wiring AUDI A4 1995 B5 / 1.G AFC Engine Closed Throttle Position Switch Checking And Adjusting Workshop Manual

24-75

Adjusting

- Remove throttle body.

- Loosen two throttle position sensor mounting
screws.

Repair Manual, 2.8 Liter V6 2V Engine Mechanical, Engine Code(s):
AFC, Repair Group 20

Checking wiring between CTP switch and ECM - Turn throttle position sensor in direction shown (arrows), without
moving throttle valve shaft, until stop can be felt.
- Tighten throttle position sensor in this position.
- Check CTP switch again page 24
-74
.
- Re-install throttle body and adjust accelerator pedal cable

Terminal assignments for throttle position sensor connector.
- Connect VAG 1598/19 test box to ECM harness connector page 01
-
255
.
- Check wiring for continuity or short to B+ between throttle position
sensor connector terminal 4 (GND) and test box socket D12.

Specified value: max. 1 ohm ( )
Pa
ge 4 of 5 Closed Throttle Position
(CTP
) switch, checkin
g and ad
justin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.21

24-76

- Check wiring for continuity or short to Ground
(GND) between throttle position sensor
connector terminal 6 (signal) and test box socket
A4.


Specified value: max. 1 If the specified value is not obtained:

Note:
If it becomes necessary to repair or replace any of the throttle position
sensor electrical terminals, ONLY replace with gold-plated terminals. - Determine open or short circuit in wiring using wiring diagram; repair as
necessary. 6-pin TP sensor connector terminal
ECM connector A terminal
6 A4
4 Intake manifold Ground (GND)
Pa
ge 5 of 5 Closed Throttle Position
(CTP
) switch, checkin
g and ad
justin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.21