lock Acura TL 2011 User Guide

Tighten the tether strap as
instructed by the child seat maker.
Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure.When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
Route the tether strap over the
head restraint, then attach the
tether strap hook to the anchor,
making sure the strap is not
twisted. With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle and remove any slack f rom
the lap portion of the belt.
7.
8.
9. 1.
CONT INUED
Installing a Child Seat
Installing a Child Seat
with a Lap/ Shoulder Belt
Driver and Passenger Saf ety
49
TETHER STRAP HOOK
ANCHOR COVER
10/07/29 11:46:00 31TK4620_054
2011 TL

Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps. To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt f eed back into the
retractor.To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt. Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.Push and pull the child seat
forward and from side-to-side to
verify that it is secure enough to
stay upright during normal
driving maneuvers. If the child
seat is not secure, unlatch the
belt, allow it to retract fully, then
repeat these steps.
2.
3.
4.
5.
Installing a Child Seat
50
10/07/29 11:46:07 31TK4620_055
2011 TL

To deactivate the lockable retractor
and remove a child seat, unlatch the
buckle, unroute the seat belt, and let
the belt fully retract.A child seat with a tether can be
installed in any seating position in
the back seat, using one of the
anchorage points shown above.
Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available. Af ter properly securing the child
seat with the lap/shoulder belt
(see page ), pivot the head
restraint down (see page ) and
route the tether strap over the
head restraint.
1.
49 157
CONT INUED
Installing a Child Seat
with a Tether
Installing a Child Seat
Using an Out er A nchor
Driver and Passenger Saf ety
51
TETHER ANCHORAGE POINTS TETHER STRAP HOOK
ANCHOR COVER
COVER
ANCHOR
10/07/29 11:46:15 31TK4620_056
2011 TL

This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach............................
Control Locations .62
............................
Instrument Panel .63
..........
Instrument Panel Indicators . 64
.............................................
Gauges .75
..................................
Fuel Gauge .75
...................
Temperature Gauge . 76
.............
Multi-Inf ormation Display . 77
Controls Near the Steering .........................................
Wheel .130
Windshield Wipers and .....................................
Washers .131
.......
Turn Signals and Headlights . 133
Automatic Lighting Off ...................................
Feature .135
.........
Daytime Running Lights . 136
.....................................
Fog Lights .137
......
Instrument Panel Brightness . 137
...............
Hazard Warning Button . 139
...............
Rear Window Def ogger . 139
......
Steering Wheel Adjustments . 140
.............................
Keys and Locks .141
......................
Immobilizer System .143
..............................
Ignition Switch .145
....................................
Door Locks .146
............
Childproof Door Locks . 147..............................................
Trunk .148
......
Emergency Trunk Opener . 150
.....................
Remote Transmitter .151
...............................................
Seats .155
......
Trunk Pass-through Cover . 160
...........................................
Mirrors .161
Driving Position Memory ........................................
System .164
................
Keyless Access System . 167
...........
Keyless Access Remote . 173
........
Engine Start/Stop Button . 177
..................................
Seat Heaters .196
............................
Power Windows .198
.......................................
Moonroof .202
...............................
Parking Brake .204
.........
Interior Convenience Items . 205
.....................
Beverage Holders .206
........
Accessory Power Sockets . 207
..................................
Glove Box .208
.............
Console Compartment . 208
............................
Vanity Mirror .209
...................................
Sun Visor .209
...........................
Center Pocket .210
....................
Sunglasses Holder .210
..................................
Coat Hook .211
...............................
Interior Lights .211
Instruments and Controls
Inst rument s and Cont rols
61
10/07/29 11:47:28 31TK4620_066
2011 TL

Î
Î
: If equipped
Control L ocations
62
GAUGES
MULTI-INFORMATION DISPLAYMIRROR CONTROLS
DRIVING POSITION
MEMORY SYSTEM
BUTTONS
POWER DOOR LOCK
MASTER SWITCH
POWER WINDOW
SWITCHES
TRUNK RELEASE
BUTTON
FUEL FILL DOOR RELEASE
BUTTON
HOOD RELEASE HANDLE
INSTRUMENT PANEL INDICATORS
MOONROOF SWITCH
HAZARD WARNING
BUTTON
(P.
63)
(P. 75)
(P.77)
(P. 162)
(P.164)
(P. 146)
(P.148) (P.
139)
AUDIO
CLIMATE CONTROL
SYSTEM
ACCESSORY POWER
SOCKET
AUTOMATIC
TRANSMISSION
ACCESSORY POWER
SOCKET
(P.
198)
(P. 445)
(P. 447)
(P.207)
HOMELINK BUTTONS
A/T model with navigation system is shown. MANUAL
TRANSMISSION
(P.
465 )
(P.
468)
(P. 207)
CLOCK
COMPASS
(P.
225 )
(P. 216)
(P.
202)
AUXILIARY INPUT JACK
SEAT HEATER SWITCHES
(P.
196)
USB ADAPTER CABLE (P. 254,263,340,350)
(P.
386)
(P.374)
(P. 379)
(P. 372)
10/07/29 11:47:36 31TK4620_067
2011 TL

