brake system Acura TSX 2004 User Guide
Page 200 of 364
This section gives you tips on
starting the engine under various
conditions, and how to operate the
manual and automatic transmissions.
It also includes important inf orma-
tion on parking your car, the braking
system, the vehicle stability assist
system, and f acts you need if you are
planning to tow a trailer.........................
Preparing to Drive .198
.......................
Starting the Engine .199
Starting in Cold Weather ....................
at High Altitude .200
....
6-speed Manual Transmission . 201
.....
Recommended Shif t Points . 202
..............
Engine Speed Limiter . 202
.......................
Reverse Lockout .203
..............
Automatic Transmission . 204
.
Shif t Lever Position Indicator . 204
................
Shif t Lever Positions . 204
..............
Engine Speed Limiter . 209
....................
Shif t Lock Release . 210
...........................................
Parking .211
..............................
Parking Tips .211
.....................
The Braking System .212
.............
Brake Wear Indicators . 212
...............
Brake System Design . 213
.......................
Anti-lock Brakes .213
Important Saf ety .........................
Reminders .214
........................
ABS Indicator .214
...
Vehicle Stability Assist System . 216
...............
Driving in Bad Weather . 219
...........................
Towing a Trailer .221
Driving
Driving197
Page 209 of 364
µ
µµ µµ
µ
To shif t to Reverse
f rom Park, see the explanation under
Park. To shif t to Reverse f rom
Neutral, come to a complete stop and
then shift.
Your car has a reverse lockout so
you cannot accidentally shif t to
Reverse from Neutral or any other
driving position when the car speed
exceeds 5 6 mph (8 10 km/h).
If you cannot shif t to Reverse when
the car is stopped, press the brake
pedal and slowly shif t to Neutral, and
then to Reverse.
If there is a problem in the reverse
lockout system, or your car’s battery
is disconnected or goes dead, you
cannot shif t to Reverse. (Ref er to
Shif t Lock Release on page ). Use Neutral if you
need to restart a stalled engine, or if
it is necessary to stop brief ly with
the engine idling. Shif t to Park posi-
tion if you need to leave the car for
any reason. Press on the brake pedal
when you are moving the shif t lever
f rom Neutral to another gear. This position is simi-
lartoD,exceptonlythefirstthree
gears are selected. Use D when
towing a trailer in hilly terrain, or to
provide engine braking when going
down a steep hill. D can also keep
the transmission f rom cycling third,
fourth and fifth gears in stop-and-go
driving.
ForfasteraccelerationwheninD
or D, you can get the transmission
to automatically downshift by push-
ing the accelerator pedal to the
f loor. The transmission will shif t
down one, two or three gears,
depending on your speed.
Use this position f or
your normal driving. The transmis-
sion automatically selects a suitable
gear f or your speed and acceleration.
210
3
3
3
Automatic Transmission
Driving
Reverse (R) Neutral (N)Drive (D )
Drive (D)3
206
Page 214 of 364
µMake sure the parking brake is f ully
released bef ore driving away.
Driving with the parking brake
partially set can overheat or damage
the rear brakes.
Always use the parking brake when
you park your car. The indicator on
the instrument panel shows that the
parking brake is not f ully released; it
does not indicate that the parking
brakeisfirmlyset.Makesurethe
parking brake is set f irmly or your
car may roll if it is parked on an
incline.
If your car has an automatic
transmission, set the parking brake
bef ore you put the transmission in
Park.Thiskeepsthecarfrom
moving and putting pressure on the
parking mechanism in the
transmission making it easier to
move the shift lever out of Park
when you want to drive away. If the car is f acing uphill, turn the
f ront wheels away f rom the curb. If
you have a manual transmission, put
it in f irst gear.
If the car is f acing downhill, turn the
f ront wheels toward the curb. If you
have a manual transmission, put it in
reverse gear.
Make sure the moonroof and the
windows are closed.
Turn of f the lights.
Place any packages, valuables, etc.,
in the trunk or take them with you.
Lockthedoorswiththekeyorthe
remote transmitter.
Check the indicator on the
instrument panel to verif y that the
security system is set.
Never park over dry leaves, tall
grass, or other f lammable
materials. The three way catalytic
converter gets very hot, and could
cause these materials to catch on
fire.
