ECU Acura TSX 2008 User Guide

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle.To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt feed back into the
retractor.
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
1.2.
3.
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
48
\f—\f—
y
\fy
(\fy\f\fy
2008 TSX

Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure enough to
stay upright during normal driving
maneuvers. If the child seat is not
secure, unlatch the belt, allow it to
retract f ully, then repeat these
steps.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt. To deactivate the lockable retractor
and remove a child seat, unlatch the
buckle, unroute the seat belt, and let
the belt fully retract. Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
A child seat with a tether can be
installed in any seating position in
the back seat, using one of the
anchorage points shown above.
4.
5.
CONT INUED
Installing a Child Seat with a
Tether
Installing a Child Seat
Driver and Passenger Saf ety
49
COVER
ANCHOR ANCHORAGE POINTS
\f—\f—
y
\fy
(\fy\f\fy
2008 TSX

Af ter properly securing the child
seat (see page ), route the
tether strap over the seat-back.
Follow steps 2 and 3 f rom the
previous column.
Af ter properly securing the child
seat (see page ), lif t the head
restraint, then route the tether
strap over the seat-back and
through the head restraint legs. Lift the anchor cover, then attach
the tether strap hook to the
anchor, making sure the strap is
not twisted.
Tighten the strap according to the
seat maker’s instructions.
If the tether strap is too long and
cannot be tightened f irmly, f ind a
route where the strap can be
tightened securely.
1. 2.
3.
1.
2.
48
48
Using t he Cent er A nchor
Using an Out er A nchor
Installing a Child Seat
50
TETHER STRAP HOOK
TETHER STRAP HOOK
ANCHOR
ANCHOR
\f—\f—
y
\fy
(\fy\f\fy
2008 TSX

Devices intended to
improve a child’s comf ort or
reposition the shoulder part of a
seat belt can make the belt less
ef f ective and increase the chance
of serious injury in a crash.
This could result
in serious neck injuries during a
crash.
If they do, they
could be very seriously injured in a
crash.
If you decide that a child can saf ely
ride up f ront, be sure to:
This could
cause very serious injuries during
a crash. It also increases the
chance that the child will slide
under the belt in a crash and be
injured.
Caref ully read the owner’s manual,
and make sure you understand all
seat belt instructions and all saf ety
inf ormation.
Move the vehicle seat to the rear-
most position.
Have the child sit up straight, back
against the seat, and feet on or
near the f loor.
Check that the child’s seat belt is
properly positioned and secured.
Supervise the child. Even mature
children sometimes need to be
reminded to f asten the seat belts
or sit properly.
Do not put any accessories on a
seat belt.
Do not let a child wear a seat belt
across t he neck.
T wo children should never use thesame seat belt .
Do not let a child put the shoulder
part of a seat belt behind t he backor under t he arm.Additional Saf ety Precautions
Protecting L arger Children
54
\f—\f—
y


y
(\fy\f\fy
2008 TSX

The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
Inst rument s and Cont rols
61
ANTI-LOCK BRAKE
SYSTEM (ABS)
INDICATOR
HIGH BEAM INDICATOR
VSA ACTIVATION
INDICATOR
LIGHTS ON INDICATOR
MULTI-INFORMATION
DISPLAY
LOW FUEL
INDICATOR
SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) INDICATOR
(P.64)
(P.66)
(P.66)(P.65)
(P.66)
IMMOBILIZER SYSTEM INDICATOR
FOG LIGHT INDICATOR
SECURITY SYSTEM
INDICATOR (P.67)
(P.69)
(P.66) (P.19,62)
(P.32,64) (P.63)
(P.32,63)
PARKING BRAKE AND BRAKE
SYSTEM INDICATOR
SIDE AIRBAG OFF INDICATOR
MALFUNCTION INDICATOR LAMP
LOW OIL PRESSURE INDICATOR VEHICLE STABILITY ASSIST (VSA)
SYSTEM INDICATOR
(P.64)
CHARGING
SYSTEM
INDICATOR SEAT BELT REMINDER
INDICATOR
CRUISE MAIN
INDICATOR
(P.66)
SYSTEM MESSAGE
INDICATOR
(P.62,336) (P.62,335) (P.62,336)
(P.63,338)
(P.65,261)
(P.67,263) LOW TIRE
PRESSURE/
TPMS
INDICATOR
——
y
y
(yy
2008 TSX

