ECU Acura TSX 2006 User Guide
Page 51 of 366
Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure enough to
stay upright during normal driving
maneuvers. If the child seat is not
secure, unlatch the belt, allow it to
retract f ully, then repeat these
steps.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt. To deactivate the locking
mechanism and remove a child seat,
unlatch the buckle, unroute the seat
belt, and let the belt f ully retract. Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available. A child seat with a tether can be
installed in any seating position in
the back seat, using the anchorage
points shown above.
4.
5.
Installing a Child Seat
Installing a Child Seat with a
Tether
50
COVER
ANCHOR ANCHORAGE POINTS
——y
y
(yy
Page 52 of 366
Af ter properly securing the child
seat (see page ), route the
tether strap over the seat-back.
Follow steps 2 and 3 f rom the
previous column.
Af ter properly securing the child
seat (see page ), lif t the head
restraint, then route the tether
strap over the seat-back and
through the head restraint legs. Lift the anchor cover, then attach
the tether strap hook to the
anchor, making sure the strap is
not twisted.
Tighten the strap according to the
seat maker’s instructions.
If the tether strap is too long and
cannot be tightened f irmly, f ind a
route where the strap can be
tightened securely.
1. 2.
3.
1.
2.
49
49
Installing a Child Seat
Using t he Cent er A nchor
Using an Out er A nchor
Driver and Passenger Saf ety
51
TETHER STRAP HOOK
TETHER STRAP HOOK
ANCHOR
ANCHOR
——y
y
(yy
Page 55 of 366
If you decide that a child can saf ely
ride up f ront, be sure to:Caref ully read the owner’s manual,
and make sure you understand all
seat belt instructions and all saf ety
inf ormation.
Move the vehicle seat to the rear-
most position.
Have the child sit up straight, back
against the seat, and feet on or
near the f loor.
Supervise the child. Even mature
children sometimes need to be
reminded to f asten the seat belts
or sit properly.
Of course, children vary widely. And
while age may be one indicator of
when a child can saf ely ride in f ront,
there are other important f actors you
should consider.
If the passenger’s front airbag
inf lates in a moderate to severe
f rontal collision, the airbag can cause
serious injuries to a child who is
unrestrained, improperly restrained,
sitting too close to the airbag, or out
of position.
A side airbag also poses risks. If any
part of a larger child’s body is in the
path of a deploying side airbag, the
child could receive possibly serious
injuries. The National Highway Traffic Safety
Administration and Transport
Canada recommend that all children
age 12 and under be properly
restrained in a back seat. Physically, a child must be large
enough f or the lap/shoulder belt to
properly f it (see pages and ). If
the seat belt does not f it properly,
with or without the child sitting on a
booster seat, the child should not sit
in f ront.
Check that the child’s seat belt is
properly positioned and secured.
To saf ely ride in f ront, a child must
be able to f ollow the rules, including
sitting properly, and wearing the seat
belt properly throughout a ride. 5217
Protecting L arger Children
Physical Size
Maturity
When Can a L arger Child Sit in
Front
54
——y
y
(yy
Page 62 of 366
Î
Î
Î The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
:
Instrument Panel
Inst rument s and Cont rols
61
HIGH BEAM INDICATOR
VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR
VSA ACTIVATION
INDICATOR
MALFUNCTION INDICATOR LAMP
FOG LIGHT
INDICATOR
LIGHTS ON INDICATOR
IMMOBILIZER
SYSTEM INDICATOR
MULTI-INFORMATION
DISPLAY
ANTI-LOCK BRAKE
SYSTEM (ABS)
INDICATOR
LOW FUEL
INDICATOR
CHARGING
SYSTEM
INDICATOR
LOW OIL PRESSURE
INDICATOR
CRUISE MAIN
INDICATOR
SEAT BELT
REMINDER
INDICATOR
SECURITY INDICATOR SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) INDICATORPARKING BRAKE AND BRAKE
SYSTEM INDICATOR
SYSTEM
MESSAGE
INDICATOR (P.64)
(P.66)
(P.69)
(P.62)
(P.67)
(P.67)(P.62)
(P.62) (P.66)(P.62)
(P.64)
(P.63)(P.63)
(P.66)
(P.66)
(P.65)
(P.65)
(P.66)
(P.64)
SIDE AIRBAG OFF INDICATOR
——y
y
(yy
Page 68 of 366
This indicator comes on when there
is a system message in the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.This indicator comes on when the
security system is set. For more
inf ormation, see page .
