Engine Acura TSX 2010 Owner's Guide
Page 137 of 524
µMoves the whole seat
up and f orward, or
down and backward.
Thefrontof theseat
also tilts up or down at
thesametime.
Moves the seat
f orward and backward.
Moves the f ront of the
seat up or down.
Raises or lowers the
seat. Adjusts the seat-back
angle f orward or
backward.
The controls f or the power
adjustable front seats are on the
outside edge of each seat bottom.
You can adjust the seats with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving.
The passenger seat has the same
adjustments as the driver’s seat but
without any height adjustment.
The driver’s seat includes a memory
f eature. Two seat positions can be
stored in separate memories. You
canthenselectamemorizedposition
by pushing the appropriate memory
button. Ref er to page f or how to
memorize and select the seat
positions.142
Driver’s seat only:
Driver’s seat only:
See pages f or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-backs. 14
Driver’s seat only:
13
All models except Canadian TSX with4-cylinder engine
Seats
Power Seat A djustments
134
Driver’s seat is shown.
2010 TSX
Page 144 of 524
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
Follow these precautions whenever
you use the seat heaters:If the engine is lef t idling f or an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting. Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
Both f ront seats are equipped with
seat heaters. Because of the sensors
f or the side airbag cutof f system,
there is no heater in the passenger’s
seat-back. The ignition switch must
be in the ON (II) position to use the
heaters. Push the front of the switch, HI, to
rapidly heat up the seat. Af ter the
seat reaches a comfortable
temperature, select LO by pushing
the back of the switch. This will keep
the seat warm.
Seat Heaters
Inst rument s and Cont rols
141
Passenger’s
Seat
Driver’s
Seat
HEATERS
SEAT HEATER SWITCH
2010 TSX
Page 145 of 524
Store a driving position only when
the vehicle is parked.Turn the ignition switch to the ON
(II) position. You cannot add a
new driving position to the
memory unless the ignition switch
is in the ON (II) position. You can
recall a memorized position with
the ignition switch in any position.
Adjust the seat to a comfortable
position (see page ). Press and release the SET button
on the control panel. You will hear
a beep. Immediately press and
hold one of the memory buttons (1
or 2) until you hear two beeps.
The indicator in the memory
button will come on. The current
position of the driver’s seat is now
stored.
Your vehicle has a memory feature
f or the driver’s seat position.
Two seat positions can be stored in
separate memories. You select a
memorized position by pushing the
appropriate button or using the
appropriate remote transmitter
(Driver 1 or Driver 2).
This setting can be linked or
unlinked with the remote transmitter.
To switch the link setting, see page
. 3.
1.
2.
134
93
All models except Canadian TSX with
4-cylinder engineStoring a Driving Position in
Memory
Driving Position Memory System
142
MEMORY BUTTONS
SET BUTTON
2010 TSX
Page 177 of 524
An audio system is standard on all
models. Read the appropriate pages
(as shown below) to use your
vehicle’s audio system.
For vehicles without navigation
system, see pages through .
For vehicles with navigation system,
see pages through .175 221
222 283
Audio System
A udio syst em wit h navigat ion syst em
A udio system without navigation system
174
Canadian TSX with 4-cylinder engine
All models except Canadian TSX with
4-cylinder engine
2010 TSX
Page 186 of 524
CONT INUED
Playing the XMRadio (Models without navigation system)
Features
A ll models except Canadian T SX wit h 4-cylinder engine
183
RETURN BUTTONSELECTOR
KNOB
MENU BUTTON
CATEGORY BAR
SCAN BUTTON
VOL/
(VOLUME/POWER) KNOB
SKIP BAR
TITLE BUTTON XM RADIO BUTTON
U.S. model is shown.
2010 TSX
Page 187 of 524
µTo switch between
channel mode and category mode,
press and hold the TITLE button
until the mode changes.
In the channel mode, you can select
all of the available channels. In the
category mode, such as Jazz, Rock,
Classical, etc., you can select all of
the channels within that category. Each time you press and release the
TITLE button, the display changes in
the following sequence: name, title,
and category.
To listen to XM Radio, turn the
ignition switch to the ACCESSORY
(I) or ON (II) position, and press the
button. The last channel you
listened to will show in the display.