Parking T ips
Parking
Driving211
Page 215 of 364
Put your f oot on the brake pedal only
when you intend to brake. Resting
your f oot on the pedal keeps the
brakes applied lightly, causing them
to build up heat. Heat build-up can
reduce how well your brakes work. It
also keeps your brake lights on all
the time, conf using drivers behind
you.Constant application of the brakes
when going down a long hill builds
up heat and reduces their ef f ective-
ness. Use the engine to assist the
brakes by downshif ting to a lower
gear and taking your f oot of f the
accelerator pedal.
Check your brakes af ter driving
through deep water. Apply the
brakes moderately to see if they f eel
normal. If not, apply them gently and
f requently until they do. Since a
longer distance is needed to stop
with wet brakes, be extra cautious
and alert in your driving.
Your Acura is equipped with disc
brakes at all f our wheels. A power
assist helps reduce the ef f ort needed
on the brake pedal. The ABS helps
you retain steering control when
braking very hard.
All f our brakes have audible brake
wear indicators.
When the brake pads need replacing,
you will hear a distinctive metallic
‘‘screeching’’ sound when you apply
the brakes. If you do not have the
brake pads replaced, they will begin
screeching all the time.
Your brakes may sometimes squeal
or squeak when you apply them
lightly. Do not conf use this with the
brakewearindicators.Theymakea
very audible ‘‘screeching.’’ Brake Wear Indicators
The Braking System
Driver and Passenger Saf ety212
Page 216 of 364
this defeats the
purpose of the ABS. Let the ABS
work f or you by always keeping f irm,
steady pressure on the brake pedal
as you steer away from the hazard.
This is sometimes ref erred to as
You will f eel a pulsation in the brake
pedal when the ABS activates, and
you may hear some noise. This is
normal; it is the ABS rapidly
pumping the brakes.
Activation varies with the amount of
traction your tires have. On dry
pavement, you will need to press on
thebrakepedalveryhardbeforeyou
activate the ABS. However, you may
feel the ABS activate immediately if
you are trying to stop on snow or ice.
The hydraulic system that operates
the brakes has two separate circuits.
Each circuit works diagonally across
the car (the lef t-f ront brake is
connected with the right-rear brake,
etc.). If one circuit should develop a
problem, you will still have braking
at two wheels.
Your car has an Anti-lock Brake
System (ABS) as standard
equipment. ABS helps to prevent the
wheels f rom locking up and skidding
during hard braking, allowing you to
retain steering control.
When the f ront tires skid, you lose
steering control; the car continues
straightaheadeventhoughyouturn
the steering wheel. The ABS helps to
prevent lock-up and helps you retain
steering control by pumping the
brakes rapidly; much f aster than a
person can do it.
The ABS also balances the f ront-to
rear braking distribution according
to car loading.
‘‘stomp and steer.’’
CONT INUED
A nti-lock Brakes
You should never pump the
brake pedal;
Brake System Design
The Braking System
Driving213
Front
Page 217 of 364
such as trying to take a
corner too f ast or making a sudden
lane change. Always drive at a safe,
prudent speed f or the road and
weather conditions.
Always steer moderately
when you are braking hard. Severe
or sharp steering wheel movement
can still cause your car to veer into
oncoming traffic or off the road. it
only helps with steering control
during braking. You should always
maintain a saf e f ollowing distance
f rom other vehicles. on loose or
uneven surf aces, such as gravel or
snow, than a car without anti-lock.
Slow down and allow a greater
distance between cars under those
conditions.
The ABS is self -checking. If anything
goes wrong, the ABS indicator on
the instrument panel comes on (see
page ). This means the anti-lock
f unction of the braking system has
shut down. The brakes still work like
a conventional system without anti-
lock, providing normal stopping
ability. You should have the dealer
inspect your car as soon as possible.61
Import ant Saf et y Reminders
A BS Indicat or
A BS will not prevent a skid that
results f rom changing direction
abruptly,
A BS cannot prevent a loss of
stability. A BS does not reduce the time or
distance it takes to stop the car;A car with ABS may require a
longer distance to stop
The Braking System
Driving214
ABS INDICATOR
Page 218 of 364
If the ABS indicator and the brake
system indicator come on together,
and the parking brake is f ully
released, the front-to-rear braking
distribution system may also shut
down.
