battery AUDI A3 1996 8L / 1.G ATW Engine Diagnostic Trouble Code Table Workshop Manual

If the connector is disconnected from the ECM or the battery is disconnected, all adaptation values in the control module
are erased. DTC memory content will remain intact however. If the engine is started after this, a rough, uneven idle can
result. In this case, engine must be allowed to run at idle for a few minutes until adaptation procedure has been
completed.
If DTC memory was erased Page 01
-16
, readiness code must be re-generated Page 01
-73
.
Pa
ge 2 of 40 Dia
gnostic Trouble Code
(DTC
) table
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.3

01-44

DTC
DTC text
Corrective action
SAE
VAG


P1558 17966 Throttle drive (power accelerator
actuation) -G186-
Electrical malfunction in circuit - Check throttle valve control module Page 24
-120
P1559 17967 Throttle valve control module -
J338-
Malfunction in basic setting - Perform adaptation Page 24
-121
P1560 17968 Maximum engine speed
exceeded - Repair mechanical damage
P1564 17972 Throttle valve control module -
J338-
Voltage too low during basic
setting - Charge battery, repeat basic setting
P1565 17973 Throttle valve control module -
J338-
Lower impact not reached - Check throttle valve control module Page 24
-120
P1568 17976 Throttle valve control module -
J338-
Mechanical malfunction
P1569 17977 Cruise control switch -E45- Repair Manual, Electrical Equipment On Board Diagnostic (OBD),
Repair Group 01; OBD for cruise control system

Pa
ge 34 of 40 Dia
gnostic Trouble Code
(DTC
) table
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.3