Page 71 Acura TL 2008 Workshop Manual

Customized settings
(see page ).
Driving position memory
(see page ).
When you unlock the driver’s door
with a remote, that remote’s keyless
memory settings are activated.
Depending on which remote was
used, a WELCOME DRIVER 1 or
WELCOME DRIVER 2 message
appears on the multi-inf ormation
display. The driver’s ID (MEMORY
1 or MEMORY 2) is printed on the
back of each remote. Here are the settings activated by
the remote;
When you unlock and open the
driver’s door with the remote, the
driver’s seat (except power lumbar)
and outside mirrors move to the
positions stored in memory. An
indicator on one of the driving
position memory buttons also comes
on.
To turn of f this f eature, press and
hold the LOCK and UNLOCK
buttonsatthesametime.TheLED
in the remote will blink twice. Then
release the buttons. Doing this
cancels the keyless memory settings
f or that remote and restores the
def ault settings.
To turn the keyless memory settings
back on, repeat this procedure. The
LED will blink once to indicate the
f eature has been turned on.
77
108
K eyless Memory Settings
Remote Transmitter
102
TM
\f—\f—
y
\fy
(%\fy\f
\fy
2008 TL

µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 1213
The controls f or the power
adjustable front seats are on the
outside edge of each seat bottom.
You can adjust the seats with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving.
Moving the long horizontal switch on
the driver’s seat adjusts the seat
bottom in several directions. On the
passenger’s seat, the long horizontal
switch moves the seat only back and
f orth. The short vertical switch
adjusts the seat back angle.
The short horizontal switch on the
driver’s seat adjusts the degree of
lumbar support. Moves the seat forward
and backward.
Adjusts the seat-back
angle f orward or
backward.
Increases or decreases
the lumbar support.
(Driver’s seat only)
Moves the f ront of the
seat up or down. (Driver’s
seat only)
Moves the whole seat up
and f orward, or down
and backward. The front
of the seat also tilts up or
down at the same time.
(Driver’s seat only)
Raises or lowers the seat.
(Driver’s seat only)
Front Seat Power A djustments
Seats
Inst rument s and Cont rols
103
PASSENGER’S SEAT
DRIVER’S SEAT
\f—\f—
y
\fy
(%\fy\f
\fy
2008 TL

See pagef or important saf etyinf ormation and a warning aboutimproperly positioning head restraints. 13
All head restraints adjust f or height.
The tilt of the f ront head restraints is
also adjustable. You need both hands
to adjust the restraint. Do not
attempt to adjust it while driving. To
raise it, pull upward. To lower the
restraint, push the release button
sideways, and push the restraint
down. To adjust the tilt, pivot the
f ront head restraint to the desired
position.
The head restraints help protect you
and your passengers f rom whiplash
and other injuries. They are most
ef f ective when you adjust them so
the back of the occupant’s head rests
against the center of the restraint. A
taller person should adjust the
restraint as high as possible.
Head Restraints
Seats
104
RELEASE BUTTON
Failure to reinstall the head
restraints can result in severe
injury during a crash.
Always replace the head
restraints before driving.
\f—\f—
y
\fy
(%\fy\f
\fy
2008 TL

Make sure all items in the trunk and
those extending through the pass-
through are secured.
For security, this cover can be
locked and unlocked only with the
master key. To lock the cover, insert
thekey,andturnitclockwise.
Never drive with this cover open and
the trunk lid open.
See on
page .Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.Theinsidemirrorcanautomatically
darken to reduce glare. To turn on
this feature, press the button on the
bottom of the mirror. The AUTO
indicator comes on as a reminder.
When it is on, the mirror darkens
when it senses the headlights of a
vehicle behind you, then returns to
normal visibility when the lights are
gone. Press the button again to turn
of f this f eature.
52 Mirrors
Carbon Monoxide Hazard
Trunk Pass-through Cover, Mirrors
106
AUTO BUTTON SENSOR
INDICATOR
There is also a sensor on the back of
the mirror. Items hung on the mirror
may block this sensor and af f ect its
perf ormance.
\f—\f—
y
\f
y
(%\fy\f


y
2008 TL

The outside mirrors are heated to
remove fog and frost. With the
ignition switch in the ON (II)
position, turn on the heaters by
pressing the button. The indicator in
the button comes on as a reminder.
Press the button again to turn the
heaters off.
With the ignition switch in the ON
(II) position, move the selector
switch to the L (driver’s side), or R
(passenger’s side).
Push the edge of the adjustment
switch to move the mirror right,
lef t, up, or down.
When f inished, move the selector
switch back to the center (off)
position. Both outside door mirrors have a
reverse tilt f eature. When in
reverse, the selected mirror will
tilt down slightly to improve your
view as you parallel park. Shifting
out of reverse will return the
mirrors to their original position.
To tilt the driver’s mirror, place
the selector switch in the left
position.
To tilt the passenger’s mirror,
place the switch in the right
position.
To turn the feature off, place the
switch in the center position.
Outside mirror positions can be
stored in the driving position
memory system (see page ).
3.
1.
2.
108
Power Mirror Heaters
Adjusting the Power Mirrors
Mirrors
Reverse Tilt Door Mirror
Inst rument s and Cont rols
107
HEATED MIRROR BUTTON
SELECTOR SWITCH
ADJUSTMENT
SWITCH
\f—\f—
y
\fy
(%\fy\f

