display Acura TSX 2006 Owner's Guide
Page 78 of 366
CONT INUED
See page81
See page 82
See page 82
See page 82
See page 83 See page
83
See page 83
See page 84
See page 121
Multi-Inf ormation Display
Inst rument s and Cont rols
77
——y
y
(yy
Page 79 of 366
In addition to the Seat Belt Reminder
in the instrument panel, the multi-
inf ormation display interrupts the
current display and shows ‘‘FASTEN
SEAT BELT’’ or ‘‘PASSENGER
FASTEN SEAT BELT’’ if either the
driver or a f ront passenger does not
f asten their seat belt while driving.
This message remains displayed if
you or your passenger ignores it and
does not wear your seat belt while
the vehicle is moving.If the trunk or any door is not closed
tightly, the display reminds you to
close the open trunk or the door(s)
bef ore you start driving.
If you start driving without releasing
the parking brake, the multi-
inf ormation display interrupts the
current display and shows
‘‘RELEASE PARKING BRAKE.’’
This message continues, and a
chime sounds, until you release the
parking brake, or the vehicle speed
slows down to less than 1.8 mph (3
km/h).
Multi-Inf ormation Display
Fasten Seat Belt
Door and Trunk OpenRelease Parking Lever
78
U.S.Canada
——y
y
(y
y
Page 80 of 366
If you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
the driver’s door, you will see
‘‘REMOVE KEY’’ in the display and
hear a reminder beeper.If the brake f luid level is at or below
theMINmarkonthesideof the
brake f luid reservoir in the engine
compartment, you will see ‘‘BRAKE
FLUID LOW.’’ If you see this
message, have the brake system
checked by your dealer (see page
). If thefuelfillcapismissingornot
tightened properly, you will see
‘‘TIGHTEN FUEL CAP.’’ Make sure
the fuel cap is installed and tightened
at least one click.
288
CONT INUED
Multi-Inf ormation Display
Remove Key Brake Fluid LowTighten Fuel Cap
Inst rument s and Cont rols
79
U.S.Canada
——y
y
(yy
Page 81 of 366
If the f luid level in the windshield
washer reservoir gets low, you will
see ‘‘WASHER FLUID LOW’’ in the
multi-inf ormation display.
The TIGHTEN FUEL CAP message
should go of f af ter tightening the
f uel cap, turning the ignition switch
of f and on, then driving over 30 mph
(48 km/h) f or at least 45 seconds.
Due to dif f erent driving conditions, it
may take a few driving trips to make
the message go of f .
If a loose or missing f uel cap was not
the cause of the ‘‘TIGHTEN FUEL
CAP’’ message coming on, the
message will turn of f and the
Malf unction Indicator Lamp will
come on. If this happens, have your
vehicle checked by your dealer as
soon as possible.
If the level of the fuel in the tank
gets low, you will see ‘‘FUEL LOW’’
in the multi-information display, and
you must ref uel soon. The low f uel
indicator in the instrument panel will
also come on.
Canadian models only
Multi-Inf ormation Display
Washer Fluid L ow
Fuel Low
80
——y
y
(yy
Page 82 of 366
If the passenger’s side airbag has
automatically shut of f , you will see
‘‘PASSENGER SIDE AIRBAG OFF’’
in the multi-inf ormation display. See
page f or more inf ormation.If there is a problem with the vehicle
stability assist (VSA) system, you
will see ‘‘CHECK VSA SYSTEM’’ in
the multi-information display. If you
see this message, have the VSA
system checked by your dealer (see
page ).If the engine oil is very low or has
lost pressure, you will see ‘‘CHECK
ENGINE OIL LEVEL’’ in the multi-
inf ormation display. You will also see
the low oil pressure indicator in the
instrument panel f lashing or staying
on. If you see this message, you
should take immediate action since
serious engine damage is possible.
Follow the procedure on page .
34
255
323
CONT INUED
Multi-Inf ormation Display
Passenger Side A irbag Of f Check Engine Oil L evel
Check VSA Syst em
Inst rument s and Cont rols
81
U.S. Canada
——y
y
(yy
Page 83 of 366
If there is a problem in the anti-lock
brake system (ABS), you will see
‘‘CHECKABSSYSTEM’’inthe
multi-inf ormation display. If you see
this message, have your vehicle
checked by a dealer (see page ).
