coolant Alfa Romeo 8C 2010 Owner handbook (in English)

Page 8 of 223

6SYMBOLSSome components of your ALFA ROMEO, are
equipped with coloured labels, applied onto
or next to them. The symbols shown on these
labels are important warnings that the user must
follow when using the component involved.
Below is a summary of all the symbols used
on the labelling of your ALFA ROMEO. The
component to which the symbol draws your
attention is shown next to the symbol.
In addition, the meaning of the symbol shown
is also indicated according to the following
sub-division: danger, prohibition, warning,
mandatory - with respect to that same symbol.DANGER SYMBOLS
Battery
Corrosive liquid.
Battery
Explosion.
Fan
It can start up automatically even with
the engine off.
Expansion tank
Do not remove the cap when the
coolant is hot.
Coil
High voltage.
Belts and pulleys
Moving elements; Keep body parts and
clothing away.
Air-conditioning lines
Do not open. Gas under high pressure.SYMBOLS OF
PROHIBITIONS
Battery
Do not approach with open fl ames.
Battery
Keep children at a safe distance.
Heat guards - belts - pulleys - fans
Do not touch with your hands.
Engine compartment ECU protection
cover
Do not direct the jet of water on the
ECUs, relays and fuses.

Page 48 of 223

46
3
1354
27896
INFORMATION SHOWN
ON THE STANDARD PAGE 1) Time2) Outside temperature3) Failure/information symbol4) Trip odometer5) Total odometer6) Q-Select gearbox status 7) Engine oil temperature8) Coolant temperature 9) Fuel level gauge
The central area of the display indicating the
engine oil and coolant temperatures and the
fuel level remains active until another function
is activated or other information on the vehicle
status needs to be displayed.
RECONFIGURABLE
MULTIFUNCTION
DISPLAY The “reconfigurable multifunction display” shows
useful information while driving, in particular:With the key turned to MAR the following
information is immediately displayed for 2
seconds:
- Clock
- Outside air temperature
- Date
- Total odometer
- Trip odometer
- Q-Select gearbox status.
After two seconds the display will automatically
return to the standard page.

Page 63 of 223

61
3
INSTRUMENTS AND CONTROLSWARNING: When the ignition key is turned to
MAR, if the warning light does not illuminate
or if it illuminates while driving, immediately
contact an Authorised Service Centre of the
Manufacturer’s Network.
Excessive coolant temperature
(*)
Combined with the “Coolant
thermometer”, it illuminates together with
the warning light on the instrument panel
and indicates an excessive temperature of the
coolant.
In this condition, stop the vehicle and have
the cooling system checked by an Authorised
Service Centre of the Manufacturer’s
Network. INDICATORS AND
WARNING LIGHTS
Rear fog lights
When the rear fog lights are turned
on.
Position lights / low beams
Illuminates when the position lights
or low beams are activated.
High beams
When the high beams are turned on
or used to flash.
Low beams
Illuminates when the low beams are
activated.
Low fuel
When this warning light illuminates,
it means that there are about 14
litres of fuel left in the tank.Engine failure control system
(EOBD)
In normal conditions, this warning
light should illuminate when the ignition key is
turned to MAR and go off as soon as the engine
is started. This will show that the warning light is
working properly.
If the warning light remains on or illuminates
while driving, it indicates that there is a failure
in the fuel supply/ignition and emission control
system. This failure could cause high exhaust
emissions, loss of performance, poor vehicle
handling and high consumption levels.
In these conditions you can proceed slowly
without demanding engine performance.
Prolonged use of the vehicle when the warning
light is on can cause damage. Therefore, as
soon as possible contact an Authorised Service
Centre of the Manufacturer’s Network.
The warning light will go out if the problem
disappears. The error will be stored in any case.

Page 69 of 223

67
3
°C
50
°C90 130
50 90 130
0 1/2 1
INSTRUMENTS AND CONTROLS
FUEL GAUGE
The fuel gauge is always displayed when the key
is turned to ON and with the display in Normal or
Trip mode.
The fuel reserve is indicated by the last of the 8
notches split in two.
- When 8 notches are shown the tank is full
- When two notches are shown the tank is
in reserve
- When one notch is shown the tank is in
half reserve.COOLANT
THERMOMETER
The coolant TMP is displayed when the key is
turned to ON and with the display in standard
mode. When the display is in TRIP mode, it is no
longer shown.
The coolant temperature is displayed by means
of a bar graph.
The temperature is indicated with 8 notches
corresponding to the temperature values the
coolant has reached.
The temperature symbol
is shown next to
the 8 notches indicating the following values:°C °F
Beginning of
scale50 120
Average 90 190
End of scale 130 260
Beginning of
danger sector 115 239

Page 180 of 223

178
7
Parts to be refi lled Quantity Product specifi cations
Engine cooling circuit 12.5 litres Mix of water and coolant, in the proportions indicated on the product package.
Coolant: inhibited monoethylene glycol-based protective fluid with anti-freezing
action: CUNA NC 956-16.
Recommended fluid: PARAFLU UP - Contractual Technical - Reference No. F101.M01
Hydraulic power steering - Oil type: ATF DEXRON II D LEV, SAE 10W.
Oil Type ATF Type A - MB 236.2 - ZF ML09/12
Recommended oil: TUTELA GI/A - Contractual Technical - Reference No. F002.B92
Gearbox 2.7 litres SAE 75W/90 above API GL4-GL5C API MT1-PG2 specifications
Recommended oil: TUTELA SPORT ZC SUPREME
“Q-Select” system ~0.5 litres Oil type: CHF
Recommended oil: TUTELA GI/R - Contractual Technical - Reference No. F428.H04
Braking system - Synthetic fluid: NHTSA n.116 DOT4, ISO 4925, SAE J1703 J1704, CUNA NC
956-01.
SAE J1703, FMVSS No. 116 DOT 4 and ISO 4925
Recommended fluid: TUTELA TOP 4 - Contractual Technical - Reference No. F001.A93
Air conditioning coolant 600 g R134a
Air conditioning compressor oil 200 cc
(+20/-10 ml)Type RL - 897 SAE J2297/98/99

