engine oil AUDI A3 1995 8L / 1.G AEB ATW Engines Valvetrain Servicing Workshop Manual
Page 14 of 51
15-42
      
Oil seals for camshafts, replacing
 
     
Cylinder head installed 
     Lock carrier in service position   Page 13
-1 
     
Special tools and equipment  
     
2085 seal puller
     3241 seal installer
     3036 retainer
     
Replacing exhaust camshaft oil seal  
     
Removing  
     
-  Remove ribbed belt and ribbed belt tensioner   
Page 13
-15
 . 
     
-  Remove engine covers. 
     
-  Remove upper toothed belt cover   Page 13
-
29
 . 
    
- 
Turn crankshaft at central bolt of toothed belt gear in direction of 
Pa
ge 14 of 51 Valvetrain, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.3 
Page 34 of 51
15-60
      
Hydraulic valve lifters, checking
 
     
Special tools and equipment  
     
Feeler gauge 
     Wood or plastic wedge
     
Note:  
     Hydraulic valve lifters cannot be serviced.
     Irregular valve noise when starting engine is 
normal. 
     
-  Start engine and let run until coolant 
temperature reaches at least 80 C (176 F). 
     
-  Increase RPM to 2500 for about 2 minutes; if 
necessary test drive vehicle. 
     
Note:  
     If irregular valve noises disappear but then 
reappear during drive, replace oil retaining valve. 
Oil retaining valve is located in oil filter bracket   
Page 17
-6 . 
      If hydraulic valve lifters are still loud, locate faulty 
Pa
ge 34 of 51 Valvetrain, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.3 
Page 41 of 51
15-65
      
Installing  
    
CAUTION!  -  Place plastic sleeve -A- on valve stem to prevent damage to new valve 
stem oil seals. 
-  Lightly oil lip of valve stem oil seal -B-.
-  Insert valve stem oil seal into 3365 valve stem seal fitting tool and 
carefully slide onto valve guide. 
-  Remove plastic sleeve. 
- Install camshafts   Page 15
-53
 .
After installing the camshafts, the engine must not be started for 
approx. 30 minutes. The hydraulic valve lifters have to settle 
(otherwise valves will strike the pistons). After installing the valvetrain and lifters, carefully rotate the 
crankshaft by hand at least 2 full revolutions before starting to be 
sure that valves do not strike the pistons. 
Pa
ge 41 of 51 Valvetrain, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.3