Adjust the volume by turning the
VOL/ knob. You can also change the mode from
the menu items. Press the MENU
button to display the menu items,
then turn the selector knob to select
MODE/CATEGORY or MODE/
CHANNEL and press the selector
knob (ENTER). Each time you press
and release the selector knob
(ENTER), the display changes
between CHANNEL and
CATEGORY. To enter the setting,
press the button.
You may experience periods when
XM Radio does not transmit the
artist’s name and song title
inf ormation. If this happens, there is
nothing wrong with your system.
Your vehicle is capable of receiving
XM
Radio anywhere in the United
States and Canada, except Hawaii,
Alaska,andPuertoRico.XMisa
registered trademark of Sirius XM
Radio, Inc. and XM CANADA
is a
registered business name of
Canadian Satellite Radio Inc.
XM Radio receives signals f rom two
satellites to produce clear, high-
quality digital reception. It of f ers
many channels in several categories.
Along with a large selection of
dif f erent types of music, XM Radio
allows you to view channel and
category selections in the display. MODE Operating the XM Radio
Playing the XMRadio (Models without navigation system)
A ll models except Canadian T SX
wit h 4-cylinder engine
184
2010 TSX
Page 192 of 524
Playing a Disc (Models without navigation system)
Features
Canadian T SX wit h 4-cylinder engineWithout XMRadio A ll models except Canadian T SX wit h 4-cylinder engine
With XMRadio
189
MENU BUTTON
RETURN BUTTON
SCAN BUTTON
SELECTOR
KNOB
MP3/WMA INDICATOR
MENU BUTTON
RETURN BUTTON
SCAN BUTTON
SELECTOR
KNOB CD
BUTTON
PRESET
BUTTONS
SKIP BAR
TITLE
BUTTON
DISC SLOT MP3/WMA INDICATOR
VOL/
(VOLUME/POWER) KNOB
DISC EJECT
BUTTONDISC SLOT
TITLE
BUTTON
CATEGORY
BAR VOL/
(VOLUME/POWER) KNOB
CD
BUTTON
DISC EJECT
BUTTONPRESET
BUTTONS
SKIP BAR
FOLDER
BAR
2010 TSX
Page 202 of 524
Playing an iPod(Models without navigation system)
Features
A ll models except Canadian T SX wit h 4-cylinder engine
199
MENU BUTTON
RETURN BUTTON
SELECTOR KNOB
TITLE BUTTON iPod INDICATOR
VOL/
(VOLUME/POWER) KNOB
SKIP BAR AUX BUTTON CD BUTTON
USB INDICATOR
U.S. model is shown.
2010 TSX
Page 211 of 524
Playing a USB Flash Memory Device (Models without navigation system)
A ll models except Canadian T SX wit h 4-cylinder engine
208
MENU BUTTON
RETURN BUTTON
SELECTOR KNOB
TITLE BUTTON
VOL/
(VOLUME/POWER) KNOB
CATEGORY BAR
USB INDICATOR
AUX BUTTON
SKIP BAR CD BUTTON
FILE TYPE INDICATOR
U.S. model is shown.
2010 TSX
Page 290 of 524
´µ
´
µ
´
µ
In MP3 or WMA mode, you can use
the skip function to select folders.
Press and hold the top ( ) of the
CH button until you hear a beep, to
skip f orward to the f irst f ile of the
next folder. Press the bottom ( ) to
skip backward to the previous f older.
The auxiliary input jack is inside the
console compartment. The system
will accept auxiliary input from
standard audio accessories using a
1/8 inch (3.5 mm) stereo miniplug.
When a compatible audio unit is
connected to the jack, press the AUX
button to select it.
When playing a USB f lash memory
device, you can also use the seek
function to skip the folder. To
activate this, press and hold either
side of the CH button until you hear
a beep.
If youareplayingaconventionalCD
(without the text data and not
compressedinMP3orWMA),you
can use the skip function to select
discs. Press and hold the top ( ) of
the CH button until you hear a beep,
to skip f orward to the next disc.
Press and hold the bottom ( ) to
skip backward to the previous disc.
If youareplayingaUSBflash
memory device or iPod with the USB
adapter cable, press and release the
top ( ) of the CH button to skip
f orward to the beginning of the next
file. Press the bottom ( ) to skip
backward to the beginning to the
current f ile. Press it twice to return
to the previous file.
On models with navigation system
Except Canadian TSX with 4-cylinder engine
Auxiliary Input Jack
Remote Audio Controls, Auxiliary Input Jack
Features
287
2010 TSX