour authorized Acura dealer f or
service.
For f urther important f uel-related
inf ormation, please ref er to your
Quick Start Guide.
Some gasoline today is blended with
oxygenates such as ethanol or
MTBE. Your vehicle is designed to
operate on oxygenated gasoline
containing up to 10 percent ethanol
by volume and up to 15 percent
MTBE by volume. Do not use
gasoline containing methanol.
If you notice any undesirable
operating symptoms, try another
service station or switch to another
brand of gasoline.
On TL with manual transmission
Break-in Period, Gasoline T ype
Break-in Period
Gasoline Type
Bef ore Driving164

If it is near or below the lower mark,
seeon page .
Remove the dipstick again and
check the level. It should be
between the upper and lower
marks.
Look at the coolant level in the
radiator reserve tank. Make sure it is
between the MAX and MIN lines. If
it is below the MIN line, see
on page f or
inf ormation on adding the proper
coolant.
Refer to on page f or inf ormation
about checking other items on your
Acura.
Wait a f ew minutes af ter turning the
engine of f bef ore you check the oil.
Remove the dipstick (orange loop).
Wipe of f the dipstick with a clean
cloth or paper towel.
Insert it all the way back in its tube. 4.
1.
2.
3 198
204
207
Service Station Procedures
Oil Check
A dding OilEngine Coolant Check
A dding
Engine Coolant
Owner’s Maintenance
Checks
Bef ore Driving167
UPPER MARK
LOWER MARK
DIPSTICK RESERVE TANK
MINMAX

This section explains why it is
important to keep your vehicle well
maintained and how to f ollow basic
maintenance saf ety precautions.
This section also includes
instructions on how to read the
maintenance messages in the Multi-
Inf ormation Display, a Maintenance
Record, and instructions f or simple
maintenance tasks you may want to
take care of yourself .
If you have the skills and tools to per-
f orm more complex maintenance
tasks on your Acura, you may want
to purchase the Service Manual. See
page f or inf ormation on how to
obtain a copy, or see your Acura
dealer.......................
Maintenance Saf ety .194
....................
Maintenance Minder . 195
....................
Maintenance Record .200
..............................
Fluid Locations .202
......
Engine Compartment Covers . 203
........................
Adding Engine Oil .204
.........
Changing the Oil and Filter . 205
..............................
Engine Coolant .207
....................
Windshield Washers .208
....
Automatic Transmission Fluid . 209
........
Manual Transmission Fluid . 210
................
Brake and Clutch Fluid . 211
....................
Power Steering Fluid . 212
....................................
Hood Latch .212
.............................................
Lights .213
.......................................
Seat Belts .218
.....................................
Floor Mats .218
.................................
Wiper Blades .219
...............................................
Tires .220
...................
Checking the Battery . 226
.............................
Vehicle Storage .227
269
Maintenance
Maint enance193

One of the most convenient and
important f eatures of the Multi-
Inf ormation Display on your Acura is
the Maintenance Minder.
Based on engine operating
conditions and accumulated engine
revolutions, the onboard computer in
your Acura calculates the remaining
engine oil lif e.When the remaining engine oil lif e is
15 percent, you will see the message
‘‘SERVICE DUE SOON’’ along with
all maintenance items that are
needed at oil change time. Ref er to
page f or a complete list of the
maintenance main items and sub
items.
The system also displays the code
f or other scheduled maintenance
items needing service.
The remaining engine oil lif e is
displayed on the Multi-Inf ormation
Display as a percentage when you
turn the ignition switch to ON (II).
199
CONT INUED
Maintenance Minder
Maint enance195
MAINTENANCE
MAIN ITEMMAINTENANCE
SUB ITEMS

»¼»¼
When the remaining oil lif e is less
than5percent,youwillseethe
message ‘‘SERVICE DUE NOW’’
with the same maintenance items
you saw when ‘‘SERVICE DUE
SOON’’ was displayed. When you
see this message, have the indicated
maintenance perf ormed as soon as
possible. Your Acura dealer will reset the
display af ter completing the required
maintenance service. You will see
‘‘OIL LIFE 100%’’ on the display the
next time you turn the ignition
switch to ON (II).
If maintenance service is done by
someone other than your Acura
dealer, reset the display as f ollows:
Turn the ignition switch to ON (II).
Press the or button
repeatedly until the oil lif e is
displayed.
Press and hold the Select/Reset
button f or 10 seconds. The Multi-
Inf ormation Display will ask f or a
conf irmation.If you are sure you want to reset
the display, press the Select/
Reset button to select ‘‘OK’’.
If you do not want to reset the
display, press the or
button to select ‘‘Cancel’’.
1.
2.
3.
Maintenance Minder
Maint enance196