warning light Acura TSX 2011 Owner's Manual

8Quick Reference Guide
Instrument Panel
P.63
Lights On IndicatorHigh Beam IndicatorFog Light Indicator
Temperature
Gauge
Fuel Gauge Speedometer
Tachometer
Low Fuel
Indicator
Security System Alarm
Indicator Multi-Information Display
Shift Lever Position Indicator
*
Gear Position Indicator
*
Gauges

P.75
Multi-Information Display

P.76
System Indicators

P.64
Lights Reminders
System IndicatorsSystem Indicators
VSA
® OFF Indicator
Turn Signal and
Hazard Warning
IndicatorsElectric Power
Steering (EPS)
IndicatorMalfunction
Indicator LampLow Oil Pressure
IndicatorCharging System
IndicatorAnti-lock Brake
System (ABS)
IndicatorVehicle Stability
Assist (VSA
®) System
Indicator
Seat Belt Reminder
IndicatorImmobilizer System
IndicatorSupplemental
Restraint System
IndicatorLow Tire Pressure/
TPMS IndicatorDoor and Trunk
Open IndicatorCruise Main IndicatorCruise Control
IndicatorSystem Message
Indicator Parking Brake
and Brake System
Indicator
U. S.Canada
Side Airbag Off
Indicator
U. S.Canada

69Instrument Panel
Indicators
Continued
Indicator Name On/Blinking Explanation Message
System Message
Indicatort
$PNFT
PO
BMPOH
XJUI
B
CFFQ
XIFO

a problem is detected. A system
message on the multi-information
display appears at the same time.t
8IJMF
UIF
JOEJDBUPS
JT
PO

QSFTT
UIF

(information) button to see
the message again.
t
3FGFS
UP
UIF
*OEJDBUPST
JOGPSNBUJPO
JO

this chapter when a system message
appears on the multi-information
display. Take the appropriate action
for the message.
t
5IF
NVMUJJOGPSNBUJPO
EJTQMBZ
EPFT

not return to the normal screen
unless the warning is canceled, or the button is pressed.
—
Turn Signal
Indicatorst
5IF
UVSO
TJHOBM
JOEJDBUPST
CMJOL

when you operate the turn signal
lever.
t
*G
ZPV
QSFTT
UIF
IB[BSE
XBSOJOH

button, both indicators and all turn
signals blink at the same time.t
Does not blink or blinks rapidly-
A turn signal light bulb has blown.
Change the bulb immediately.
 Replacing Light Bulbs P.252, 253
—
High-Beam
Indicatort
$PNFT
PO
XIFO
UIF
IJHI
CFBN

headlights are on.
t
$PNFT
PO
XJUI
SFEVDFE
CSJHIUOFTT

when DRL (daytime running lights)
are on.—
—
Lights On
Indicatort
$PNFT
PO
XIFOFWFS
UIF
MJHIU

switch is on, or in AUTO when the
exterior lights are on.t
*G
ZPV
SFNPWF
UIF
LFZ
GSPN
UIF

ignition switch while the light is on, a
chime sounds when the driver's door
is opened.
—

Indicators
Multi-Information Display Warning and Information Messages
72Instrument Panel
Multi-Information Display Warning and Information Messages
Message Condition Explanation
t
"QQFBST
XIFO
UIF
FOHJOF
DPPMBOU
UFNQFSBUVSF
HFUT

abnormally high.
 Overheating P. 2 8 8
t
"QQFBST
XIFO
UIF
GVFM
mMM
DBQ
JT
MPPTF
PS
JT
OPU

installed.
 Tighten the Fuel Fill Cap P. 2 9 1
t
"QQFBST
JG
UIFSF
JT
B
QSPCMFN
XJUI
UIF
%3-
TZTUFN t
)BWF
ZPVS
WFIJDMF
DIFDLFE
CZ
B
EFBMFS
 Daytime Running Lights P.1 0 7
Canadian models
t
"QQFBST
XIFO
XBTIFS
nVJE
HFUT
MPX
t
3FmMMJOH
XBTIFS
GVJME
 Refilling Window Washer Fluid P. 2 4 6
The following messages appear only on the multi-information display. Press the
(information) button to see the message
again with the system message indicator on.

Opening and Closing the Windows
100Controls
Opening/Closing the Power WindowsThe power windows can be opened and closed when the ignition switch is in ON II
, using the switches on the doors. The driver's side switch can be used to open
and close all of the windows.
The main switch on the driver's side must be switched off (not pushed in, indicator
off) to open and close the windows from anywhere other than the driver's seat.
When the main switch is turned on (pushed in, indicator on), you can only operate
the windows from the driver's seat. Turn the main switch on when children are in
the vehicle.
Opening/Closing the Power Windows
WARNING
Closing a power window on someone's
hands or fingers can cause serious injury.
Make sure your passengers are away from
the windows before closing them.
Opening/Closing Windows with Auto-Open/Close Function
The power windows can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
Auto Reverse
If a power window senses resistance when closing
automatically, it will stop closing and reverse
direction.
The driver’s window auto reverse function is
disabled when you continuously pull up the switch.
The auto reverse function stops sensing when
the window is almost closed to ensure that it fully
closes.
Automatic operation
To o p e n : Push the switch down firmly
To close: Pull the switch up firmly.
The window opens or closes completely. To
stop the window at any time, push or pull the
switch briefly. Manual operation
To open: Push the switch down lightly.
To close: Pull the switch up lightly.
Release the switch when the window reaches
the desired position.
ONOFF
Main Switch
Driver’s Window Switch
Indicator
Front Passenger’sWindow Switch