ÎÎ
Î
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
Inst rument s and Cont rols
63
CRUISE MAIN INDICATOR CRUISE CONTROL INDICATORPARKING BRAKE AND
BRAKE SYSTEM
INDICATOR
HIGH BEAM INDICATOR
LOW FUEL INDICATOR IMMOBILIZER SYSTEM
INDICATOR
SIDE AIRBAG OFF INDICATOR
SH-AWD INDICATOR
LIGHTS ON INDICATOR LOW TIRE PRESSURE/TPMS INDICATOR
If equipped
: SECURITY SYSTEM INDICATOR
SUPPLEMENTAL RESTRAINT SYSTEM INDICATOR
ANTI-LOCK BRAKE SYSTEM (ABS) INDICATOR
KEYLESS ACCESS SYSTEM INDICATOR ELECTRIC POWER STEERING
(EPS) INDICATOR
FOG LIGHT INDICATOR VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR (P.
68)
(P.73)
(P. 68)
(P.74) (P.
69) (P.
72)
(P.
72)
(P.
67)(P.
73)
(P.
65)
(P.
70)
(P.
71)
(P.
67) (P.
66)
SYSTEM MESSAGE INDICATOR (P.
72)
MULTI-INFORMATION DISPLAY
SEAT BELT REMINDER INDICATOR (P. 64)
CHARGING SYSTEM INDICATOR
LOW OIL PRESSURE INDICATOR
MALFUNCTION INDICATOR LAMP
VEHICLE STABILITY
ASSIST (VSA) OFF
INDICATOR (P.
72)
(P. 71)
A/T model is shown. (P.
77)
(P. 71)
DOOR/TRUNK OPEN INDICATOR
(P.
71)
(P.
65, 561)
(P. 64, 561)
(P. 64, 562)
(P.65, 563)
10/07/29 11:47:46 31TK4620_068
2011 TL

Î
Î
If it stays on after you have fully
released the parking brake while
the engine is running, or if it
comes on while driving, it can
indicate a problem in the brake
system. You will also see a ‘‘LOW
BRAKE FLUID’’ or ‘‘CHECK
BRAKE SYSTEM’’ message on
the multi-information display. For
more information, see page . This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. It may also come on brief ly
when the ignition switch is turned to
the START (III) position. Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. ON Mode
is the equivalent of ON (II), and
START Mode is the equivalent
of START (III). For more
information, see pages
.
If this indicator comes on at any
other time, there is a problem in the
ABS. If this happens, take the
vehicle to your dealer to have it
checked. With this indicator on, your
vehicle still has normal braking
ability but no anti-lock f unction. You
will also see a ‘‘CHECK ABS
SYSTEM’’ message on the multi-
inf ormation display. For more
inf ormation, see page .
2.
:
178
482
563
Instrument Panel Indicators
Anti-lock Brake System
(A BS) Indicator
66
10/07/29 11:48:11 31TK4620_071
and 181
2011 TL

Î
ÎThis indicator comes on with the
high beam headlights. For more
inf ormation, see page .
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page ).
This indicator comes on when you
turn on the f og lights. For more
inf ormation, see page .
This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. This indicator
will also come on when the light
switch is in AUTO and the lights
turn on automatically. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position, without
turning of f the light switch, this
indicator will remain on. Reminder
beeps will also sound when you open
the driver’s door.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. VEHICLE
OFF (LOCK) Mode is the
equivalent of LOCK (0) and
ACCESSORY Mode is the
equivalent of ACCESSORY (I).
For more inf ormation, see pagesand . This indicator comes on red if any
door or the trunk lid is not closed
tightly.
You will also see a corresponding
indicator(s) on the multi-information
display to indicate which door and/
or the trunk is not closed tightly (see
page ).
136
: 134
137
178 181 12
Instrument Panel Indicators
High Beam Indicator
Fog L ight Indicator
Lights On Indicator
Door/Trunk Open
Indicator
Inst rument s and Cont rols
71
10/07/29 11:48:54 31TK4620_076
2011 TL

Î
Î
CONT INUED
You can select the displayed
language and also customize some
vehicle control settings to your liking
with the multi-information display
and the three buttons on the steering
wheel (see page ).
When you unlock and open the
driver’s door, the display shows
‘‘DRIVER 1’’ or ‘‘DRIVER 2’’
depending on which remote
transmitter/keyless access remoteyou use, and the driver’s seat and the
outside mirrors move to the position
stored in that remote transmitter/
keyless access remote (see
).
The driver’s ID (1 or 2) is displayed
when the power mode is set to ON.
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably. Others help to keep
you aware of the periodic
maintenance your vehicle needs f or
continued trouble-f ree driving.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. ON Mode
is the equivalent of ON (II). For
more inf ormation, see pagesand .
There are three types of messages:
normal display messages, engine oil
lif e and maintenance messages, and
system messages. 78
: 178 181
On models with keyless access system
Multi-Inf ormation Display
Normal Display Messages
Inst rument s and Cont rols
77
Remote transmitter/keyless
access remote 1 is used.
Remote transmitter/keyless
access remote 2 is used.
10/07/29 11:49:37 31TK4620_082
page 164
2011 TL

ÎÎ
Î
You can customize some vehicle
control settings. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park (automatic) or
with the parking brake set (manual). If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFTTOPARKTOCHANGE
SETTINGS’’ (automatic) or ‘‘MUST
STOP AND SET PARK BRAKE TO
CHANGE SETTINGS’’ (manual)
message and you cannot change the
settings.
You can customize some vehicle
control settings f or ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure the driver’s door is
unlocked with a corresponding
remote transmitter/keyless access
remote.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. VEHICLE
OFF (LOCK) Mode is the
equivalent of LOCK (0),
ACCESSORY Mode is the
equivalent of ACCESSORY (I),
and ON Mode is the equivalent
of ON (II). For more information,
see pages and
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, move the shif t lever out of
Park (automatic) or release the
parking brake (manual), the display
will change to the normal screen. :
178181 .
K eyless Memory Settings
Multi-Inf ormation Display
92
TM
10/07/29 11:51:45 31TK4620_097
2011 TL