minder Acura TL 2006 Owner's Manual

µµ
µ
µ
µ
µ
Your safety, and the safety of others,
is very important. And operating this
vehicle safely is an important
responsibility.
Of course, it is not practical or
possible to warn you about all the
hazards associated with operating or
maintaining your vehicle. You must
use your own good judgement.
You will f ind this important saf ety inf ormation in a variety of f orms,
including:
on the vehicle.preceded by a saf ety alert symbol and one of
three signal words: , , or .
These signal words mean:
such as Important Saf ety Reminders or Important
Safety Precautions. such as Driver and Passenger Safety.
how to use this vehicle correctly and safely.
This entire book is f illed with important saf ety inf ormation please read it
caref ully.
To help you make inf ormed
decisions about saf ety, we have
provided operating procedures and
other inf ormation on labels and in
this manual. This inf ormation alerts
you to potential hazards that could
hurt you or others.
AFewWordsAboutSafety
Saf ety L abels
Saf ety Messages
Saf ety Headings
Saf ety Section
Instructions
DANGER WARNING CAUTION
ii
You WILL be KILLED or SERIOUSLY
HURT if you don’t follow instructions.
You CAN be KILLED or SERIOUSLY
HURT if you don’t follow instructions.
You CAN be HURT if you don’t follow
instructions.

Î
Î
Î
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
:
Instrument Panel
Inst rument s and Cont rols
59
HIGH BEAM INDICATOR
SUPPLEMENTAL
RESTRAINT
SYSTEM INDICATOR LIGHTS ON
INDICATOR
CRUISE MAIN
INDICATOR
SEAT BELT REMINDER
INDICATOR
CRUISE CONTROL
INDICATOR
VEHICLE
STABILITY
ASSIST (VSA)
SYSTEM
INDICATOR MULTI-INFORMATION
DISPLAY
LOW FUEL INDICATOR
VSA ACTIVATION
INDICATOR
MALFUNCTION INDICATOR LAMP
(P.62)
(P.60)
(P.61) (P.63)
(P.62) (P.62)(P.63)
(P.60)
(P.61)
(P.64)
(P.64)
(P.64)
LOW OIL PRESSURE INDICATOR
CHARGING SYSTEM INDICATOR FOG LIGHT INDICATOR (P.65)
TIRE PRESSURE MONITORING
SYSTEM INDICATOR
IMMOBILIZER SYSTEM INDICATOR ANTI-LOCK BRAKE SYSTEM INDICATOR
DAYTIME RUNNING LIGHT INDICATOR (P.63) LOW TIRE PRESSURE
INDICATOR
(P.65)
PARKING BRAKE AND
BRAKE SYSTEM INDICATOR
SIDE AIRBAG OFF
INDICATOR
(P.60,256) (P.60,256) (P.62,202)(P.61,201)
(P.60,257)(P.67)

The instrument panel has many
indicators to give you important
inf ormation about your vehicle. The engine can be severely damagedif this indicator f lashes or stays on
when the engine is running. For
more information, see page .
If this indicator comes on when the
engine is running, the battery is not
being charged. For more inf ormation,
see page .
See page .This indicator has two f unctions:
If it stays on after you have fully
released the parking brake while
the engine is running, or if it
comes on while driving, it can
indicate a problem in the brake
system. For more inf ormation, see
page .
This indicator comes on when you
turn the ignition switch to the ON
(II) position. It reminds you and your
passengers to f asten your seat belts.
A beeper also sounds if you have not
f astened your seat belt.
If you continue driving without
f astening your seat belt, the beeper
sounds and the indicator f lashes
again at regular intervals, and you
will also see a ‘‘FASTEN SEAT
BELT’’ message on the multi-
inf ormation display (see page ).
If you drive without releasing the
parking brake, a chime will sound,
and you will also see a ‘‘RELEASE
PARKING BRAKE’’ message on the
multi-inf ormation display (see page
).
If you turn the ignition switch to the
ON (II) position bef ore f astening
your seat belt, the beeper sounds,
and the indicator f lashes. If you do
notfastenyourseatbeltbeforethe
beeper stops, the indicator stops
f lashing but remains on. Itcomesonwhenyouturnthe
ignition switch to the ON (II)
position. It is a reminder to check
the parking brake. Driving with
the parking brake not f ully
released can damage the brakes
and tires.
1.
2.
69 256
256 257 258
70
Instrument Panel Indicators
Seat Belt Reminder
Indicator L ow Oil Pressure
Indicator
Charging System
Indicator
Malf unction Indicator
Lamp Parking Brake and
Brake System
Indicator
60
Canada
U.S.

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.This indicator has three f unctions.
Itcomesonasareminderthatyou
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. See page f or more
inf ormation on the VSA system. This indicator comes on when you
set the cruise control. See page
f or inf ormation on operating the
cruise control. This indicator comes on when you
turn on the cruise control system by
pressing the master button (see page ).
If itcomesonandstaysonatany
other time, or if it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. Take
your vehicle to a dealer to have it
checked. Without VSA, your vehicle
still has normal driving ability, but
will not have VSA traction and
stability enhancement. See page f or more inf ormation on the
VSA system. 1.
2.
3.
202
202 202153
153
Vehicle Stability Assist
(VSA ) System Indicator
VSA A ctivation Indicator
Cruise Main Indicator
Cruise Control Indicator
Instrument Panel Indicators
62