70
203
75
Security System Indicator
System Message
Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
67
SECURITY SYSTEM INDICATOR
——y
y
(yy
Page 89 of 366
Î
ÎÎ
Î Î
Î
Î
LIGHTING SETUP
DOOR · WINDOW
SETUP
WIPER SETUP
INTERIOR LIGHT
DIMMING T IME
HEADLIGHT AUT O OFF
TIMER
DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGEMENT
SECURTY RELOCK
TIMER
FRONT WIPER ACTION 15 sec
30 sec
60 sec
0sec
15 sec
30 sec
60 sec
DRIVER DOOR
ALL DOORS
ON
OFF
30 sec
60 sec
90 sec
WITH VEH SPD
INTERMITTENTSee page
105
See page 107
See page 110
See page 112
See page 114
See page 116
Default setting
Multi-Inf ormation Display
:
88
——y
y
(y
y
Page 110 of 366
There are three custom settings in
the Door · Window Setup:DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGEMENT
SECURITY RELOCK TIMER
While the multi-information display
shows ‘‘DOOR · WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Each time you press
the INFO button, the display
changesasshowninthenext
column.
To customize a setting, press the
INFO button repeatedly until you see
the setting you want to customize,
and press the SEL/RESET button.
Then f ollow the procedures
described on the f ollowing pages.
CONT INUED
Door · Window Setup
Multi-Inf ormation Display
Inst rument s and Cont rols
109
: Press the INFO Button.
——y
y
(y
y
Page 113 of 366
While the multi-information display
shows ‘‘DOOR·WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Then press the
INFO button repeatedly until you see
‘‘KEYLESS LOCK
ACKNOWLEDGMENT’’ as shown
above.Press SEL/RESET button, then
press the INFO button.
Each time you press the INFO
button, the display changes to ‘‘ON,’’
to ‘‘OFF,’’ then to ‘‘EXIT.’’
Select ‘‘ON’’ or ‘‘OFF’’ by pressing
the INFO button, and enter your
selection by pressing the SEL/
RESET button.
When you push the LOCK button on
the remote transmitter, the doors
and the trunk are set, and some
exterior lights f lash, and a beeper
sounds when you push the LOCK
button again within 5 seconds, and
the security system has set and a
horn sounds (see page ). You
can customize the exterior lights not
to f lash and the beeper not to sound.
203
K eyless L ock A cknowledgment
Multi-Inf ormation Display
112
——y
y
(y
y
Page 115 of 366
While the multi-information display
shows ‘‘DOOR·WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Then press the
INFO button repeatedly until you see
‘‘SECURITY RELOCK TIMER’’ as
shown above.Press the SEL/RESET button, then
press the INFO button.
Each time you press the INFO
button, the time changes f rom ‘‘30
sec,’’ to ‘‘60 sec,’’ and then to ‘‘90 sec.’’
If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock and
the security system sets.
You can change this relock time
f rom 30 seconds to 60 or 90 seconds.
Securit y Relock T imer
Multi-Inf ormation Display
114
——y
y
(y
y
Page 116 of 366
Select the desired relock time by
pressing the INFO button, and enter
your selection by pressing the SEL/
RESET button.If you f ail to enter your selection,
you will see the above display f or
several seconds, and the display goes
back to ‘‘CUSTOMIZE MENU.’’
Repeat the setup.
When your selection is entered, you
will see the above display for several
seconds, and then the display goes
back to ‘‘CUSTOMIZE MENU.’’ To exit ‘‘SECURITY RELOCK
TIMER,’’ press the INFO button
until you see ‘‘EXIT,’’ then press the
SEL/RESET button. The display
goes back to ‘‘CUSTOMIZE MENU.’’
Multi-Inf ormation Display
Inst rument s and Cont rols
115
——y
y
(y
y