Test your brakes as instructed on
page . If the brakes f eel normal,
drive slowly and have your car
repaired by your dealer as soon as
possible. Avoid sudden hard braking
which could cause the rear wheels to
lock up and possibly lead to a loss of
control.321
The Braking System
Driving215
Page 220 of 364
The VSA system indicator (see page) comes on and stays on when
there is a problem with the VSA
system. The VSA Activation
indicator will also come on.
The VSA system indicator may come
on along with the ABS indicator if
there is a problem with the anti-lock
brake system. If the VSA indicator comes on while
driving, pull to the side of the road
when it is saf e and turn of f the
engine. Reset the system by
restarting the engine, and watch the
VSA system indicator. If the
indicator remains on, or comes back
on while driving, have the VSA
system inspected by your Acura
dealer.
If the indicator does not come on
when the ignition switch is turned
ON(II),theremaybeaproblem
with the VSA system. Have your
dealer inspect your car as soon as
possible.
When VSA is off, the VSA Activation
Indicator light comes on as a
reminder. Pressing the switch again
turns the system back on. This switch is under the lef t vent.
Press it to turn the Vehicle Stability
Assist system on and of f .
Without VSA, your car will have
normal braking and cornering ability,
but it will not have VSA traction and
stability enhancement.
61
CONT INUED
VSA Syst em Indicat or
Vehicle Stability Assist (VSA) System
Driving
VSA Of f Switch
217
VSA SYSTEM INDICATOR
VSA OFF SWITCH
Page 226 of 364
Discuss your needs with your trailer
sales or rental agency, and f ollow the
guidelines in the rest of this section.
Also make sure that all equipment is
properly installed and that it meets
f ederal, state, province, and local
regulations. Towing can require a variety of
equipment, depending on the size of
your trailer, how it will be used, and
how much load you are towing.
The best way to confirm that car and
trailer weights are within limits is to
have them checked at a public scale.
Using a suitable scale or a special
tongue load gauge, check the tongue
load the f irst time you set up a
towing combination (a f ully-loaded
car and trailer), then recheck the
tongue load whenever the conditions
change.
Any hitch used on your car must be
properly bolted to the underbody.
Always use saf ety chains. Make sure
they are secured to both the trailer
and hitch, and that they cross under
the tongue so they can catch the
trailer if it becomes unhitched.
Leave enough slack to allow thetrailer to turn corners easily, but do
not let the chains drag on the ground.
Acura recommends that any trailer
having a total weight of 1,000 lbs
(450 kg) or more be equipped with
its own electric or surge-type brakes.
If you choose electric brakes, be
sure they are electronically actuated.
Do not attempt to tap into your car’s
hydraulic system. No matter how
successf ul it may seem, any attempt
to attach trailer brakes to your car’s
hydraulic system will lower braking
ef f ectiveness and create a potential
hazard.
Seeyourtrailerdealerformore
inf ormation on installing electric
brakes.
CONT INUED
Towing a Trailer
Driving
Hitches
Saf et y Chains Trailer Brakes
T owing Equipment and
A ccessories
Checking L oads
223
Page 227 of 364
All states and Canadian provinces
require some type of trailer lights.
Check requirements f or the areas
where you plan to tow.
You can get an optional trailer
lighting connector f or your car f rom
your Acura dealer.
If you use a converter, you can get
the connector and pins that mate
with the connector in your car f rom
your Acura dealer.Since lighting and wiring vary in
trailer type and brand, you should
also have a qualif ied mechanic install
a suitable connector between the car
and the trailer.
Always consult your Acura dealer
bef ore connecting the trailer lights
to your car’s lighting system.
Applicable
Light
Taillight
Brake Light
Back-up
Light
Right Turn
Signal
Left Turn
Signal
GroundWiring
Color
Red/Black
White/Black
Green/Black
Green/
Yellow
Green/Blue
Black
Ref er to the f ollowing table f or the
wiring color code.
Wiring Color Code f or Lighting
T railer L ights
Towing a Trailer
Driving224