Interior Lights/Interior Convenience Items
Interior Convenience Items
126Controls
Interior Convenience Items
Glove Box
Pull the handle to open the glove box. You
can lock the glove box with the master key.
Glove Box
The glove box light comes on when the parking
lights are on.
WARNING
An open glove box can cause serious
injury to your passenger in a crash, even if
the passenger is wearing the seat belt.
Always keep the glove box closed while
driving.
Detachable shelf
The shelf in the glove box is detachable.
To remove it, disengage the tabs.
ShelfGlove Box
To L o c k

Interior Lights/Interior Convenience Items
Interior Convenience Items
132Controls
Seat Heaters
If the ignition switch is in ON
II
. The HI
setting heats the seats faster than the LO
setting.
There is no heater in the passenger's seat-
back due to the side airbag cutoff system.
Seat Heaters
Do not use the seat heaters even in LO when the
engine is off. Under such conditions, the battery
may be weakened, making the engine difficult to
start.
In the LO setting, the heater runs continuously and
does not automatically turn off after a period of
time.
WARNING
Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis)
or with sensitive skin should not use seat
heaters.
While in HI, the heater cycles on and off. The appropriate indicator will be on while
the seat heater is on. Briefly press the
button on the opposite side to turn the
heater off. The indicator will be off.
When a comfortable temperature is
reached, select LO to keep the seat warm.

Braking
210Driving
Brake System
Parking Brake
Use the parking brake to keep the vehicle stationary when parking.
To a p p l y :
Pull the lever fully up without pressing the
release button.
To r e l e a s e :
1. Pull the lever slightly, and press and hold
the release button.
2. Lower the lever down all the way, then
release the button.
Parking Brake NOTICE Release the parking brake fully before driving. The
rear brakes and axle can be damaged if you drive
with the parking brake applied.If you start driving without fully releasing the
parking brake, a buzzer sounds as a warning, and
"RELEASE PARKING BRAKE" appears on the multi-
information display.
Always apply the parking brake when parking.
To prevent the parking brake from freezing when
the outside temperature is extremely cold, do not
apply it, but do the following: Automatic transmission models Put the shift lever in
P, then use a block or other
wheel chock to stop the wheels from turning.
Manual transmission models Put the shift lever in
R or
1, then use a block or
other wheel chock to stop the wheels from turning.

277
If a Tire Goes Flat
Continued
Handling the Unexpected
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then, stop in a safe place. Replace the flat tire with the compact
spare tire. Go to a dealer as soon as possible to have the full size tire repaired or
replaced.
1. Park the vehicle on firm, level, and non-slippery ground. Automatic transmission models 2. Put the shift lever in P
.
Manual transmission models 2. Put the shift lever in R
.
All models 3. Set the parking brake.
4. Turn on the hazard warning lights and turn the ignition switch to LOCK 0
.
Changing a Flat Tire
Periodically check the tire pressure of the compact
spare. It should be set to the specified pressure.
Specified Pressure: 60 psi (420 kPa, 4.2 kgf/cm
2)
When driving with the compact spare tire, keep
the vehicle speed under 50 mph (80 km/h). Replace
with a full size tire as soon as possible.
The compact spare tire and wheel in your vehicle
are specifically for this model.
Do not use them with another vehicle.
Do not use another type of compact spare tire or
wheel with your vehicle.
Do not mount tire chains on a compact spare tire.
If a chain-mounted front tire goes flat, remove one
of the full-size rear tires and replace it with the
compact spare tire. Remove the flat front tire and
replace it will the full size tire that was removed
from the rear. Mount the tire chains on the front
tire.
Do not use a puncture-repairing agent on a flat tire,
as it can damage the tire pressure sensor.
Changing a Flat Tire

Jump Starting
284Handling the Unexpected
Jump Starting Procedure
Turn off the power to electric devices, such as audio and lights. Turn off the
engine, then open the hood.
Jump Starting
6-cylinder models 1. Slide out the battery terminal cover. All models 2. Connect the first jumper cable to your
vehicle's battery
terminal.
3. Connect the other end of the first jumper
cable to the assisting vehicle's
terminal.
Use a 12-volt booster battery only.
4. Connect the second jumper cable to the
assisting vehicle's
terminal.
WARNING
A battery can explode if you do not follow
the correct procedure, seriously injuring
anyone nearby.
Keep all sparks, open flames, and smoking
materials away from the battery.Securely attach the jumper cables clips so that they
do not come off when the engine vibrates. Also be
careful not to tangle the jumper cables or allow the
cable ends to touch each other while attaching or
detaching the jumper cables.
4-cylinder models 6-cylinder models Booster Battery
Cover

Overheating
288Handling the Unexpected
How to Handle OverheatingOverheating symptoms are as follows:
The temperature gauge needle is at the tH
mark or the engine suddenly loses
power.
Steam is coming out of the engine compartment. t
First thing to do
1. Immediately park the vehicle in a safe place. Automatic transmission models
Move the shift lever to P
and set the parking brake. Turn off all accessories
and turn on the hazard warning lights.
Manual transmission models
Move the shift lever to N
and set the parking brake. Turn off all accessories
and turn on the hazard warning lights.
2. No steam coming out: Keep the engine running and open the hood.
Steam coming out: Turn off the engine and wait until steam goes away.
Then, open the hood.
How to Handle Overheating NOTICE Continuing to drive with the temperature gauge
needle at the
H
mark may damage the engine.WARNING
Steam and spray from an overheated
engine can seriously scald you.
Do not open the hood or engine
compartment if steam is coming out.