ignition AUDI A3 1997 8L / 1.G AEB ATW Engines Secondary Air System Workshop Manual
Page 11 of 16
26-39
Installation location:
Repair Manual, 1.8 Liter 4-Cyl. 5V Turbo Fuel
Injection & Ignition, Repair Group 24
- Initiate output Diagnostic Test Mode (DTM) and
activate Secondary Air Injection (AIR) pump
relay -J299-.
A - If relay does not trigger:
B - If relay triggers, but Secondary Air Injection (AIR) pump does not run:
The Secondary Air Injection (AIR) pump relay (in 3-socket relay
carrier in the E-box, at left in plenum chamber, position 2) must
trigger and the Secondary Air Injection (AIR) pump motor -V101-
must run in intervals
- Check voltage supply of Secondary Air Injection (AIR) relay Page
26
-40
.
- Checking activation of Secondary Air Injection (AIR) relay Page 26
-
42
.
- Check voltage supply for Secondary Air Injection (AIR) pump Page
26
-43
.
Pa
ge 11 of 16 Secondar
y air s
ystem, checkin
g (en
gine code ATW
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.2
Page 14 of 16
26-42
Checking activation of the Secondary Air
Injection (AIR) pump relay
- Switch ignition off.
- Remove Secondary Air Injection (AIR) pump
relay.
If LED does not blink: - Connect VAG1527B voltage tester as follows:3-socket relay carrier in E-box, plenum
chamber, position 2
terminal
Measure to
6 Engine Ground
(GND)
- Initiate output Diagnostic Test Mode (DTM) and activate Secondary Air
Injection (AIR) pump relay -J299-.
LED must blink.
- Switch ignition off.
- Connect VAG1598/31 test box at wiring harness to ECM, do not
connect ECM.
Pa
ge 14 of 16 Secondar
y air s
ystem, checkin
g (en
gine code ATW
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.2