If there is a problem with the
automatic transmission, you will see
‘‘CHECK TRANSMISSION’’ in the
multi-inf ormation display. Avoid
rapid acceleration, and have the
transmission checked by a dealer as
soon as possible. If there is a problem with your f ront
airbags, side airbags, passenger’s
side airbag automatic cutoff system,
automatic seat belt tensioners, side
curtain airbags, driver’s seat position
sensor, or the f ront passenger’s
weight sensors, you will see
‘‘CHECK AIRBAG SYSTEM’’ in the
multi-inf ormation display. Take your
vehicle to a dealer as soon as
possible(seepage ).
253
34Automatic transmission:
Multi-Inf ormation Display
Check T ransmission Check A BS Syst emCheck A irbag Syst em
82
——y
y
(yy
Page 84 of 366
CONT INUED
If you see ‘‘CHECK CHARGING
SYSTEM’’ in the multi-inf ormation
display, it means the battery is not
being charged. See page f or
more inf ormation.If you see ‘‘CHECK EMISSION
SYSTEM’’ in the multi-inf ormation
display, it means one of the engine’s
emission systems may have a
problem. Have your vehicle checked
by a dealer (see page ).If there is a problem with the brake
system, you will see ‘‘CHECK
BRAKE SYSTEM’’ in the multi-
inf ormation display. The parking
brake and brake system indicator in
the instrument panel will also come
on. See page f or more
inf ormation.
324
324326
Multi-Inf ormation Display
Check Charging Syst em Check Emission Syst em Check Brake Syst em
Inst rument s and Cont rols
83
U.S.Canada
——y
y
(yy
Page 85 of 366
Canadian models onlyThis message comes on when you
set the cruise control. The Cruise
Control indicator in the instrument
panel will also come on. See pagef or inf ormation on the cruise
control operation. You can receive or make phone-calls
f rom your cell phone through your
vehicle’s HandsFreeLink (HFL)
system without touching your cell
phone.
To use the system, your cell phone
and the HFL system must be linked.
Not all cell phones are compatible
with this system. Ref er to page
for instructions on how to link
your cell phone to the HFL and how
toreceiveormakephonecalls.
If there is a problem in the high
beam headlight’s circuit, you will see
‘‘CHECK DRL SYSTEM’’ in the
multi-inf ormation display. If you see
this message, have your vehicle
checked by a dealer.
204
213
Multi-Inf ormation Display
Check DRL Syst emCruise Control HandsFreeL ink
84
U.S. model is shown
TM
——y
y
(yy
Page 86 of 366
You can customize some vehicle
control settings f or ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure you use your transmitter
to unlock the driver’s door.If you use the key to unlock the
driver’s door, the system cannot
recognize either ‘‘DRIVER 1’’ or
‘‘DRIVER 2.’’ In this case, when you
try to enter the customizing mode,
‘‘DRIVER UNKNOWN
CUSTOMIZE IMPOSSIBLE’’ will be
displayed, and you cannot customize
some of the settings.
With the ignition switch in the ON
(II) position, press and hold the
INFO button for more than 3
seconds. ‘‘CUSTOMIZE ENTRY’’
appears in the multi-inf ormation
display.
CONT INUED
Multi-Inf ormation Display
Customized Settings
Inst rument s and Cont rols
85
DRIVER’S
ID
——y
y
(yy
Page 87 of 366
To change the settings, stop the
vehicle, and make sure to set the
parking brake and put the
transmission in Park (A/T) or
neutral (M/T). If you try to enter the
customizing mode while the vehicle
is moving, the above message
appears and you cannot change the
settings.The f irst customizing menu is:
DEFAULT ALL CHANGE SETTING
EverytimeyoupresstheINFO
button, the display cycles from
‘‘CHANGE SETTING,’’ ‘‘DEFAULT
ALL,’’ ‘‘EXIT’’ and then back to
‘‘CHANGE SETTING.’’ Press the
SEL/RESET button to enter your
selection.
If you want the settings as they were
when the vehicle lef t the f actory,
select ‘‘DEFAULT ALL,’’ as
described on page . If you want to change any vehicle
control settings, select ‘‘CHANGE
SETTING,’’ and f ollow the
instructions on page .
You can also use the Select/Reset
knob in the instrument panel. Turn
the knob to select a setting and press
it to enter your selection. If you do not make any changes,
select ‘‘EXIT,’’ the display returns to
normal display.
89 91
Multi-Inf ormation Display
86
AT model MT model
——y
y
(yy