coolant AUDI A4 1995 B5 / 1.G AFC Engine Lock Carrier Removing For Service Workshop Manual
Page 7 of 35
15-13
Cylinder head, removing and installing
Engine installed
This removal procedure refers to the left cylinder
head
Removing
- Remove ribbed belt page 13
-9
- Remove toothed belt page 13
-11
- Disconnect exhaust pipe from manifold.
- Disconnect components of EGR system, if applicable.
- Drain engine coolant at drain plug (arrow) using special tool 3247, and
at drain plug in bottom of radiator.
- Remove air hose between Mass Air Flow (MAF) sensor and intake
manifold.
- Disconnect all spark plug connectors.
Pa
ge 7 of 35 Lock carrier, removin
g for service
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.15.4
Page 11 of 35
15-15
- Disconnect harness connectors for Heated
Oxygen Sensors (H02S) and oxygen sensor
heaters at engine compartment bulkhead, and
move to one side.
- Disconnect vacuum line to EGR vacuum
regulator solenoid valve at throttle body.
- Remove EGR valve from intake manifold.
- Remove hydraulic hose bracket and disconnect Ground (GND) wires
(arrow) on intake manifold.
Note:
The intake manifold has two slanting mounting surfaces to the left and - Remove bolts (arrows) and remove intake manifold.
- Seal off openings using clean cloth rags.
- Disconnect coolant line at rear of cylinder head.
Pa
ge 11 of 35 Lock carrier, removin
g for service
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.15.4
Page 22 of 35
15-22
Hydraulic valve lifters, checking
Note:
Irregular valve noise during cranking is
normal.
Do not interchange hydraulic lifters. If
necessary mark them when they are being
removed.
Place lifters that have been removed on a clean
surface with the contact surface (camshaft end)
facing downward.
Hydraulic lifters cannot be repaired or adjusted.
Faulty lifters must be replaced.
- Start and run engine until warm-until radiator
coolant fan has come on at least once.
- Increase engine speed to approx. 2500 RPM for
2 minutes
If the irregular valve noise stops and then re-
occurs again each time vehicle is used in stop
and go traffic:
-
Replace the oil check valves Repair Group
Pa
ge 22 of 35 Lock carrier, removin
g for service
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.15.4