y
2008 TL

Two seat and outside mirror
positionscanbestoredinseparate
memories. You select a memorized
position by pushing the appropriate
button or using the appropriate
remote transmitter (Driver 1 or
Driver 2).Adjust the outside mirrors f or best
visibility (see page ).
Adjust the seat to a comfortable
position (see page ).
Turn the ignition switch to the ON
(II) position. You cannot add a
new driving position to the
memory unless the ignition switch
is in the ON (II) position. You can
recall a memorized position with
the ignition switch in any position.
Store a driving position only when
the vehicle is parked.
Your vehicle has a memory feature
f or the driver’s seat and outside
mirror positions.
Press and release the MEMO
button on the driver’s door. You
will hear a beep. Immediately
press and hold one of the memory
buttons (1 or 2) until you hear two
beeps. The indicator in the
memory button will come on. The
current positions of the driver’s
seat and outside mirrors are now
stored.
3.
1.
2.
107
103
Storing a Driving Position in
Memory
Driving Position Memory System
108
MEMO BUTTON
MEMORY BUTTONS
\f—\f—
y
\fy
(%\fy\f

y
2008 TL

Change the hour by pressing and
holding the H button until the
numbers advance to the desired time.
Change the minutes by pressing and
holding the M button until the
numbers advance to the desired time.
You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, press the R
button to set the clock back to the
previous hour. If the displayed time
is af ter the half hour, the clock sets
f orward to the beginning of the next
hour.
For example: 1:06 will reset to 1:001:52 will reset to 2:00
The clock is set automatically.
The clock displays the time with the
ignition switch in the ON (II)
position. If your vehicle’s battery is
disconnected or goes dead, you will
need to reset the clock.
The moonroof has a key-of f delay.
You can still open and close the
moonroof f or up to 10 minutes af ter
you turn of f the ignition switch. The
key-of f delay cancels as soon as you
open either f ront door. You must
then turn the ignition switch to the
ON (II) position f or the moonroof to
operate.
You can use the remote transmitter
or the key to operate the moonroof
f rom the outside. Ref er to page
f or details.
114
On models without navigation system
On models with navigation system
Clock
Operating the Moonroof with the
Remote Transmitter or the Key
Moonroof , Clock
116
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or its
motor.
\f—\f—
y
\fy
(%\fy\f

y
2008 TL

To apply the parking brake, pull the
lever up f ully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake
indicator on the instrument panel
should go out when the parking
brake is f ully released (see page ).
You will also see a ‘‘RELEASE
PARKING BRAKE’’ message on the
multi-inf ormation display (see page). 59
68
Parking Brake
Inst rument s and Cont rols
117
Driving the vehicle with the parking
brake applied can damage the rear
brakes and axles. A beeper will sound
if the vehicle is driven with the parking
brake on.
\f—\f—
y
\fy
(%\fy\f
y
2008 TL

The f ront ceiling light has a three-
position switch; ON, Door Activated,
and OFF.When neither side is pushed in
(Door Activated), the lights come on
when you:
Open any door.
Unlock the doors with the key or
remote transmitter.
After all doors are closed tightly,
both f ront and rear ceiling lights
f ade out in 5, 15, or 30 seconds
depending on your customized
setting (see page ). Both f ront and rear ceiling lights
work as individual map lights. To
turn a map light on or of f , press its
lens. You can use the f ront map
lights regardless of the position of
the f ront ceiling light switch.
With the f ront ceiling light switch in
the OFF position, the rear map lights
do not work, and the interior lights
do not come on when you open a
door.
Whenthe‘‘ ’’sideispushedin,
the lights are of f all the time.
Whenthe‘‘ ’’sideof theswitch
is pushed in, both f ront and rear
ceiling lights are ON all the time. 83
Ceiling L ight
Interior Lights
118
\f—\f—
y
\fy
(%\fy\f
y
2008 TL

Û
Ý When the indicator in the button is
on, air f rom the vehicle’s interior is
recirculated throughout the system.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
This button turns the rear window
def ogger of f and on (see page ).
The driver’s side temperature and
passenger’s side temperature can be
set separately. Press either side’s
button to increase the temperature
of airf low. Press either side’s
button to decrease it. When you set
the temperature to its lower limit or
its upper limit, it will be displayed as
‘‘Lo’’ or ‘‘Hi’’.
This button turns the air
conditioning on and of f . The A/C
ON indicator comes on in the display
when the A/C is on.
The climate control system in your
vehicle can also be operated using
the voice control system. See the
navigation section in your quick start
guide f or an overview of this system
and the navigation system manual
f or complete details.
Press the button to increase the
fanspeedandairflow.Pressthe
button to decrease it.
90
Only on models with navigation system
Voice Control System Recirculation Button
Rear Window Def ogger Button
Temperature Control Buttons
Air Conditioning (A/C) Button
Fan Control Buttons
Vents, Heating, and A/C
128
\f—\f—
y
\fy
(%\fy\f
y
2008 TL