Page 194 of 223

192
8
ADDITIONAL
CHECKSEvery 500 km or before long journeys, check
and if necessary correct:
- engine coolant level
- windscreen washer fl uid level
- tyre pressure and condition.WARNING - ENGINE OIL
If the vehicle is used mainly in one of the
following particularly severe conditions:
- dusty roads;
- short repetitive trips (less than 7-8 km)
when the external temperature is below
zero;
- engine running frequently at idle or without
reaching stabilised temperatures, replace
the engine oil more frequently than
indicated in the Maintenance Schedule. WARNING - AIR FILTER
When using the vehicle on dusty roads, replace
the air filters more frequently than indicated in
the Maintenance Schedule.
If you have any doubts about the frequency
for engine oil and air filter replacements, in
the relation to the vehicle conditions of use,
contact an Authorised Service Centre of the
Manufacturer’s Network.
WARNING: The vehicle must be serviced
by an Authorised Service Centre of the
Manufacturer’s Network. For routine and minor
maintenance operations or small repairs which
you can carry out yourself, make sure that you
always use the right equipment, genuine Alfa
Romeo spare parts and the recommended fluids.
In any case, never perform these operations if
you have no experience.

Page 195 of 223

193
8
2
5
3
1
4MAINTENANCE
LEVEL CHECKS1) Engine oil
2) Engine coolant
3) Windscreen washer fluid
4) Brake fluid
5) Power steering fluid

Page 197 of 223

195
8
MAXMIN
B
MAINTENANCE
GEARBOX OIL
Have the oil level checked at an Authorised
Service Centre of the Manufacturer’s
Network.WARNING: Do not top up with oil having
characteristics other than those of the oil already
used in the engine.
WARNING: Waste transmission oil contains
substances that are dangerous for the
environment. To have the oil changed, we advise
you to contact an Authorised Service Centre
of the Manufacturer’s Network, where all the
necessary equipment is available to dispose
of the used oil and filters in compliance with
applicable legislation and in an environment-
friendly manner.
ENGINE COOLANT
CAUTION
When the engine is very hot, do
not remove the cap from the pan: risk
of burns!
The fluid level must be checked with the engine
cold and must be between the MIN and MAX
reference notches visible on the tank.
If the level is too low, slowly pour the
recommended fluid through the pan filler neck
until the level is near to the MAX reference
notch.WINDSCREEN/
HEADLIGHT WASHER
FLUID
For topping-up, open the cover
B, extract the
filler neck extension and pour in a mixture of
water and detergent in the proportion indicated
on the package.
WARNING: If the temperature is below 20°C,
use pure detergent fluid.
WARNING: Do not drive with the windscreen
washer tank empty: the action of the washer is
essential for improving visibility.

Page 205 of 223

203
8
B
A
C
MAINTENANCE
SPRAY NOZZLES
If the jet does not work, first check that there
is fluid in the pan (see “Level checks” in this
section) then check that the nozzles are not
clogged.REPLACING THE WIPER
BLADES
1) Release the blade
A by lifting the catch
B.
2) Slide the blade
A to the right to remove it
from the arm. C.
3) Fit the new blade working in reverse order.
WARNING: When replacing the blade, be careful
not to damage the bodywork or the blade itself.
AIR
CONDITIONING/
HEATING SYSTEMDuring the winter, the air conditioning system
should be operated at least once a month for
about 10 minutes.
Before the summer season, have the system
efficiency checked at an Authorised Service
Centre of the Manufacturer’s Network. WARNING: The system uses R134a type
coolant that, in the event of accidental leakage,
is not harmful for the environment. Under no
circumstances should you use R12 fluid that, in
addition to being incompatible with the system
components, contains chloro-fluoro-carbons
(CFCs).

Page 212 of 223

210
8
Precautions and warnings
- Make sure that the cables are not crushed
or come into contact with hot surfaces or
sharp edges.
- Do not cover the battery conditioner.
- Make sure that the mains connector is not
exposed to water.
- Never recharge a frozen battery.
- Never recharge a damaged battery.
- The connection to the mains must be
in compliance with domestic legislation
regarding high voltage.
- Always check the cables of the battery
conditioner before use: check that the
cables and external sheath are not cracked.
- Never use the battery conditioner if its
cables are damaged.
- Store and use the battery conditioner away
from children; do not allow children to play
with the device.Overheating protection
The battery conditioner is protected against
overheating.
If the ambient temperature rises, the output
power is reduced.
Maintenance
The battery conditioner does not require
maintenance.
The battery conditioner may not be
disassembled.
The casing of the device can be cleaned with a
soft and moist cloth or with neutral detergent.
Always disconnect the battery conditioner before
cleaning it.RESTARTING THE
VEHICLE
Before restarting the vehicle after a long period
of inactivity, we recommend that you perform
the following operations:
CAUTION
Check the tyres for pressure
and for any damages, cuts or cracks. If
this is the case, have them replaced.
- Do not dry-dust the exterior of the vehicle.
- Visually inspect if there are any fl uid leaks
(oil, brake and clutch fl uid, engine coolant
etc.).
- Have the engine oil and fi lter replaced.
- Check the fl uid levels in the braking system,
as well as the engine coolant level.
- Check the air fi lter and replace it if
necessary.
- Check the conditions of the engine belts.

Page:   1-10 11-20 next >