This indicator comes on when the
security system is set. For more
inf ormation, see page .This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two f unctions:
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are signif icantly low
on pressure.
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
inf ormation display (see page ).
You may see one or more of the low
pressure tire positions displayed
along with this message.
Check the tire pressure monitor on
the multi-inf ormation display and
determinethecause(seepage). If this happens, pull to the side of the
road when it is safe, check which tire
has lost pressure on the multi-
inf ormation display, and determine
the cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinf lated, call a prof essional
towing service. For more
inf ormation, see page .
If this indicator begins to f lash,
there is a problem with the tire
pressure monitoring system
(TPMS). You will also see a
‘‘CHECK TPMS SYSTEM’’
message on the multi-inf ormation
display. The indicator continues to
f lash f or a while (approximately 1
minute), then stays on. If this
happens, have your dealer check
the system as soon as possible.
For more inf ormation, see page .
205 1.
265
265 345
2.
267
Instrument Panel Indicators
Security System Indicator Low Tire Pressure/
TPMS Indicator
Inst rument s and Cont rols
67
SECURITY SYSTEM INDICATOR
\f—\f—
y

y
(\fy\f\fy
2008 TSX

Î
ÎÎ
Î
Î Î
Î Customize Setup
15 sec
30 sec
60 sec
0sec
15 sec
30 sec
60 sec
DRIVER DOOR
ALL DOORS
ON
OFF
30 sec
60 sec
90 sec
WITH VEH SPD
INTERMITTENT Page
106
108
111
113
115
117
Customize Menu
INTERIOR LIGHT
DIMMING T IME
HEADLIGHT AUT O OFF
TIMER
DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGEMENT
SECURITY RELOCK
TIMER
FRONT WIPER ACTION Description
Changes how long (in seconds) the
interior lights stay on after you close the
doors.
Changes how long (in seconds) the
exterior lights stay on after you close the
driver’s door.
Changes which doors unlock with the
remote transmitter when the button is
pushed one time.
The exterior lights flash each time you
press the LOCK or UNLOCK button. A
horn will also sound when you press the
LOCK button twice.
Changes how long it takes (in seconds)
for the doors to relock and the security
system to set after you unlock but do not
open the door.
Changes the windshield wiper operation
between two settings when the wiper
switch is in the INT position.
Customize Group
LIGHTING SETUP
(P.106)
DOOR · WINDOW
SETUP
(P.110)
WIPER SETUP
(P.117)
Customize Entry
CHG SETTING
(P.92)
: Default setting
Multi-Inf ormation Display
Inst rument s and Cont rols
89
——
y

y
(yy
2008 TSX

There are three custom settings in
the Door · Window Setup:DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGEMENT
SECURITY RELOCK TIMER
While the multi-information display
shows ‘‘DOOR · WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Each time you press
the INFO button, the display
changesasshowninthenext
column.
To customize a setting, press the
INFO button repeatedly until you see
the setting you want to customize,
and press the SEL/RESET button.
Then f ollow the procedures
described on the f ollowing pages. Door · Window Setup
Multi-Inf ormation Display
110
: Press the INFO Button.
——
y


y
(y

y
2008 TSX

Press SEL/RESET button, then
press the INFO button.
Each time you press the INFO
button, the display changes to ‘‘ON,’’
to ‘‘OFF,’’ then to ‘‘EXIT.’’
Select ‘‘ON’’ or ‘‘OFF’’ by pressing
the INFO button, and enter your
selection by pressing the SEL/
RESET button.
When you push the LOCK button on
the remote transmitter, the door and
trunk locks are set, some of the
exterior lights f lash, and a beeper
sounds. If you push the LOCK
button (with the security system set)
again within 5 seconds, the horn
sounds to let you know the security
system is working. You can
customize the Keyless Lock settings
so that the exterior lights do not
f lash and/or the acknowledgement
beeper does not sound.
While the multi-inf ormation display
shows ‘‘DOOR·WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Then press the
INFO button repeatedly until you see
‘‘KEYLESS LOCK
ACKNOWLEDGEMENT’’ as shown
above.
CONT INUED
Multi-Inf ormation Display
K eyless L ock A cknowledgement
Inst rument s and Cont rols
113
\f—\f—
y
\f
y
(\fy\f

y
2008 TSX

While the multi-information display
shows ‘‘DOOR·WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Then press the
INFO button repeatedly until you see
‘‘SECURITY RELOCK TIMER’’ as
shown above.Press the SEL/RESET button, then
press the INFO button.
Each time you press the INFO
button, the time changes f rom ‘‘30
sec,’’ to ‘‘60 sec,’’ and then to ‘‘90 sec.’’
If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock and
the security system sets.
You can change this relock time
f rom 30 seconds to 60 or 90 seconds.
CONT INUED
Securit y Relock T imer
Multi-Inf ormation Display
Inst rument s and Cont rols
115
\f—\f—
y
\f\f\fy
(\fy\f
\fy
2008 TSX