This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either theor position. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning of f the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door.
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
blink. All turn signals on the outside
of the vehicle should f lash.
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page ). This indicator comes on with the
high beam headlights. See pagef or inf ormation on the headlight
controls. If this indicator comes on when the
ignition switch is turned to the ON
(II) position and the parking brake is
released, it means there is a problem
in a circuit. Have your vehicle
checked by your dealer.
228
8484Canadian models only
Instrument Panel Indicators
Turn Signal and
Hazard Warning
Indicators ‘‘Daytime Running
Lights’’ Indicator
Lights On Indicator
High Beam Indicator
Inst rument s and Cont rols
63

This indicator also blinks several
times when you turn the ignition
switch f rom the ON (II) position to
the ACCESSORY (I) or the LOCK
(0) position.This indicator comes on when you
turn on the fog lights. See page
f or inf ormation on f og light
operation.
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to the ON (II) position. It then
goes of f if you have inserted a
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink and the engine
will not start (see page ).
This indicator is in the f uel gauge. It
comesonasareminderthatyou
must ref uel soon. When the indicator
comes on, there is about 1.2 U.S. gal
(4.5
) of f uel remaining in the tank
bef ore the needle reaches E. There
is a small reserve of f uel remaining
in the tank when the needle does
reach E.
91
85
U.S. models only
Immobilizer System
Indicator
L ow Fuel Indicator
Fog L ight Indicator
Instrument Panel Indicators
64
LOW FUEL INDICATOR

When you unlock and open the
driver’s door with the key, the
display shows ‘‘DRIVER 1
DETECTED’’ or ‘‘DRIVER 2
DETECTED’’, depending on which
remote transmitter was used last.
(The driver’s ‘‘ID’’ is determined by
the transmitter.)If you use the remote transmitter to
unlock the driver’s door, the display
shows ‘‘DRIVER
1DETECTED’’ or
‘‘DRIVER 2DETECTED’’ depending
on which transmitter you use, and
the driver’s seat and outside mirrors
move to the positions stored in that
transmitter (see page ).
If the trunk or any door is not closed
tightly, the display reminds you to
close the open trunk or the door(s)
bef ore you start driving. In addition to the seat belt reminder
in the instrument panel, the multi-
inf ormation display interrupts the
current display and shows ‘‘FASTEN
SEAT BELT’’ f or about 6 seconds if
you do not f asten your seat belt
while driving. This message repeats
if you ignore it and do not wear your
seat belt while the vehicle is moving.
103
Driver 1 or 2 Detected
Door and T runk OpenFasten Seat Belt
Multi-Inf ormation Display
69

µ
µ µ
Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
The rotating switch
on the lef t lever controls the lights.
Turning this switch to the ‘‘ ’’
position turns on the parking lights,
taillights, instrument panel lights,
side-marker lights, and rear license
plate lights. Turning the switch to
the ‘‘ ’’ position turns on the
headlights. If you leave the lights on
with the key removed from the
ignition switch, you will hear a
reminder tone when you open the
driver’s door. To switch f rom low
beams to high beams, push the lef t
lever f orward until you hear a click.
The blue high beam indicator will
come on (see page ). Pull it back
to return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beams will stay on as long as you
hold the lever back.
Turn Signal
Of f
Parking and instrument panel
Headlights on
Fog lights of f (U.S. models)
Fog lights on (U.S. models)
High beams
Flashhighbeams The headlights revert to normal
operation when you turn them on
with the switch. With the headlight switch of f orposition, the high beam
headlights come on with reduced
brightness when you turn the
ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch of f , even if you
set the parking brake.
1.
2.
3.
4.
5.
6.
7.
8. 63
Canadian models only
Turn Signal and Headlights
Turn Signal
Headlights
High Beams
Daytime Running L ights
84

The automatic lighting of f f eature
turns off the headlights, all other
exterior lights, and the instrument
panel lights within 15 seconds of
removing the key from the ignition
switch and closing the driver’s door.
You can change this 15 second timer
to 0, 30, or 60 seconds (see page ).The lights will turn on again when
you unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
will go off. With the driver’s door
open, you will hear a lights-on
reminder chime.
Push the button between the center
vents to turn on the hazard warning
lights (f our-way f lashers). This
causes all f our outside turn signals
and both indicators in the instrument
panel to f lash. Use the hazard
warning lights if you need to park in
a dangerous area near heavy traffic,
or if your vehicle is disabled.
The automatic lighting of f f eature
activates if you leave the headlight
switch in the ‘‘ ’’ or ‘‘ ’’
position, remove the key, open, then
close the driver’s door.
If you remove the key f rom the
ignition switch with the headlight
switch on, but do not open the door
and get out, the lights will turn of f
af ter 10 minutes. 79
Automatic Lighting Of f , Hazard Warning Button
Automatic L ighting Of f Feature
Hazard Warning Button
86

µµ
µ
µ
The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
You can insert or
remove the key only in this position.
To turn the key, you must push the
key in slightly. If your vehicle has an
automatic transmission, the shif t
lever must also be in park. If the f ront wheels are turned, the
anti-thef t lock may make it dif f icult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can
operate the audio system and the
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom the
ACCESSORY (I) to the ON (II)
position. You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or the
ACCESSORY (I) position and open
the driver’s door. Remove the key to
turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
Use this position
only to start the engine. The switch
returns to the ON (II) position when
you let go of the key.
LOCK (0) A CCESSORY (I)
ON (II)
ST A RT (III)
Ignition Switch
90
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control of the
vehicle.
Remove the key from the
ignition switch only when
parked.